Instrukcja obsługi NAV-TV Tooki NTV-KIT010

NAV-TV Niesklasyfikowane Tooki NTV-KIT010

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla NAV-TV Tooki NTV-KIT010 (7 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/7

What s in the box!

Fig. 1 - Package Contents

1. Tooki module.

2. Plug n Play power harness.! !

3. MOST ﬁber optic cable with connector.

4. Microphone.

5. Fiber optic coupler.

NOTE: Due to differences in

manufacturing, some items may not

appear exactly as pictured.

1 2

3 4

Please inspect the contents of your package to make sure all parts are included, there are no loose wires in

the harness and the ﬁber optic cable isn t kinked, bent or otherwise deformed.(2) (3) !

NOTES:

1) To ensure the most reliable operation, Nav-TV recommends professional installation of our

products.

2) Fiber optic cable is much more fragile and sensitive than normal wire therefore:(3)

a) Make sure your hands are clean when working with the ﬁber.

b) Do not bend or coil the ﬁber excessively.

c) Do not scrape or attempt to strip the orange insulation of the ﬁber.

d) Do not use zip ties or wire ties on ﬁber cable; if you need to keep the excess ﬁber (loosely)

coiled, use tape only.

Tooki Install 2/22/2008

Rev 1

3950 120th NW Ave., Coral Springs, FL 33065

Tel. 561-955-9770 Fax. 561-955-9760

www.nav-tv.com info@nav-tv.com

Tooki Porsche

Bluetooth phone integration for Porsche PCM

Certain features are intended for passenger and off-road use only. User must obey all State and Federal regulations

Installation Instructions

Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.

If you do not agree, please discontinue use immediately and return product to place of purchase.

This product is intended for off-road use and passenger entertainment only.

3) The ﬁber optic coupler is not required for the installation. DO NOT discard it. If the Tooki unit(5)

needs to be removed from the vehicle, then the ﬁber optic bypass must be installed in the place of

the Tooki to maintain the continuity of the MOST ﬁber optic ring.

Close up of Tooki

Fig. 2 - Connections

1. Microphone jack.

2. MOST ﬁber optic connector, with cover.

3. Power connector.

1 2 3

The Nav-TV Tooki module is a very sophisticated piece of equipment. Though the installation is fairly

straightforward, please read the entire manual prior to starting.

BEFORE YOU START: Verify if the vehicle is equipped with the factory phone module. Press

the TEL button on the PCM; if an “Insert SIM card” or “No card” message appears, then the factory

phone module is installed. If that is the case, (a) the factory phone module must be disconnected and

(b) the location of the phone module (under the passenger seat) is an ideal location to install the

Tooki, as it has both the ﬁber optic connection and a power connection.

NOTE: Even if the Tooki will not be mounted in the factory phone location, the factory phone

module still needs to be disconnected and the coupler/bypass will need to be used.. (5)

Therefore, NAV-TV recommends that location for mounting the Tooki.

Tooki Install 2/22/2008

Rev 1

Tooki Porsche

Bluetooth phone integration for Porsche PCM

Certain features are intended for passenger and off-road use only. User must obey all State and Federal regulations

Installation Instructions

Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.

If you do not agree, please discontinue use immediately and return product to place of purchase.

This product is intended for off-road use and passenger entertainment only.

(Replace factory phone module)

To install the Tooki in the location of the original phone module:

1) Remove plastic covers from front and rear ends of seat sliding rails.

2) Remove 4 inverted torx bolts (E12) that hold down the seat at each corner.

3) Remove the SRS and seat harness plug from the front bottom of the passenger seat.

IMPORTANT NOTE: Once the Harnesses have been unplugged from the seat, DO NOT

close, open, lock or unlock the doors, turn on the ignition, or turn on the radio! Doing so may

trigger negative diagnostics, such as the airbag light.

4) Remove the passenger seat.

5) Remove 2 10mm bolts holding metal plate located just under the front right and left sides of the

carpet.

6) Starting from the front (where the bolts were removed), lift the metal plate.

7) Remove 2 10mm bolts that attach the factory phone module to the underside of the metal plate.

8) Remove 32-pin molex, MOST ﬁber optic and antenna connector from factory phone module.

9) The antenna connector is not necessary for this install (Cell phones have their own antennas.) Cut

off Red & Black wires and connector from Plug n Play power harness. Splice Red wire to (any)! !

Red/Green wire (constant 12v) on factory harness and Black to (any) Brown wire (ground) on

factory harness. Plug 8-pin molex (power) into Tooki. Remove gray ﬁber optic cover and plug

MOST ﬁber optic connector into Tooki. Plug microphone into Tooki.

10) Using velcro or double-sided tape, mount Tooki to ﬂoor. Run the microphone wire under the

carpet, along the side of the console and up to a suitable mounting location, such as: On top of

the steering column, in the driver s side A pillar or up by the rear view mirror.!

11) Carefully reassemble in reverse order, making sure not to activate any of the car s systems prior!

to reconnecting the harnesses from step .3

Tooki Install 2/22/2008

Rev 1

Tooki Porsche

Bluetooth phone integration for Porsche PCM

Certain features are intended for passenger and off-road use only. User must obey all State and Federal regulations

Installation Instructions

Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product.

If you do not agree, please discontinue use immediately and return product to place of purchase.

This product is intended for off-road use and passenger entertainment only.

Specyfikacje produktu

Marka:	NAV-TV
Kategoria:	Niesklasyfikowane
Model:	Tooki NTV-KIT010
Kolor produktu:	Black,Metallic
Typ produktu:	Przelewowy ekspres do kawy
Moc:	820 W
Przyrządza espresso:	Nie
Przyrządza kawę:	Tak
Przyrządza cappuccino:	Nie
Typ kontroli:	Przyciski
Wbudowany wyświetlacz:	Nie
Wyjmowany zbiornik wody:	Tak
Długość przewodu:	0.9 m
Wbudowany młynek:	Tak
Typ wkładu kawy:	Coffee beans,Ground coffee
Pojemność pojemnika na ziarna kawy:	100 g
Regulowane ustawienia maszynki do mielenia:	Tak
Pojemność w kubkach:	6 kub.
Położenie urządzenia:	Blat
Typ ekspresu do kawy:	Półautomatyczny
Zbiornik na kawę:	Dzbanek
Wysokość produktu:	400 mm
Szerokość produktu:	165 mm
Głębokość produktu:	275 mm
Waga produktu:	3478 g
Kraj pochodzenia:	Chiny
Pojemnik na mleko:	Nie
Wbudowany spieniacz do mleka:	Nie
Regulacja mocy kawy:	Tak
Kod produktu celnego (TARIC):	851671000
Liczba programów:	6
Blokada kapania zapobiega kapaniu wody na prasowane ubrania:	Tak
Przyciski oświetlane od tyłu:	Tak
Liczba ustawień mocy kawy:	2