Instrukcja obsługi JL Audio Stealthbox SB-GM-SLVEXT2/10W1v3/DG

JL Audio Niesklasyfikowane Stealthbox SB-GM-SLVEXT2/10W1v3/DG

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla JL Audio Stealthbox SB-GM-SLVEXT2/10W1v3/DG (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/2

I N S T A L L A T I O N G U I D E

for the

SB-GM-SLVEXT2/10W1v3

SKU#94467 - 94470

2007 - 2013 Chevrolet Silverado / GMC Sierra Extended Cab

Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With

proper installation, your new vehicle-specific enclosed subwoofer system will deliver

years of listening pleasure.

We strongly recommend that you have your new Stealthbox® installed by your

authorized JL Audio dealer. The installation professionals employed by your dealer have

the necessary tools and experience to disassemble and reassemble your vehicle properly.

Also, keep in mind that your warranty coverage extends to 2 years if your system is

installed or approved by your authorized JL Audio dealer. If you prefer to perform your

own installation, please read this installation guide completely

before beginning the process.

If you choose to perform the installation yourself, it is absolutely vital that

the Stealthbox ® be properly mounted to the vehicle according to these

instructions. Failure to mount the enclosure properly presents two problems:

1) The sub-bass performance will suffer due to the movement of the enclosure

caused by the force exerted by the woofer(s).

2) A loose enclosure presents a serious safety hazard in the event of a collision

or sudden deceleration.

S T E P 1

Empty out the area under the back seat so that you have a

Clean area to work in.

Continued on Next Page

S T E P 2

Measure 14” in from the inside of the rear sill trim as shown,

this should be the center of the 3” x 3” Wax Square.

S T E P 3

Thread the Mounting Stud into the bottom of the

Stealthbox® so that only 1/4”- 3/8” is exposed.

SB-GM-SLVEXT2/10W1v3 INSTR_SKU# 011300

INSTALLATI ON

D I F F I C U L T Y :

OUT

ESTIMATED TIME:

1 HOUR

14”

SB-GM-SLVEXT2/10W1v3 INSTR_SKU# 011300

S T E P 7

C O N G R A T U L A T I O N S !

You have completed the installation for this model!

Enjoy your new Stealthbox®!

Please refer to the Power Recommendation section for an

amplifier recommendation and basic set-up help.

S T E P 6

Install the included Fender Washer, Split Lock Washer and

Hex Nut as shown, tighten them down.

S T E P 5

Back the Mounting Stud out of the Stealthbox® so that

approximately 1-1/4” is exposed, set the Stealthbox® back

into place, with the Mounting Stud going through the freshly

drilled hole.

S T E P 4

Line up the Stealthbox® so that the seat belt anchor bolt is

centered in the recess in the enclosure. Press down on the

Stealthbox making and imprint in the 3” x 3” wax square with

the Mounting Stud. Remove the Stealthbox® and drill a 1/2”

hole through the floor where the mark was made.

Before drilling, always make sure that you are not

going to be drilling into any gas lines, brake lines,

tires, transmission lines, electrical wiring, exhaust

systems or anything else that might cause a

reduction in your weekly pay.

Always wear eye protection when drilling!

Page 2 • JL Audio, Inc 2016

All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered

trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.

For more detailed information please visit us online at www.jlaudio.com.

(954) 443-1100

w w w . j l a u d i o . c o m

1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A

I N C L U D E D H A R D W A R E

1) 3/8-16 Mounting Stud 1) 3/8 x 1-1/4” Fender Washer

1) 3/8” Split Lock Washer 1) 3/8-16 Hex Nut

S P E C I F I C A T I O N S

Enclosure Type: Acoustic Suspension (sealed)

Driver Type: (2) 10W1v3-4

Nominal Impedance: 2 ohms

Continuous Power Handling: 600 watts

P O W E R R E C O M M E N D A T I O N

JL Audio recommends high quality amplifiers such as the JL Audio HD900/5, 600/1v3 or JX500/1D. The diagram

below shows the recommended crossover, infrasonic filter and equalizer settings for the 600/1v3. If another

amplifier is being used, please reference this illustration and use similar settings on that amplifier.

All JL Audio amplifiers are very versatile audio components. Please consult the owner’s manual for even more

detailed information about installing and tuning your amplifier.

C O N N E C T I O N S

Using quality power, signal and speaker wire is essential in ensuring the performance of your Stealthbox®.

JL Audio recommends using a 4 AWG power kit such as the XC-PCS4-1B for your Stealthbox® amplifier, other

kits are available should you be using more than one amplifier. Signal wire such as the JL Audio Premium

Audio Interconnect Cables should be used that will provide signal for both channels of the amplifier. JL Audio

recommends using 12AWG speaker wire for subwoofers such as our XC-BCS12-25.

M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T

A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.

Front Speaker Size / Location: 6-1/2”- Front Doors

Fits JL Audio Models: TR650-CXi, TR650-CSi, C2-650x, C2-650,

C3-650, C5-650, C5-650x & ZR650-CSi

Rear Speaker Size / Location: 6-1/2”- Rear Doors

Fits JL Audio Models: TR650-CXi, TR650-CSi, C2-650x, C2-650,

C3-650, C5-650, C5-650x & ZR650-CSi

Specyfikacje produktu

Marka:	JL Audio
Kategoria:	Niesklasyfikowane
Model:	Stealthbox SB-GM-SLVEXT2/10W1v3/DG

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z JL Audio Stealthbox SB-GM-SLVEXT2/10W1v3/DG, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Niesklasyfikowane JL Audio

JL Audio MediaMaster 55-HR Instrukcja

7 Października 2024

JL Audio MediaMaster 55 Instrukcja

7 Października 2024

JL Audio Stealthbox SB-J-JL4DPAS/10TW1-2 Instrukcja

4 Października 2024

JL Audio MBT-RX Instrukcja

3 Października 2024

JL Audio MediaMaster MM105-HR Instrukcja

2 Października 2024

JL Audio JLINK RX Instrukcja

30 Września 2024

JL Audio Stealthbox SB-POL-RZG3/10TW3 Instrukcja

29 Września 2024

JL Audio Stealthbox SBA-J-JK-FHB Instrukcja

27 Września 2024

JL Audio Stealthbox SB-GM-BURBCNSL/10W3v3 Instrukcja

27 Września 2024

JL Audio Stealthbox SB-F-SUPRDTY/10W1v3 Instrukcja

27 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024

Stihl HT 70 Instrukcja

15 Października 2024

Ernesto H14270 Instrukcja

15 Października 2024

Uniden BT MIC KIT Instrukcja

15 Października 2024

Vaude Omnis Bike 26 Instrukcja

15 Października 2024

ART ProChannel II Instrukcja

15 Października 2024

Aukey DR02J Instrukcja

15 Października 2024

Master Lock 653EURD Instrukcja

15 Października 2024

Roland FR-18 Diatonic Instrukcja

15 Października 2024