Instrukcja obsługi Keurig K-Duo Essentials

Keurig ekspres do kawy K-Duo Essentials

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Keurig K-Duo Essentials (8 stron) w kategorii ekspres do kawy. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/8
Get the most from your
new Keurig® brewer
Use & Care Guide
Remove packing tape from brewer
and plug into an outlet.
Single Cup - Place a large mug
(12oz minimum) on the drip tray.
Carafe - Rinse the carafe and
place it on the heating plate.
Remove the water reservoir lid, then lift
the reservoir straight up to remove it.
If you have a Keurig
®
Water Filter, install it
now. Refer to your Water Filter Starter Kit
for instructions.
Fill the reservoir with fresh water to the
MAX fill line.
Replace water reservoir, making sure the
lock tabs engage with the brewer.
Press the OZ button to power on the
single cup side. Do not insert a K-Cup®
pod. 8 Press the button to start
the cleansing brew – the button OZ
will pulse green while the brewer is
heating. Once heated, the button OZ
will turn solid green and the cleansing
brew will begin. Pour the hot water
into the sink.
NOTE: Between brew cycles, the brewer may take about a
minute to reheat
1
3
5
2
Before You Brew
The button will illuminate red to CUPS
indicate the heating plate is on when
the cleansing brew is complete. Press
and hold the button to turn the CUPS
heating plate off, and pour the hot
water into the sink.
The one-time single cup setup process
is now complete and you are ready to
brew!
Press the 8 button to start a
cleansing brew – the button will
illuminate blue.
Add Water
8
Add Water
Add Water
Add Water
8
Add terWa
12
10
8
Add terWa
12
10
8
Plug & Place Rinse & Fill
Cleansing Brew - Single Cup
Fill the reservoir to the MAX fill line, and
then press the CUPS button to power on
the carafe side. Do not fill filter basket
with coffee grounds. CUPS The button
will illuminate green and the 3 brew size
buttons will blink blue.
4Power On - Carafe
Cleansing Brew - Carafe
HEATING
PLATE
ON
Place a mug on the drip tray.
If using a travel mug, remove
the drip tray and place the mug
on the drip tray base. Lift the
handle and place a K-Cup® pod
in the K-Cup® pod holder. Lower
the handle completely to close
the lid.
High Altitude Brewing: While
holding the brewer handle
up, push down slowly on the
K-Cup® pod in the pod holder
until the bottom of the K-Cup® pod is
punctured by the exit needle.
Press the OZ button, then select your
brew size. The OZ button and brew
size button will remain illuminated
while brewing – about 1 minute.
Brewing is complete when the brew
size button is no longer illuminated.
Lift the handle and dispose of the
used K-Cup® pod. The brewer will be
ready to brew another cup in about a
minute.
We recommend using a Keurig® Rinse
Pod or running a cleansing brew
immediately after brewing hot cocoa
or other sweetened pods to keep the
needles clean.
NOTE: After 60 seconds, the brew buttons will be
disabled. To reactivate, press .OZ or CUPS
1
1
2
2
Brew Your First Single Cup
Brew Your First Carafe
Press the CUPS button and select
your brew size. Once the brew is
complete, the heating plate will
automatically turn on and remain
on for 2 hours - the button CUPS
will illuminate red. To turn off the
heating plate, press and hold the
CUPS button until the light is no
longer illuminated.
If you accidentally shut the heating
plate off, press and hold the CUPS
button until the red light illuminates
to turn it back on.
Fill the water reservoir to
the MAX fill line.
Remove the filter basket
drawer by pulling outward
and insert a 12 cup paper
filter into the filter basket. Add the
desired amount of ground coffee
(1 tablespoon of ground coffee per
cup is recommended). Reinsert the
filter basket drawer completely
and make sure the carafe is on the
heating plate.
NOTE: The maximum capacity for regular ground
coffee is 15 tablespoons and 12 tablespoons for decaf.
Exceeding this amount may cause overflow.
Add Water
Place Mug & Pod Brew & Enjoy!
Place Carafe & Fill Basket Brew & Enjoy!
Smart Start heats then brews in one simple process. No
need to wait for the brewer to heat before selecting brew
size. Power on your brewer, add coffee, then select your brew
size. The brewer will heat, then automatically begin brewing.
Single Cup Auto Off automatically turns your brewer off 60
seconds after the last brew for energy savings.
Carafe Auto Off automatically turns your heating plate off
2 hours after the last brew for energy savings.
Pause & Pour a cup mid-brew while brewing a carafe using
the 20 second automatic pause feature.
NOTE: Removing the carafe for more than 20 seconds may cause
the filter basket to overflow.
Add Water
Add te rWa
12
10
8
Add terWa
12
10
8
Brewer Features


Specyfikacje produktu

Marka: Keurig
Kategoria: ekspres do kawy
Model: K-Duo Essentials

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Keurig K-Duo Essentials, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje ekspres do kawy Keurig

Instrukcje ekspres do kawy

Najnowsze instrukcje dla ekspres do kawy

Russell Hobbs

Russell Hobbs Retro Instrukcja

15 Października 2024
Bialetti

Bialetti Kitty Instrukcja

14 Października 2024
Exquisit

Exquisit KA 6502 sw Instrukcja

14 Października 2024
Royal Catering

Royal Catering RCKM-20 Instrukcja

14 Października 2024
Royal Catering

Royal Catering RC-CU9 Instrukcja

14 Października 2024
Rowenta

Rowenta CT500 Silver Art Instrukcja

12 Października 2024
Krups

Krups Vertuo Next Instrukcja

11 Października 2024