Instrukcja obsługi Konica Minolta Maxxum 800Si

Konica Minolta Niesklasyfikowane Maxxum 800Si

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Konica Minolta Maxxum 800Si (69 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/69
INSTRUCTION MANUAL
E
BASIC
OPERATION
FOCUS
BASICS
FLASH
BASICS
SUBJECT
PROGRAM
MODES
EXPOSURE
BASICS
ADVANCED
AUTOFOCUS
ADVANCED
EXPOSURE
ADVANCED
FLASH
ADDITIONAL
FEATURES
APPENDIX
Thank you for purchasing the Minolta Dynax/Maxxum 800si. The 800si
features Minolta's highly acclaimed 14-Segment Honeycomb Pattern
Metering, a built-in high-power zoom ash, and built-in Intelligent Card
functions. The built-in ash covers focal lengths from 24 to 80mm and has
a guide number of up to 20. A screw-type PC terminal and Rear-ash
sync function give you maximum control over ash exposures.
The High-Speed Autofocus, Predictive Focus Control functions, and top
shutter speed of 1/8000 second mean the 800si responds quickly,
accurately, and exibly to virtually any motion, composition, or lighting
condition in the moment of a shutter release.
The 800si also oers full control over all camera systems. In addition, you
can select any of the four local focus areas, take spot meter readings,
lock exposure and focus separately or together, and use Memory to save
and later recall three groups of your most often used camera settings.
This manual has been designed to help you understand the operation of
your camera and its functions. Please familiarize yourself with the names
of the controls and their locations on the camera, then read this manual
thoroughly.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Changes or modications not
approved by the party responsible for compliance could void the user's authority to operate the
equipment. This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment
Regulations.
This mark on your camera certies that this camera meets the requirements of the EU
(European Union) concerning interference causing equipment regulations. CE stands for
Conformité Européenne (European Conformity).
FOR PROPER AND SA
Read and understand all warnin
TABLE OF CONTENTS
2
BASIC OPERATION
FOCUS BASICS
FLASH BASICS
SUBJECT PROGRAM
MODES
EXPOSURE BASICS
ADVANCED
AUTOFOCUS
ADVANCED EXPOSURE
ADVANCED FLASH
ADDITIONAL
FEATURES
APPENDIX
For Proper and Safe Use..................................1
Standard Accessories .......................................11
Installing the Batteries ......................................12
Battery Condition Indicators..............................13
Attaching and Removing the Lens....................14
Focus Signals ...................................................26
Focus Lock .......................................................27
Using the Built-in Flash.....................................34
Flash Signals ....................................................35
Subject Program Selection ...............................41
Portrait Mode ....................................................42
Exposure Modes...............................................49
P: Programmed Autoexposure Mode ...............51
Autofocus Modes ..............................................64
Changing the Autofocus Mode .........................66
Metering............................................................71
Selecting a Metering Method............................73
Exposure Compensation ..................................74
High-speed Flash Sync.....................................87
Slow-shutter Sync.............................................88
Rear-ash Sync ................................................89
Memory.............................................................99
Customized Settings.........................................102
Data Memory ....................................................106
Program-reset button........................................120
Accessory Information ......................................121

Specyfikacje produktu

Marka: Konica Minolta
Kategoria: Niesklasyfikowane
Model: Maxxum 800Si

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Konica Minolta Maxxum 800Si, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Niesklasyfikowane Konica Minolta

Konica Minolta

Konica Minolta Dynax 700Si Instrukcja

23 Września 2024
Konica Minolta

Konica Minolta Dynax 9Xi Instrukcja

23 Września 2024
Konica Minolta

Konica Minolta Dynax 800Si Instrukcja

23 Września 2024
Konica Minolta

Konica Minolta Dynax 500Si Super Instrukcja

23 Września 2024
Konica Minolta

Konica Minolta Dynax 500Si Instrukcja

23 Września 2024
Konica Minolta

Konica Minolta Dynax 303Si Instrukcja

23 Września 2024
Konica Minolta

Konica Minolta Dynax 60 Instrukcja

23 Września 2024
Konica Minolta

Konica Minolta AF-Tele Super Instrukcja

23 Września 2024
Konica Minolta

Konica Minolta Auto S2 Instrukcja

23 Września 2024
Konica Minolta

Konica Minolta Dynax 300Si Instrukcja

23 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024
Husqvarna

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024
Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024