Instrukcja obsługi JVC HR-J287MS
JVC
magnetowid
HR-J287MS
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla JVC HR-J287MS (17 stron) w kategorii magnetowid. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/17
Page 1 September 3, 2001 9:09 am
VIDEO CASSETTE RECORDER
HR-J281MS
INSTRUCTIONS
LPT0590-001A Printed in Malaysia
COPYRIGHT © 2001 VICTOR COMPANY OF JAPAN, LTD. 0501 MNVfPJfPJ
Safety Precautions
The rating plate and the safety caution are on the rear of the unit.
WARNING:DANGEROUS VOLTAGE INSIDE
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS UNIT TO RAIN OR MOISTURE.
●Cassettes marked “VHS” (or “S-VHS”) can be used with this
video cassette recorder. However, S-VHS recording is not
possible with this model.
●HQ VHS is compatible with existing VHS equipment.
CAUTION
䡲When you are not using the recorder for a long period of
time, it is recommended that you disconnect the power cord
from the mains outlet.
䡲Dangerous voltage inside. Refer internal servicing to qualified
service personnel. To prevent electric shock or fire hazard,
remove the power cord from the mains outlet prior to
connecting or disconnecting any signal lead or aerial.
ATTENTION
1. This recorder can also receive SECAM colour television
signals for recording and playback.
2. Recordings made of SECAM television signals produce
monochrome pictures if played back on another video
recorder of SECAM standard, or do not produce normal
colour pictures if played back on another video recorder of
PAL standard.
3 SECAM prerecorded cassettes or recordings made with a
SECAM video recorder produce monochrome pictures when
played back with this recorder.
POWER SYSTEM:
This set operates on voltage of AC110 –240 Vd (Rating), AC90 –
260 Vd (Operating), 50/60 Hz with automatic switching.
Caution on Replaceable lithium battery
The battery used in this device may present a fire or chemical
burn hazard if mistreated. Do not recharge, disassemble, heat
above 100°C or incinerate.
Replace battery with Panasonic (Matsushita Electric), Sanyo,
Sony or Maxell CR2025. Danger of explosion or Risk of fire if
the battery is incorrectly replaced.
䡲Dispose of used battery promptly.
䡲Keep away from children.
䡲Do not disassemble and do not dispose of in fire.
IMPORTANT
䡲Please read the various precautions on this page before
installing or operating the recorder.
䡲It should be noted that it may be unlawful to re-record pre-
recorded tapes, records, or discs without the consent of the
owner of copyright in the sound or video recording,
broadcast or cable programme and in any literary, dramatic,
musical, or artistic work embodied therein.
The STANDBY/ON 1 button does not completely shut off
mains power from the unit, but switches operating current on
and off. “`“ shows electrical power standby and “ ! “ shows
ON.
Video tapes recorded with this video recorder in the LP (Long
Play) or EP (Extended Play) mode cannot be played back on a
single-speed video recorder.
HR-J287MS
Page 2 September 3, 2001 9:09 am
When the equipment is installed in a cabinet or a shelf, make sure
that it has sufficient space on all sides to allow for ventilation
(10 cm or more on both sides, on top and at the rear).
When discarding batteries, environmental problems must be
considered and the local rules or laws governing the disposal of
these batteries must be followed strictly.
Failure to heed the following precautions may result in damage
to the recorder, remote control or video cassette.
1. DO NOT place the recorder ...
... in an environment prone to extreme temperatures or
humidity.
... in direct sunlight.
... in a dusty environment.
... in an environment where strong magnetic fields are
generated.
... on a surface that is unstable or subject to vibration.
2. DO NOT block the recorder’s ventilation openings or holes.
(If the ventilation openings or holes are blocked by a
newspaper or cloth, etc., the heat may not be able to get out.)
3. DO NOT place heavy objects on the recorder or remote
control.
4. DO NOT place anything which might spill on top of the
recorder or remote control.
(If water or liquid is allowed to enter this equipment, fire or
electric shock may be caused.)
5. DO NOT expose the apparatus to dripping or splashing.
6. DO NOT use this equipment in a bathroom or places with
water. Also DO NOT place any containers filled with water or
liquids (such as cosmetics or medicines, flower vases, potted
plants, cups, etc.) on top of this unit.
7. DO NOT place any naked flame sources, such as lighted
candles, on the apparatus.
8. AVOID violent shocks to the recorder during transport.
MOISTURE CONDENSATION
Moisture in the air will condense on the recorder when you move
it from a cold place to a warm place, or under extremely humid
conditions—just as water droplets form on the surface of a glass
filled with cold liquid. Moisture condensation on the head drum
will cause damage to the tape. In conditions where condensation
may occur, keep the recorder’s power turned on for a few hours to
let the moisture dry.
How to use the remote control
The remote control can operate most of your recorder’s functions,
as well as basic functions of TV, cable box, satellite receiver, and
DVD sets of JVC and other brands.
●Point the remote control toward the sensor window on the
target component.
