Instrukcja obsługi Microchip PIC32MZ1025W104132

Microchip nieskategoryzowany PIC32MZ1025W104132

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Microchip PIC32MZ1025W104132 (22 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/22

PIC32MZ W1

PIC32MZ W1 Software User’s Guide

Introduction

This document describes the software features supported by the PIC32MZ W1 Family using the MPLAB

® Harmony

v3 framework. This framework is integrated with a development environment that works directly with the WFI32E01

module. The software release package enables a rich set of PIC32MZ1025W104 SoC features such as 802.11 b/g/n,

Ethernet, USB, CAN, CAN-FD, SPI, I2C, SQI, UART and JTAG, which are supported by the PIC32MZ W1 Family.

Features

Harmony v3 Peripheral Support

• Three UART modules (one high-speed UART with dedicated pads and two user-configurable UART using

Peripheral Pin Select)

• I2C Master and Slave with Address Masking

• Two SPI Ports

– One dedicated high-speed SPI

– One user configurable SPI using PPS

• One USB OTG 2.0 (full-speed, device mode CDC console only)

• 35 Remappable GPIOs using PPS

• One Fast Ethernet (10/100) Reduced Media Independent Interface (RMII)

• Seven Timers

– 16-bit timers/counters can be concatenated to form a single 32-bit timer

• Eight Channel Hardware DMA (Direct Memory Access) Controller with Automatic Data Size Detection

supporting 32-bit CRC-checked Transfers of up to 64 KB in size

• Node Version Manager (NVM) Read/Write Support

• Watchdog Timer (WDT) for Fail Safe Operations

• 20 External Analog Inputs for Sampling/Conversion

• Four Output Compare Ports

Harmony v3 System Services Support

• Clock Support up to 200 MHz

• Four On-chip Integer PLLs:

– USB (UPLL)

– Ethernet/Wi-Fi® (EWPLL)

– System (SPLL)

– Bluetooth (BTPLL) (unused)

• Power-up Timer (PWRT) and Oscillator Start-up Timers (OST)

• Interrupts Enabled through Peripheral Libraries

• System Console for User Debug Log Messages

• Reset Source Selections:

– Power-on Reset (POR)

– Master Clear Reset (MCLR)

– Software Reset (SWR)

– Brown-out Reset (BOR)

• Four System Ports (A, B, C and K)

• Device Configuration (DEVCON) for all Peripheral-related Bits including Clocks, Programming and Debugging

Harmony v3 Networking Support

• MPLAB Harmony v3 TCP/IP Stack

• WLAN STA and AP Networking Modes

– TLS v1.2 with symmetric crypto acceleration

– DHCP client/server, DNS client/server, ICMPv4, iPerf

• Wireless Network Security Standard (WEP, WPA/WPA2-Personal and WPA3 – FreeRTOS only)

• Protected Management Frames (802.11w)

• Wi-Fi Transmit Power Control

• Configurable Region Selection for Regulatory Compliance

PIC32MZ W1

Table of Contents

Introduction.....................................................................................................................................................1

Features......................................................................................................................................................... 1

1. Quick References....................................................................................................................................4

1.1. Reference Documentation............................................................................................................4

1.2. Hardware Prerequisites................................................................................................................4

1.3. Software Prerequisites................................................................................................................. 4

2. Functional Overview................................................................................................................................5

2.1. Hardware Setup........................................................................................................................... 5

2.1.1. Power Supply.................................................................................................................5

2.1.2. Debugger/Programmer Selection.................................................................................. 7

2.1.3. ICSP Header..................................................................................................................8

2.2. Harmony Setup............................................................................................................................ 9

2.2.1. Configuration Bits ......................................................................................................... 9

2.2.2. Clock Source Selection..................................................................................................9

2.2.3. Pin Configuration using Pin Manager.......................................................................... 12

2.3. Programming MPLAB Projects...................................................................................................15

3. Appendix A: Configuration Bits............................................................................................................. 16

4. Document Revision History...................................................................................................................18

The Microchip Website.................................................................................................................................19

Product Change Notification Service............................................................................................................19

Customer Support........................................................................................................................................ 19

Microchip Devices Code Protection Feature................................................................................................ 19

Legal Notice................................................................................................................................................. 20

Trademarks.................................................................................................................................................. 20

Quality Management System....................................................................................................................... 21

Worldwide Sales and Service.......................................................................................................................22

PIC32MZ W1