Instrukcja obsługi Metra AX-BM90122

Metra Niesklasyfikowane AX-BM90122

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Metra AX-BM90122 (5 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/5

AX-BM90122

I N S TA L L A T I O N I N S T R U C T I O N S

Product Info

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS & INSTALLATION ACCESSORIES REQUIRED

• Crimping tool and connectors, or solder gun,

solder, and heat shrink • Tape • Wire cutter

• Zip ties

TABLE OF CONTENTS

Connections ............................................................2

Installation ............................................................. 3

Programming ......................................................... 3

BMW (with M.O.S.T. 25 ampliﬁer) 2004-2013

• Provides accessory power (12 volt 10 amp)

• Retains R.A.P. (retained accessory power)

• Designed for ampliﬁed models

• Retains audio controls on the steering wheel

• Retains phone buttons (radio dependent)

• Retains factory features: date, time, temperature display

• Micro-B USB updatable

• AX-BM90122 interface

• AX-BM90122 ampliﬁer interface

• ASWC-1 interface

• AX-BM90122 harness

• ASWC-1 harness

• 3.5mm adapter

APPLICATIONS

BMW

1-Series 2004-2013 3-Series 2005-2012

CONNECTIONS

From the aftermarket radio to the AX-BM90122 harness, connect the:

• wire to the ground wire.Black

• Yellow wire to the battery wire.

• Yellow wire (6’ long w/ fuse-holder) directly to the vehicles battery.

• wire to the accessory wire.Red

• Orange wire to the illumination wire (if applicable).

• wire to the power antenna turn-on wire.Blue

• Brown wire to the mute wire.

The following (3) wires are only for multimedia/navigation radios that require these wires.

• wire to the VSS/speed sense wire.Blue/Pink

• Green/Purple wire to the reverse wire.

• Light Green wire to the parking brake wire.

•

Tape off and disregard the following (8) wires, they will not be used in this application:

Gray, Gray/Black Green Green/Black Purple Purple/Black White White/Black, , , , , ,

• and RCA jacks to the full range ampliﬁer output jacks.Red White

ASWC-1 harness:

This harness is only to be used if the vehicle is equipped with steering wheel controls.

• Connect the wire to the chassis ground.Black

• Connect the wire to accessory power.Red

• For the radios listed below: Connect the

3.5mm adapter

to the male 3.5mm SWC jack from the

ASWC-1 harness. Any remaining wires tape off and disregard:

• Connect the steering wheel control wire, normally Eclipse: Brown Brown/White, to the wire

of the connector. Then connect the remaining steering wheel control wire, normally Brown/

White Brown, to the wire of the connector.

• Connect the steering wheel control Key 1 wire to the Metra OE: (Gray) Brown wire.

• Kenwood or select JVC with a steering wheel control wire: Blue/Yellow Connect the wire to

the wire.Brown

• Connect the steering wheel control SWC-2 wire from the radio to the XITE: Brown wire.

• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold

separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.

Note:

The radio must be updated to rev. 2.1.4 or higher software.

• Universal “2 or 3 wire” radio: Connect the steering wheel control wire, referred to as Key-A or

SWC-1, to the Brown wire of the connector. Then connect the remaining steering wheel control

wire, referred to as Key-B or SWC-2, to the wire of the connector. If the radio Brown/White

comes with a third wire for ground, disregard this wire.

Note:

After the interface has been programmed to the vehicle, refer to the manual provided with

the radio for assigning the SWC buttons. Contact the radio manufacturer for more information.

• Connect the 3.5mm jack from the ASWC-1 harness, into the jack on the For all other radios:

aftermarket radio designated for an external steering wheel control interface. Please refer to the

aftermarket radios manual if in doubt as to where the 3.5mm jack goes to.

REV. 11/13/2019 INSTAX-BM90122

With the key in the off position:

• Connect the AX-BM90122 harness AX-BM90122 interface to the .

• Connect the AX-BM90122 harness AX-BM90122 ampliﬁer interface to the .

• Remove the dust cover from ﬁber optic port in the AX-BM90122 ampliﬁer interface.

• Connect the factory ﬁber optic cable into the AX-BM90122 ampliﬁer interface.

• Connect the AX-BM90122 harness to the wiring harness in the vehicle.

• Connect the ASWC-1 harness ASWC-1 interface to the , and then to the AX-BM90122 interface.

• Press and hold the Volume-Up button on the steering wheel.