●The maximum operating distance of the remote control is about
8m.
NOTES:
●When inserting the batteries, be sure to insert in the correct
directions as indicated under the battery cover.
●If the remote control does not work properly, remove its
batteries, wait for a few seconds, replace the batteries and then
try again.
Video heads cleaning
Use a dry cleaning cassette — TCL-2UX — when:
●Rough, poor picture appears while a tape is played back.
●The picture is unclear or no picture appears.
●“USE CLEANING CASSETTE” appears on the screen (only with
“O.S.D.” set to “ON”).
Buttons, Connectors
and Indicators
Front Panel
Rear Panel
Cassette
loading slot
Display panel
Play indicator
Record indicator
Timer mode indicator
Channel and auxiliary input/Clock time
Infrared beam
receiving
window
Main power cord
Lithium battery
compartment
Page 3 September 3, 2001 9:09 am
Remote control
* Not function with this recorder.
On-screen display
If you press OK on the remote control when “O.S.D.” is set to
“ON”, you can see the current recorder status on the TV screen.
After about 5 seconds, indications other than the time counter
disappear. To clear the time counter, press OK again.
The indications are not recorded even if the recorder is in the
recording mode.
AChannel and auxiliary input
BClock time
CDay
DTime counter
ETape position
FTape direction
GColour system indicator
HTape spee d
IRecorder operation mode
JCassette mark
Basic Connections
ACheck contents
Make sure the package contains all of the accessories listed in
“Specifications”.
BSituate recorder
Place the recorder on a stable, horizontal surface.
CConnect recorder to TV
RF Connection
ADisconnect the TV aerial cable from the TV.
BConnect the TV aerial cable to the ANT. IN terminal on the
rear of the recorder.
CConnect the supplied RF cable between the RF OUT terminal
on the rear of the recorder and the TV’s aerial input terminal.
AV Connection
(improves picture quality during tape playback.)
If your TV is equipped with AV input connectors
AConnect the aerial, recorder and TV as shown in the
illustration.
BConnect an AV cable between the AUDIO/VIDEO OUT
connectors on the rear of the recorder and the AV input
connectors on the TV.
●Even if you are using AV cables to connect your recorder to
your TV, you must also connect it using the RF cable. This will
ensure that you can record one show while watching another.
DConnect recorder to main
Plug the main power cord into a mains outlet.
Number keys
*[^]
0+++ +
PR. 12 SP
23 : 59 NTSC 3.58
31. 12. 01
– 1 : 23 : 45
A
B
C
H
G
E
F
D
JI RF cable
(supplied)
Back of recorder
Main power cord
AV cable
(not supplied)
To AV input
connectors
TV aerial cable
Main outlet
To aerial terminal
TV
– Buttons, Connectors and Indicators –
Specyfikacje produktu
| Marka: | JVC |
| Kategoria: | magnetowid |
| Model: | HR-J287MS |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z JVC HR-J287MS, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje magnetowid JVC
13 Września 2024
20 Sierpnia 2024
5 Lipca 2024
4 Lipca 2024
4 Lipca 2024
4 Lipca 2024
4 Lipca 2024
3 Lipca 2024
3 Lipca 2024
3 Lipca 2024
Instrukcje magnetowid
- magnetowid Sony
- magnetowid Tenda
- magnetowid Motorola
- magnetowid TP-Link
- magnetowid Philips
- magnetowid Bosch
- magnetowid Hikvision
- magnetowid EZVIZ
- magnetowid Canon
- magnetowid Reolink
- magnetowid TRENDnet
- magnetowid Toshiba
- magnetowid Imou
- magnetowid Grundig
- magnetowid Tripp Lite
- magnetowid Moxa
- magnetowid Synology
- magnetowid Digitus
- magnetowid Dahua Technology
- magnetowid DataVideo
- magnetowid Vivotek
- magnetowid Speco Technologies
- magnetowid Planet
- magnetowid Aiwa
- magnetowid LevelOne
- magnetowid Axis
- magnetowid Milesight
- magnetowid Abus
- magnetowid Ubiquiti Networks
- magnetowid QNAP
- magnetowid Hitachi
- magnetowid Ernitec
- magnetowid Hanwha
- magnetowid Grandstream
- magnetowid Foscam
- magnetowid Monacor
- magnetowid Daewoo
- magnetowid UniView
- magnetowid Acti
- magnetowid Sylvania
- magnetowid Magnum
- magnetowid GeoVision
- magnetowid Seagate
- magnetowid Provision ISR
- magnetowid Digital Watchdog
- magnetowid Skytronic
- magnetowid Magnavox
- magnetowid Inkovideo
- magnetowid Mach Power
- magnetowid Avigilon
Najnowsze instrukcje dla magnetowid
15 Października 2024
10 Października 2024
9 Października 2024
9 Października 2024
7 Października 2024
7 Października 2024
7 Października 2024
7 Października 2024
5 Października 2024
5 Października 2024