Instrukcja obsługi JBL GSF6

JBL głośnik GSF6

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla JBL GSF6 (6 stron) w kategorii głośnik. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/6
Installation Guide
GSF3 & GSF6 Landscape Speakers
CAUTION: Installation must be done by qualified persons using safe
installation standards.
The installer is responsible for proper selection and use of mounting hardware
and processes to install the speakers in a safe manner.
Wire Connection
• CABLE-- - - - The GSF speakers have a captive 1 meter long cable for bare wire connection via an external installer provided
weather proof- junction box.
o Polarity -- – . The red wire is + (positive) and the black wire is (negative)
o Wire Gauge – 1 The wire gauge is 18 AWG ( mm2).
o Wire Jacket – - The wire jacket is 5 mm (+0/ 05.mm) in diameter.
o Connecting -- Use proper wire nuts or other safe connectorsprofessional that are appropriate for the installation
conditions and that are sized properly for wire gauge(s) and number of wires to be connected together in the
connector.
o Routing – - - When using the ground stake or L bracket base, the cable can be routed through the base.
Black - = (negative)
Red = + (positive)
CABLE
Bare-Wire End of Cable
Setting TAP SELECTOR SWITCH
(TAP SELECTOR SWITCH is located on the bottom of the speaker enclosure)
• Rotate bottom- : panel TAP SELECTOR SWITCH to select between
o GSF3:
8 - ) Ω(ie, low impedance / direct
15W or 7.5W for either 70V or 100V distributed speaker system
3.75W for 70V distributed speaker system only
o GSF6:
8 - Ω(ie, low impedance / direct)
30W or 15W for either 70V or 100V distributed speaker system
7.5W for 70V distributed speaker system only
Installing GROUND OUDSPEAKER-STAKE BASE or L BRACKET BASE - to L
• The speaker comes with both a GROUND-STAKE BASE and an L-BRACKET BASE. Use whichever one applies to the installation
requirements of the project.
• At the bottom of the LOUDSPEAKER there is a SOCKET. Three come with the speaker (packaged in a separate - rhead set sc ews
pouch) for attaching the chosen base into the SOCKET.
o Screw Dimensions -- – , GSF3: M4 x 0.7 5mm with 3 mm hex drive
GSF6: M4 x 0.7 – 9 , mm with 3 mm hex drive
(GSF SPEAKER shown with L-BRACKET BASE)
(continued ↓)
ROTARY TAP SELECTOR SWITCH
• Use the included 3 mm hex wrench to tighten the 3 set screws to hold the chosen base securely.
• For GROUND-STAKE BASE, press base into the ground.
(GSF SPEAKER shown with included GROUND STAKE base)-
• For L BRACKET BASE, securely attached base to either horizontal surface (such as decking or railing) or vertical surface (such as t- he
side of a building or post). Use the proper attachment hardware for the material and characteristics of what it’s being attached to.
Aiming LOUDSPEAKER
• Loosen HINGE BOLT by using included 4 mm hex key. Aim loudspeaker, and then retighten.
• Aiming Speaker at Downward Angle Provides Best Drainage – The greatest water drainage and reliability can be achieved by
aiming the speaker at a slight downward aiming angle.
• Maximum Upward Aiming Angle of 30° -- For when aimed slightly upward, there is a drain hole at the bottom of the speaker
that helps to drain water from the front of the speaker’s driver °at aiming angles up to a maximum 30 . At upward aiming
angles potentially °greater than 30 , water can pool on the driver, causing damage.
Ingress Protection Rating
• IP66 -- The GSF speakers are rated IP66 ( per IEC529 highly protected against ingress from dust and water). However, the
speaker is not rated for submersion in water, so steps must be taken to ensure that no immersion situation occurs.
HINGE BOLT
(use included 4 mm hex key)
(Shown with included L-BRACKET base)
CAUTION WHEN RE-AIMING SPEAKER:
When ground stake is utilized, re aiming speaker - -
horizontally requires either: a) completely pull ing
stake from ground and re back into -pressing
ground at new aiming angle or b) loosening 3 set ,
screws, re- -aiming speaker, and re tightening set
screws. Trying to rotate speaker with stake in
ground could and set screws tightened result in
damage or breakage.
CAUTION WHEN ROTATING ON L- : BRACKET
When bracket rotating speakerL- is utilized, on L-
bracket otating requires loosening 3 set screws, r
speaker, and re tightening set screws. Trying to -
rotate speaker set screws tightened could with
result in damage or breakage.

Specyfikacje produktu

Marka: JBL
Kategoria: głośnik
Model: GSF6

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z JBL GSF6, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje głośnik JBL

JBL

JBL B-6ICDT Instrukcja

11 Stycznia 2025
JBL

JBL B-8IC Instrukcja

11 Stycznia 2025
JBL

JBL 4349 Instrukcja

11 Stycznia 2025
JBL

JBL Tower X Marine MT10HLW Instrukcja

5 Stycznia 2025
JBL

JBL Control CM42AW Instrukcja

31 Grudnia 2025
JBL

JBL Performance P36AW Instrukcja

31 Grudnia 2025
JBL

JBL Balboa 30 Instrukcja

31 Grudnia 2025
JBL

JBL 250Ti Instrukcja

31 Grudnia 2025
JBL

JBL 800 Instrukcja

31 Grudnia 2025
JBL

JBL 900 Instrukcja

31 Grudnia 2025

Instrukcje głośnik

Najnowsze instrukcje dla głośnik

Bowers & Wilkins

Bowers & Wilkins LCR3 Instrukcja

15 Stycznia 2025
Hifonics

Hifonics Vulcan VX6.2E Instrukcja

15 Stycznia 2025
Pyle

Pyle PLRGSW64BK Instrukcja

15 Stycznia 2025
ION

ION Insta Sound Instrukcja

15 Stycznia 2025
Pure Acoustics

Pure Acoustics QBT-340 Instrukcja

15 Stycznia 2025
Yamaha

Yamaha WX-010 Instrukcja

15 Stycznia 2025
Polk

Polk REACT SOUND BAR 1 Instrukcja

15 Stycznia 2025
Sennheiser

Sennheiser AMBEO Soundbar Plus SB02M Instrukcja

15 Stycznia 2025
Klipsch

Klipsch Reference RB-25 Instrukcja

15 Stycznia 2025
Klipsch

Klipsch Reference RB-35 Instrukcja

15 Stycznia 2025