Instrukcja obsługi Lenco MCI-210

Lenco głośnik MCI-210

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Lenco MCI-210 (40 stron) w kategorii głośnik. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/40
M
M
M
Mc
c
c
ci
i
i
i-
-
-
-2
2
2
21
1
1
10
0
0
0Mci-210
MICRO HI-FI SYSTEM
WITH iPod/iPhone DOCKING STATION,
CD/MP3 PLAYER, PLL FM RADIO,
USB AND CARD READER
INSTRUCTI ON MANUAL
iPod/iPhone shown not included
For information and support, www.lenco.eu
SAFETY PRECAUTIONS
Important Notes
No naked flame sources such as lighted candles should be placed on the unit.
Attention should be drawn to the environmental aspects of battery disposal.
D
CAUTION:
DANGEROUS VOLTAGE
ATTENTION
Note:
To achieve the utmost in enjoyment and performance, and in order to become familiar with its features, please read this manual
carefully before attempting to operate the unit.
This safety and operating instruction should be retained for future reference.
Avoid installing the unit in locations described below:
* - Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters, on top of other stereo
equipment that radiate too much heat.
* - Places blocking ventilation or dusty places.
* - Places subject to constant vibration, humid or moist places.
Make sure not to obstruct the ventilation openings, a minimum of 10cm should be kept around the apparatus for ventilation.
The ventilation should not be impeded by covering the ventilation openings with items such as newspaper, table-cloths,
curtains, etc. Use apparatus in moderate climates only.
Operate tuning controls and switches as instructed in the manual.
Before turning on the power for the first time, make sure the power cord is properly installed.
Store your CD in a cool area to avoid damage from heat.
o not attempt to remove any screws, or open the casing of the unit; there are no user serviceable parts inside, refer all
servicing to qualified service personnel.
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK), NO USER
SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Conductor dangerous voltage, that may be of sufficient magnitude to constitute a risk of electric shock to persons
is present within this product's enclosure.
The owner's manual contains important operating and maintenance instructions, for your safety, it is necessary to
refer to the manual.
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TODRIPPING OR SPLASHING.
WARNING :
This unit will become warm when used for a long period of time. This is normal and does not indicate a problem with the
unit. This unit includes micro-processors which may malfunction as a result of external electrical interference/noise or
electrostatic discharge . If the unit is not working properly, disconnect the power source and then reconnect it.
The apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed
on apparatus.
The mains plug is used as the disconnect device and it must remain readily operable. To completely disconnect the power
input, the mains plug of the apparatus must be disconnected from the mains.
The normal function of the product may be disturbed by Strong Electro Magnetic Interference. If so, simply reset the product
to resume normal operation by following the instruction manual. In case the function could not resume, please use the
product in other location.
UK-1
FEATURES AN D CONTRO LS
25
26
19
20 21 22
23
24
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
17
16
18
REMOT E CO NTROL
1. STANDBY/ON BUTTON
2. iPod/CD BUTTON
3. BACKLIGHT BUTTON
4. PLAY/PAUSE BUTTO N
5. BUTTONI◀◀
6. STOP/MENU BUTTON
7. RANDOM BUTTON
8. PROGRAM BUTTON
9. PS/FOL/MENU BUTTON▼
10. X- BASS BUTTON
11. VOLUME + BUTTON
12. EQ BUTTON
13. VOLUME - BUTTON
TO UC H SENSIN G CONTROL
The unit is utilizing a hu man capacitive sensing technology, the front pane l controls are designed to be touch
sensing key pads; you can operate the unit by the touch of your finger tips. The blue light dots on the CD front
panel will be flashing up every time when you perform your touch operation.
CLOCK S ETTI NG
When t he unit is powered up for the first time, it will be in standby mode, the display will show the clock and flash.
To perform th e clock setting, ensure the unit is in standby mod e.
1. Setting the clock display format - Keep touching the touch pa d on the front panel until the CLOC K/DI SPLAY
display shows “12 HR” or “24 HR” , t hen touch on the ◄◄ or touch pad to select the “12 HR” (12- I ► ►I
Hour) or “24 HR” (24-Hour ) clock display format, wh en yo ur desired fo rmat appears in the display, touch on
the to confirm. (F. 1)CL OCK/ DISP LAY
2. After the clock display format is set, the display will show the clock with the hour digits flash , touch on the
I ►►I CL OCK/ DISPLAY ◄◄ or to set to the correct hour, then touch on the to confirm, first set the hour
and then the minute, when the display shows the correct time, to uch on the again to CL OCK/ DISP LAY
confirm, the clock setting is now completed. (F. 2)(F. 3)
3. The clock is displayed during unit standb y. To see the clock during unit operation, repeatedly touch on the
CLOC K/DI SPLAY until the display shows the clock and it will be displayed for 5 seconds.
LI STEN IN G TO YO U R RA DI O
When t he unit is first switched on from standby, it will automatically enter into the FM radio mode. You should fully
extend the FM lead wire antenna located at the back o f the unit and adjust its position and direction until you find
the best reception.
To select radio mode during other operation modes, to uch on the touch pad on the fr ont panel, the TUNE R
display will show the FM frequency. (F. 4)
PUTTING THE BATTERY INTO TH E REM OT E CONTROL UNIT
UK-2
**BATTERY INCLUDED**
14. OPEN/CLOSE BUTTON
15. AUX/USB/SD BUTTON
16. TUNER BUTTO N
17. CLOCK/DISPLAY BUTTON
18. BUTTON▶▶I
19. SELECT/REPEAT BUTTON
20. INTRO BUTTON
21. PS/FOL/MENU BUTTON▲
22. SLEEP BUTTON
23. TIMER BUT TON
24. SURROUND BUTTON
25. MUTE BUT TON
FEATURES AND CONTROLS
1. CD DOOR
2. CD DOOR OPEN/CLOSE(touch pad)
3. SELECT/REPEAT(touch pad)
4. VOLUME +(touch pad)
5. VOLUME -(touch pad)
6. HEADPHONE JACK
7. IR SENSOR
8. LCD DISPL AY
9. SKIP /TUNE (tou ch pad)▼
10. SKIP /TUNE (touch pad)▶▶I▲
I◄◄
11. PLAY/PAUSE(touch pad)
12. STOP/MENU(touch pad)
13. CL OCK/DISPLAY(to uch pad)
14. iPod/CD(touch pad)
15. TUNER(touch pad)
16. AUX/USB/SD(touch pad)
17. STANDBY/ON(touch pad)
18. iPod DECK
19. FM WIRE ANT ENNA
20. AUX IN(RIGHT) JACK
F.2 F.3
F.1
1
2
3
4
5
6
7
8
9
12
14
13
15
16
17
18
19
20
21
22
23
24
25
10
11
21. AUX IN(LEFT) JACK
22 SPEAKER TERMINALS
23. BATTERY DOOR
24. AC CORD
25. USB DEVICE IN PORT
26. SD CARD IN SLOT
BATTERY COMPARTMNT
OPEN/CLOSE
CHANGE OF BATTERY
1. Press the battery co mpartment gently according to the direction
indicated in the illustration.
2. Slide to ope n the battery compartment.
3. Insert the supplied CR2032 battery into th e compartment according to
the polarity ma rkings ("+" and "-") inside the compartment and on the
battery. Replace the battery compartment until it clicks.
NOTE :Remove the battery from the remote control if not in use for long
period of time. Replace with ne w battery when the battery becom e weak,
otherwise the remote control will not function properly.

