Instrukcja obsługi Metra Axxess AX-ADCH02

Metra Niesklasyfikowane Axxess AX-ADCH02

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Metra Axxess AX-ADCH02 (16 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/16
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
AX-ADCH02
I N S TA L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 6/26/18 INSTAX-ADCH02
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS REQUIRED
• Crimping tool and connectors, or solder gun, solder,
and heat shrink • Small flat-blade screwdriver
• Tape • Wire cutter • Zip ties
TABLE OF CONTENTS
Connections to be made
For models
without
an amplifier .......................3
For models
with
an amplifier ............................4
Installing & programming the AX-ADCH02
AX-ADBOX1 ...........................................................5
AX-ADBOX2 ..........................................................6
Adjusting the AX-ADCH02 .....................................7
Chrysler Data Interface 2007-up*
APPLICATIONS
See inside front cover
• Provides accessory power (12-volt 10-amp)
• Maintains the retained accessory power (R.A.P.) feature
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains safety chimes
• Pre-wired ASWC-1 harness (ASWC-1 sold separately)
• Can be used in both amplified and non-amplified models
• Retains balance and fade†
• Retains Blind Spot Detection (if equipped)
• Micro “B” USB updatable
• AX-ADCH02 harness
• 4-pin harness with stripped leads
*Visit AxxessInterfaces.com for up-to-date vehicle specific applications.
INTRODUCTION
The AX-ADCH02 harness is designed for, and must be used with, the
AX-ADBOX1 or AX-ADBOX2 interface (sold separately). Please refer to the
AX-ADBOX1 or AX-ADBOX2 for the 16-pin connector with stripped leads
.
† To retain fade in amplified models, use the AX-ADBOX1
2
APPLICATIONS
CHRYSLER
200 2011-2014
300 2008-2010
Aspen 2008-2009
Sebring 2007-2010
Town & Country 2008-2017
DODGE
Avenger 2008-2014
Caliber 2009-2010
Caravan/
Grand Caravan 2008-up
Challenger 2009-2014
Charger 2008-2010
Dakota 2008-2011
Durango 2008-2013
Journey 2009-2010
Magnum 2008-2009
Nitro 2007-2011
Ram 1500 2009-2011
Ram 2500/3500 2010-2011
JEEP
Commander 2008-2010
Compass 2009-2017.5
Grand Cherokee 2008-2013
Liberty 2008-2012
Patriot 2009-2017
Wrangler 2007-2017
Wrangler
(JK body type) 2018
MITSUBISHI
Raider 2008-2009
RAM
1500/2500/3500 2012
C/V Tradesman 2012-2015
VOLKSWAGEN
Routan 2009-2013
3
REV. 6/26/2018 INSTAX-ADCH02
From the AX-ADCH02 harness to the aftermarket radio:
• Connect the wire to the ground wire.Black
• Connect the Yellow wire to the battery wire.
• If installing an ASWC-1 (sold separately), connect the wire to accessory power.Red
• Connect the wire to the power antenna wire.Blue/White
•
Ensure the (2) 4-pin Molex connectors (with green purple and wires) are connected together
.
• Connect the
4-pin harness with stripped leads
, to the 4-pin Molex connector
(with and wires).gray white
Attention! The following (4) wires are reversed on purpose. These wires will not match “color
code” to the aftermarket radio.
• Connect the wire to the right front positive speaker output.Green
• Connect the wire to the right front negative speaker output.Green/Black
• Connect the wire to the left front positive speaker output.Purple
• Connect the wire to the left front negative speaker output.Purple/Black
12-pin pre-wired ASWC-1 harness:
This harness is to be used along with the optional ASWC-1 (sold separately) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If the ASWC-1
will be used, please refer to the ASWC-1 instructions for radio connections and programming.
Disregard the harness that comes with the ASWC-1.
Continue to Installing & Programming the AX-ADCH02
CONNECTIONS TO BE MADE
Attention! This interface will work with models that are either non-amplified, or amplified.
Please follow the instructions carefully for your model vehicle. Failure to do so will result in
either no sound, or low sound. If you are unsure if your vehicle is factory amplified or not, please
contact your local dealership.
For models
without
an amplifier:
From the 16-pin harness with stripped leads to the aftermarket radio (harness included with interface):
• Connect the wire to the accessory wire.Red
If installing an ASWC-1 (sold separately), connect the wire on the AX-ADCH02 Note: Red
harness as well.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
Attention! The following (4) wires are reversed on purpose. These wires will not match “color
code” to the aftermarket radio.
• Connect the wire to the right rear positive speaker output.Gray
• Connect the Gray/Black wire to the right rear negative speaker output.
• Connect the wire to the left rear positive speaker output.White
• Connect the wire to the left rear negative speaker output.White/Black
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the wire to the VSS/speed sense wire.Blue/Pink
• Connect the wire to the reverse wire.Green/Purple
• Connect the wire to the parking brake wireLight Green
• Tape off and disregard the following (6) wires, they will not be used in this application:
Blue/White Brown Green Green/Black Purple Purple/Black, , , , ,

Specyfikacje produktu

Marka: Metra
Kategoria: Niesklasyfikowane
Model: Axxess AX-ADCH02

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Metra Axxess AX-ADCH02, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Niesklasyfikowane Metra

Metra

Metra 71-017C Instrukcja

9 Października 2024
Metra

Metra AXSP-HK Instrukcja

9 Października 2024
Metra

Metra 109-TO7 Instrukcja

9 Października 2024
Metra

Metra 95-8273B Instrukcja

9 Października 2024
Metra

Metra 95-7822 Instrukcja

9 Października 2024
Metra

Metra 82-8703 Instrukcja

9 Października 2024
Metra

Metra 88-00-9004 Instrukcja

9 Października 2024
Metra

Metra 82-9101 Instrukcja

9 Października 2024
Metra

Metra 95-7021HG Instrukcja

9 Października 2024
Metra

Metra 82-5608 Instrukcja

9 Października 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024
Husqvarna

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024
Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024