• Turn the ignition on, the L.E.D. in the ASWC-1 interface will start ﬂashing rapidly, which

means the ASWC-1 is looking for the vehicle and the radio.

Note:

If the L.E.D. did not start ﬂashing rapidly, press the reset button for 3 seconds, while still

holding the Volume-Up button.

• After a few seconds the L.E.D. should stop ﬂashing rapidly, and then go out for

approximately 2 seconds.

• After approximately 2 seconds there will be a series of 7 ﬂashes, some short, and Green

some long. The long ﬂashes represent the wires that are connected to the ASWC-1. The 3rd,

4th, 5th, and 6th ﬂashes should be longer.

Tip:

Knowing this will help to troubleshoot, if need be.

• The L.E.D. will pause for another 2 seconds, and then ﬂash up to 18 times depending on Red

which radio is connected to the ASWC-1. Refer to the L.E.D. feedback section for information.

• This is the end of the auto detection stage. Release from holding the Volume-Up button.

If the ASWC-1 detected the vehicle and the radio successfully, the L.E.D. will light up solid.

•

Test the steering wheel controls for proper operation. Refer to the ASWC-1 instructions online at

axxessinterfaces.com for customizing the buttons, if so desired

INSTALLATION

PROGRAMMING

(CONT.)

L.E.D. feedback

The (18) L.E.D. ﬂashes represent which brand radio the ASWC-1 is connected to. Each Red

ﬂash represents a different radio manufacturer. For example, if you are installing a JVC radio,

the ASWC-1 will ﬂash (5) times, and then stop. Following is a legend that dictates which Red

radio manufacturer corresponds to which ﬂash.

L.E.D. feedback legend

1 ﬂash - Eclipse (Type 1) †

2 ﬂashes - Kenwood ‡

3 ﬂashes - Clarion (Type 1) †

4 ﬂashes - Sony / Dual

5 ﬂashes - JVC

ﬂashes -

Pioneer / Jensen

7 ﬂashes - Alpine *

8 ﬂashes - Visteon

9 ﬂashes - Valor

10 ﬂashes - Clarion (Type 2) †

11 ﬂashes - Metra OE

12 ﬂashes - Eclipse (Type 2) †

13 ﬂashes - LG

14 ﬂashes - Parrot **

15 ﬂashes - XITE

16 ﬂashes - Philips

17 ﬂashes - TBD

18 ﬂashes - JBL

* Note:

If the ASWC-1 ﬂashes (7) times, and you do not have an Alpine radio connected to Red

it, that means the ASWC-1 does not detect a radio connected it. Verify that the 3.5mm jack is

connected to the correct steering wheel jack/wire in the radio.

** Note:

The AX-SWC-PARROT is required (sold separately). Also, the Parrot radio must be

updated to rev. 2.1.4 or higher through www.parrot.com.

† Note:

If you have a Clarion radio and the steering wheel controls do not work, change the radio type to

the other Clarion radio type; same for Eclipse. Refer to the “Programming Information” document online

‡ Note:

If you have a Kenwood radio and the L.E.D. feedback comes back as showing as a JVC radio,

change the radio type to a Kenwood. Refer to the “Programming Information” document online

Specyfikacje produktu

Marka:	Metra
Kategoria:	Niesklasyfikowane
Model:	AX-BM90122

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Metra AX-BM90122, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Niesklasyfikowane Metra

Metra 71-017C Instrukcja

9 Października 2024

Metra AXSP-HK Instrukcja

9 Października 2024

Metra 109-TO7 Instrukcja

9 Października 2024

Metra 95-8273B Instrukcja

9 Października 2024

Metra 95-7822 Instrukcja

9 Października 2024

Metra 82-8703 Instrukcja

9 Października 2024

Metra 88-00-9004 Instrukcja

9 Października 2024

Metra 82-9101 Instrukcja

9 Października 2024

Metra 95-7021HG Instrukcja

9 Października 2024

Metra 82-5608 Instrukcja

9 Października 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024

Stihl HT 70 Instrukcja

15 Października 2024

Ernesto H14270 Instrukcja

15 Października 2024

Uniden BT MIC KIT Instrukcja

15 Października 2024

Vaude Omnis Bike 26 Instrukcja

15 Października 2024

ART ProChannel II Instrukcja

15 Października 2024

Aukey DR02J Instrukcja

15 Października 2024

Master Lock 653EURD Instrukcja

15 Października 2024

Roland FR-18 Diatonic Instrukcja

15 Października 2024