Instrukcja obsługi M-Audio Pulsar

M-Audio Niesklasyfikowane Pulsar

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla M-Audio Pulsar (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/4

AUDIOPHILE 192 PCI

Pulsar

small-capsule

condenser microphone

care & usage

English

User Guide

English

Introduction

Thank you for purchasing the Pulsar microphone from M-Audio. Please take a few moments to familiarize

yourself with your new microphone by reading this guide.

Features

< Top-address cardioid instrument microphone

< 3/4” diameter 6-micron evaporated-gold diaphragm

< Solid brass body and capsule

< 20Hz-20kHz frequency response

< Class A FET electronics

< 3-pin XLR (phantom-powered)

< Includes soft case, pop ﬁlter, and hard mount

Important: Please ﬁll out and mail your warranty card for the Pulsar so that we may provide you with support

for your microphone.

Unpacking

The container for your microphone was carefully constructed for protection during shipping. Please save this

packaging for storage or traveling with your Pulsar microphone. If your box does not include the following items,

please contact your dealer immediately:

< < (1) M-Audio Pulsar microphone (1) hard mount

< < (1) soft case (1) pop ﬁlter

Connections and Phantom Power

The M-Audio Pulsar microphone outputs a balanced low-impedance signal. It is designed to be connected to the

mic-level inputs of a mixer channel or a dedicated high-quality preamp such as M-Audio’s DMP3 or TAMPA.

As with all condenser microphones, your Pulsar requires power in order to operate. You will need to connect

the Pulsar via XLR connection to a preamp or mixer channel input that supplies +48V phantom power. (Phantom

power shares the same XLR cable as the audio from the microphone). In order to avoid pops and surges that can

damage components like speakers and microphones, always perform the following steps (in the order listed)

when connecting the mic and/or cable:

1. Turn the volume/gain on your preamp and/or mixer all the way down.

2. Make sure that phantom power is turned off.

3. Connect the microphone via a high-quality XLR cable.

4. Turn on phantom power.

5. Slowly turn up the gain on your preamp and/or mixer.

Before disconnecting the mic and/or cable, repeat steps 1 and 2 (in the order listed).

Applications

The Pulsar’s clean electronics combine with an all-brass capsule to produce a smooth tone that makes it a great

instrument-recording microphone. Use it on acoustic instruments, wind instruments, as an overhead drum mic

or room ambience recording mic. When you’re ready to add more pro-quality microphones to your mic locker,

be sure to check out the increased vocal punch of the M-Audio Luna and the multi-pattern recording features of

the M-Audio Solaris microphone.

Cardioid Pattern

Cardioid is the most commonly used polar pattern engineered into microphones.

This design causes the back of the microphone to reject incoming sound, allowing the engineer to isolate the

signal source from other performance elements or background noise by just pointing the mic at the sound

source. The logo side of the microphone is the “live” side.

Pulsar Small-Capsule Condenser Microphone Care and Usage •

English

Care of Your Microphone

Here are a few tips for care of your Pulsar microphone:

< Never subject the Pulsar to physical shock.

< Always use a stand—and always use the included hard mount when securing to a stand.

< Always wipe the Pulsar exterior down with a soft dry cloth and return it to its case after each use to

prevent damage from dust.

< In the event that your Pulsar needs more extensive cleaning, lightly dampen a soft cloth with water or

mild household soap and clean the metal exterior, wiping it completely dry when ﬁnished. Never spray

a cleaning agent on the microphone itself, as the moisture can damage the unit.

< Avoid subjecting the Pulsar to any kind of moisture. In vocal applications, use a windscreen to protect the

diaphragm from breath condensation and saliva build-up.

< Never disassemble the Pulsar microphone. There are no user-serviceable parts inside.

< Always use top-quality cables in order to avoid electrical problems that may damage the microphones

electronics.

< Avoid temperature extremes above 95°F and below 50°F. In order to avoid harmful moisture condensation

on the diaphragm, allow the microphone to acclimate to room temperature before connection when

moving the microphone between outdoor and indoor environments.

Speciﬁcations

< Type: small diaphragm condenser

< Polar Pattern: cardioid

< Frequency Response: 20Hz – 20kHz

< Sensitivity: 13.8 mV/Pa (-37dBV re 1V/Pa)

< Max. SPL for 0.5% THD: 134dB

< Equivalent Noise Level: 17dB A-weighted

< Output Impedance: 200 Ω

< Recommended Load Impedance: > 1,000 Ω

< Preamp Topology: Class A FET, transformerless

< Power Requirement: 48V phantom power

< Connector: 3-pin male XLR

< Dimensions: 22mm (0.87”) dia,, 132 mm (5.20”) long

< Weight: 115 g (4.0 oz)

Warranty Terms and Registration

Warranty Terms

M-Audio warrants products to be free from defects in materials and workmanship, under normal use and

provided that the product is owned by the original, registered user. Visit www.m-audio.com/warranty for terms

and limitations applying to your speciﬁc product.

Warranty Registration

Thank you for registering your new M-Audio product. Doing so immediately both entitles you to full warranty

coverage and helps M-Audio develop and manufacture the ﬁnest quality products available. Register online at

www.m-audio.com/register to receive FREE product updates and for the chance to win FREE M-Audio gear.

• Pulsar Small-Capsule Condenser Microphone Care and Usage

Specyfikacje produktu

Marka:	M-Audio
Kategoria:	Niesklasyfikowane
Model:	Pulsar

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z M-Audio Pulsar, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Niesklasyfikowane M-Audio

M-Audio SBX10 Instrukcja

17 Września 2024

M-Audio MidAir Instrukcja

16 Września 2024

M-Audio Delta 44 Instrukcja

16 Września 2024

M-Audio ProKeys 88sx Instrukcja

16 Września 2024

M-Audio Studiophile DX4 Instrukcja

16 Września 2024

M-Audio Solaris Instrukcja

16 Września 2024

M-Audio Firewire 1814 Instrukcja

15 Września 2024

M-Audio Revolution 7.1 Instrukcja

15 Września 2024

M-Audio X-Session UC-17 Instrukcja

15 Września 2024

M-Audio SAM Instrukcja

15 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024

Stihl HT 70 Instrukcja

15 Października 2024

Ernesto H14270 Instrukcja

15 Października 2024

Uniden BT MIC KIT Instrukcja

15 Października 2024

Vaude Omnis Bike 26 Instrukcja

15 Października 2024

ART ProChannel II Instrukcja

15 Października 2024

Aukey DR02J Instrukcja

15 Października 2024

Master Lock 653EURD Instrukcja

15 Października 2024

Roland FR-18 Diatonic Instrukcja

15 Października 2024