Specyfikacje produktu

Marka: Lenco
Kategoria: głośnik
Model: MCI-210

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Lenco MCI-210, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje głośnik Lenco

Lenco

Lenco PA-101 Instrukcja

4 Stycznia 2025
Lenco

Lenco BT-4650 Instrukcja

5 Października 2024
Lenco

Lenco PA-46 Instrukcja

4 Października 2024
Lenco

Lenco PA-360 Instrukcja

1 Października 2024
Lenco

Lenco BT-272 Instrukcja

30 Września 2024
Lenco

Lenco BT-180 Instrukcja

30 Września 2024
Lenco

Lenco BT-210 Instrukcja

28 Września 2024
Lenco

Lenco BTP-400 v2 Instrukcja

28 Września 2024
Lenco

Lenco City Romance BTSW-1 Instrukcja

27 Września 2024
Lenco

Lenco PA-100 Instrukcja

24 Września 2024

Instrukcje głośnik

Najnowsze instrukcje dla głośnik

Bowers & Wilkins

Bowers & Wilkins LCR3 Instrukcja

15 Stycznia 2025
Hifonics

Hifonics Vulcan VX6.2E Instrukcja

15 Stycznia 2025
Pyle

Pyle PLRGSW64BK Instrukcja

15 Stycznia 2025
ION

ION Insta Sound Instrukcja

15 Stycznia 2025
Pure Acoustics

Pure Acoustics QBT-340 Instrukcja

15 Stycznia 2025
Yamaha

Yamaha WX-010 Instrukcja

15 Stycznia 2025
Polk

Polk REACT SOUND BAR 1 Instrukcja

15 Stycznia 2025
Sennheiser

Sennheiser AMBEO Soundbar Plus SB02M Instrukcja

15 Stycznia 2025
Klipsch

Klipsch Reference RB-25 Instrukcja

15 Stycznia 2025
Klipsch

Klipsch Reference RB-35 Instrukcja

15 Stycznia 2025