Instrukcja obsługi JVC FS-SD9R

JVC system hi-fi FS-SD9R

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla JVC FS-SD9R (29 stron) w kategorii system hi-fi. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/29
COMPACT COMPONENT SYSTEM
FS-SD5R/FS-SD7R/FS-SD9R
REMOT E CONTR OL
DIMM ER SLEEP
D ISPLAY FM M ODE
AHB PRO CD
PROGRAM
DOOR
SLIDE
AUTO
PRESET
REPEATRAND OM
BASS TREBLE CANC EL
UP
SET
DOW N
MD/AU X FM
/
AM
VOLU ME
CD
FADE M UTING
PTY/EON
DISPLAY MODE
FS-SD5R
FS-SD7R, FS-SD9R
REMOT E CONTR OL
DIMM ER SLEEP
D ISPLAY FM M ODE
AHB PRO CD
PROGRAM
DOOR
SLIDE
AUTO
PRESET
REPEATRAND OM
BASS TREBLE CANC EL
UP
SET
DOW N
MD/AU X FM
/
AM
VOLU ME
CD
FADE M UTING
PTY/EON
DISPLAY MODE
For Customer Use:
Enter below the Model No. and Serial No.
which are located either on the rear, bot-
tom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
INSTRUCTIONS
LVT0418-002A
[B/UB]
G-1
Warnings, Cautions and Others
IMPORTANT for the U.K.
DO NOT cut off the mains plug from this equipment. If the plug
fitted is not suitable for the power points in your home or the
cable is too short to reach a power point, then obtain an appro-
priate safety approved extension lead or consult your dealer.
BE SURE to replace the fuse only with an identical approved
type, as originally fitted.
If nontheless the mains plug is cut off ensure to remove the fuse
and dispose of the plug immediately, to avoid a possible shock
hazard by inadvertent connection to the mains supply.
If this product is not supplied fitted with a mains plug then follow
the instructions given below:
IMPORTANT:
DO NOT make any connection to the terminal which is marked
with the letter E or by the safety earth symbol or coloured green
or green-and-yellow.
The wires in the mains lead on this product are coloured in
accordance with the following code:
Blue :Neutral
Brown :Live
As these colours may not correspond with the coloured mark-
ings identifying the terminals in your plug proceed as follows:
The wire which is coloured blue must be connected to the termi-
nal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the ter-
minal which is marked with the letter L or coloured red.
IF IN DOUBT - CONSULT A COMPETENT ELECTRICIAN.
Caution — switch!
Disconnect the mains plug to shut the power off completely.
The switch in any position does not disconnect the mains
line. The power can be remote controlled.
IMPORTANT FOR LASER PRODUCTS
REPRODUCTION OF LABELS
1 CLASSIFICATION LABEL, PLACED ON EXTERIOR SUR-
FACE
2 WARNING LABEL, PLACED INSIDE THE UNIT
1 CLASS 1 LASER PRODUCT
2DANGER: Invisible laser radiation when open and interlock
failed or defeated. Avoid direct exposure to beam.
3CAUTION: Do not open the top cover. There are no user
serviceable parts inside the Unit; leave all servicing to qual-
ified service personnel.
CAUTION
To reduce the risk of electrical shocks, fire, etc.:
1 Do not remove screws, covers or cabinet.
2 Do not expose this appliance to rain or moisture.
Caution: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:
3 Front: No obstructions and open spacing.
4 Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.
5 Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height
of 10 cm or more.
CAUTION
■
■■
■About the Internal Cooling Fan
This unit includes an internal cooling fan, so as to allow for high-power operation within a small space.
This fan comes on when the sound level is set high, and may also come on even at low sound levels if the internal temperature rises. To ensure
effective fan operation, please leave at least 15cm clearance between the rear of the unit and the wall, and at least 1cm clearance on each side of
the unit.
CLASS 1
LASER PRODUCT
Front view Side view
10 cm
15 cm
15 cm
15 cm 1 cm 1 cm
STANDBY/ON OPEN/CLOSE
PHONES
15 cm
15 cm
G-2
SAFETY INSTRUCTIONS
“SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT”
This equipment has been disigned and manufactured to meet international safety standards but, like any electrical
equipment, care must be taken if you are to obtain the best results and safety is to be assured.
✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮
Do read the operating instructions before you attempt to use the equipment.
Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between
pieces of equipment) are properly made and in accordance with the manufacturer’s instructions. Switch off and with-
draw the mains plug when making or changing connections.
Do consult your dealer if you are ever in doubt about the installation, operation or safety of your equipment.
Do be careful with glass panels or doors on equipment.
✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮
DON’T continue to operate the equipment if you are in any doubt about it working normally, or if it is damaged in any
way–switch off, withdraw the mains plug and consult your dealer.
DON’T remove any fixed cover as this may expose dangerous voltages.
DON’T leave equipment switched on when it is unattended unless it is specifically stated that it is designed for unat-
tended operation or has a standby mode.
Switch off using the switch on the equipment and make sure that your family know how to do this.
Special arrangements may need to be made for infirm or handicapped people.
DON’T use equipment such as personal stereos or radios so that you are distracted from the requirements of traffic
safety. It is illegal to watch television whilst driving.
DON’T listen to headphones at high volume as such use can permanently damage your hearing.
DON’T obstruct the ventilation of the equipment, for example with curtains or soft furnishings.
Overheating will cause damage and shorten the life of the equipment.
DON’T use makeshift stands and NEVER fix legs with wood screws — to ensure complete safety always fit the man-
ufacturer’s approved stand or legs with the fixings provided according to the instructions.
DON’T allow electrical equipment to be exposed to rain or moisture.
ABOVE ALL
— NEVER let anyone, especially children, push anything into holes, slots or any other opening in the case -
this could result in a fatal electrical shock.;
— NEVER guess or take chances with electrical equipment of any kind
— it is better to be safe than sorry!

Specyfikacje produktu

Marka: JVC
Kategoria: system hi-fi
Model: FS-SD9R

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z JVC FS-SD9R, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje system hi-fi JVC

JVC

JVC RD-E761 Instrukcja

29 Września 2024
JVC

JVC UX-F227B-DAB Instrukcja

4 Września 2024
JVC

JVC UX-B70 Instrukcja

28 Sierpnia 2024
JVC

JVC UX-E15 Instrukcja

22 Sierpnia 2024
JVC

JVC CA-MXJ552R Instrukcja

6 Lipca 2024
JVC

JVC UX-P30 Instrukcja

5 Lipca 2024
JVC

JVC CA-MXS5 Instrukcja

4 Lipca 2024
JVC

JVC FS-SD9R Instrukcja

4 Lipca 2024
JVC

JVC CA-UXG48 Instrukcja

23 Maja 2024

Instrukcje system hi-fi

Najnowsze instrukcje dla system hi-fi

AKAI

AKAI EIE Pro Instrukcja

13 Października 2024
Sharp

Sharp XL-540H Instrukcja

11 Października 2024
Kenwood

Kenwood M-9000S Instrukcja

10 Października 2024
GoGen

GoGen MSC 472 BTDAB Instrukcja

9 Października 2024
Morel

Morel SUB-10X Instrukcja

9 Października 2024
Morel

Morel USUB 803 Instrukcja

9 Października 2024
Morel

Morel Soundsub PSW8e-w Instrukcja

9 Października 2024
Morel

Morel Sopran 934 Instrukcja

9 Października 2024
NAD

NAD M10 V3 Instrukcja

9 Października 2024
NUVO

NUVO NV-MPS4-E Instrukcja

8 Października 2024