Instrukcja obsługi JL Audio Stealthbox SB-F-MUCUPE/13W3v3

JL Audio Niesklasyfikowane Stealthbox SB-F-MUCUPE/13W3v3

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla JL Audio Stealthbox SB-F-MUCUPE/13W3v3 (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/2
INSTALLATION
D I F F I C U L T Y :
I N S T A L L A T I O N G U I D E
for the
SB-F-MUCUPE/13W3v3
SKU# 94256
2005-2009 Ford Mustang Coupe
SB-F-MUCONV2/13W3v3
SKU#94286
2005-2009 Ford Mustang Convertible
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With
proper installation, your new vehicle-specific enclosed subwoofer system will deliver years
of listening pleasure.
We strongly recommend that you have your new Stealthbox® installed by your authorized
JL Audio dealer. The installation professionals employed by your dealer have the necessary
tools and experience to disassemble and reassemble your vehicle properly. Also, keep in
mind that your warranty coverage extends to 2 year if your system is installed or approved
by your authorized JL Audio dealer. If you prefer to perform your own installation,
please read this installation guide completely before beginning the process.
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox ® be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
S T E P 1
Remove any contents from the trunk.
Continued on Next Page
S T E P 2
Flip up the passenger’s side corner of the trunk flooring and
remove the exposed a black rubber grommet.
S T E P 3
Lay the trunk flooring back into the corner. Feel for the hole
exposed in STEP 2 and cut the flooring at the hole.
SB-F-MUCUPE/13W3v3_SB-F-MUCONV2/13W3v3 INSTR_SKU# 011216
15
OUT
OF
SB-F-MUCUPE/13W3v3_SB-F-MUCONV2/13W3v3 INSTR_SKU# 011216
C O N G R A T U L A T I O N S
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
S T E P 6
From under the vehicle, place the supplied lock washer, flat
washer, flat washer, fender washer onto the supplied hex
bolt.
Note: For added protection it is recommended that
you apply a bead of silicone between the vehicle and
the fender washer. After the bolt assembly is tightly
secured, it is also recommended that vehicle under-
coating material is applied to the exposed assembly.
Place the bolt assembly through the exposed hole and apply
the bolt into the threaded insert of the Stealthbox®.
Secure tightly.
S T E P 5
As in the picture, slide the front of the Stealthbox® into place.
Then slide the rear of the Stealthbox® into place.
Make sure that the speaker wire and the factory trunk wir-
ing do not get caught up between the Stealthbox® and the
body of the vehicle.
S T E P 4
Place the Stealthbox® into the trunk.
Run speaker wire to the Stealthbox® and wire to the terminal.
Double check the woofer for proper operation.
Page 3 • JL Audio, Inc 2016
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 011216 09.20.2016 • Printed in USA • ©2016 JL Audio, Inc.
For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100
w w w . j l a u d i o . c o m
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y M I R A M A R , F L O R I D A 3 3 0 2 5 U S A
I N C L U D E D H A R D W A R E
(1) 3/8-inch x 2-1/2-inch - 16 Hex Bolt
(1) 3/8-inch USS Flat Washer
(1) 3/8-inch Fender Washer
(1) 3/8-inch Lock Washer
S P E C I F I C A T I O N S
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: 13W3v3-2
Nominal Impedance: 2 ohms
Continuous Power Handling: 600 Watts
P O W E R R E C O M M E N D A T I O N
JL Audio recommends using a high quality amplifier such as the JL Audio XD600/1v2. The diagram below shows
the recommended crossover settings for the XD600/1v2 when being used to power your Stealthbox ®
.
The JL Audio XD600/1v2 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 5x7 / 6x8-inch / Front Doors
Fits JL Audio Models: TR570-CXi, C2-570x, C3-570, C5-570x, & C5-570
Rear Speaker Size / Location: 5x7 / 6x8-inch/ Rear Deck
Fits JL Audio Models: TR570-CXi, C2-570x, C3-570, C5-570x, & C5-570


Specyfikacje produktu

Marka: JL Audio
Kategoria: Niesklasyfikowane
Model: Stealthbox SB-F-MUCUPE/13W3v3

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z JL Audio Stealthbox SB-F-MUCUPE/13W3v3, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Niesklasyfikowane JL Audio

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024