Instrukcja obsługi Intel NUC 10 Performance
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Intel NUC 10 Performance (10 stron) w kategorii Pulpit. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/10
User Guide for NUC10i7FNH NUC i5FNH NUC i3 H, 10 , 10 FN
1
Intel® NUC Kit NUC H 10i7FN
Intel® NUC Kit NUC H 10i5FN
Intel® NUC Kit NUC H 10i3FN
User Guide
User Guide for NUC10i7FNH NUC i5FNH NUC i3 H, 10 , 10 FN
2
Before You Begin
CAUTIONS
The steps in this guide sume familiar with computer terminology with the safety as you’re and
practices a regulatory compliance required for using and modifying computer equipment.nd
Disconnect the computer from its power so ce and from any network before performi any of the steps ur ng
described in this guide.
Failure to disconnect power, telecommunications nks, or orks before you open the computer or li netw
perform procedures can result in personal injury or equipment damage. Some circuitry on the board any
can continue operate even though the front panel power bu on is f.to tt of
Follow these guidelines before you begin:
• Always follow the steps in each procedure in the correct order.
• Create a log to record information about your computer, such as mo l, serial numbersde ,
installe tions, an conf at n informat d op d igur io ion.
• Electrostati ischarge (ESD) can damage components. rform the procedures describe in c d Pe d
thi ch tes ap r onl at an ESD workstat n ing an a tatic wr t strap and a conductive foam y io us ntis is
pad. If such a stat n available, you n provide some ESD protection by wearing an io isn’t ca
antistatic wrist strap and attaching to a metal part of the computer chassis. it
Installation Precautions
When you inst an test the I el NUC, observe l warning an caut ns in the installat n all d nt al s d io io
instruct ns. io
To avoid injury, be careful of:
• Sharp pins on connecto rs
• Sharp pins circuit boards on
• Rough edges and sharp corners on the chassis
• Hot components (such as SSDs, processors, voltage regulators, a heat sinks) nd
• Damage wires that could cause a short circuit to
Observe l rning caut ns that instruct you fe computer serv ng to qualifal wa s and io to re r ici ied
tec perso el. hnical nn
Observe Safety and Regulatory Requirements
If you f w don’t ollo these instruct ns, you increase your safety risk and the possibility of noncom iance io pl
wi regional laws and regul ions. th at
User Guide for NUC10i7FNH NUC i5FNH NUC i3 H, 10 , 10 FN
3
Thi guide s you w to: s tell ho
•
Install and remove moryme
•
Install a M.2 SSDn
•
Install a 2.5” drive
•
Install a VESA mount bracket
•
Connect power
•
Install an operating system
•
Install the latest drivers
Open the Chassis
To open the Intel NUC chassis, follow these steps:
1. Unscrew the four corner screws on the bottom cover of the chassis and lift the cover .
Installing and Removing Memory
Intel NUC Kits H H, and NUC H have two 2 -pin DDR4 -DIMM socketsNUC10i7FN , NUC10i5FN 10i3FN 60 SO .
Be sure to select memory modules that meet these requirements:
• 1.2V low voltage memory
• 2666 MHz -DIMMs SO
• Non-ECC
Find compatible memory modules in the Intel Product Compatibility Tool
• NUC H10i7FN
• NUC H10i5FN
• NUC10i3FNH
NOTE
If you plan to install only one memory module, install it in the lower memory
socket.
Specyfikacje produktu
| Marka: | Intel |
| Kategoria: | Pulpit |
| Model: | NUC 10 Performance |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Intel NUC 10 Performance, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Pulpit Intel
13 Września 2024
13 Września 2024
13 Września 2024
13 Września 2024
12 Września 2024
12 Września 2024
11 Września 2024
11 Września 2024
11 Września 2024
11 Września 2024
Instrukcje Pulpit
- Pulpit Sony
- Pulpit Samsung
- Pulpit Supermicro
- Pulpit Lenovo
- Pulpit Gigabyte
- Pulpit Acer
- Pulpit Fujitsu
- Pulpit LC-Power
- Pulpit Promethean
- Pulpit Viewsonic
- Pulpit Asus
- Pulpit Medion
- Pulpit MSI
- Pulpit Toshiba
- Pulpit Haier
- Pulpit HP
- Pulpit Tripp Lite
- Pulpit Moxa
- Pulpit ZTE
- Pulpit Dell
- Pulpit JYSK
- Pulpit Apple
- Pulpit Vtech
- Pulpit NEC
- Pulpit Axis
- Pulpit Optoma
- Pulpit Asrock
- Pulpit Microsoft
- Pulpit Sharkoon
- Pulpit ECS
- Pulpit BDI
- Pulpit Zotac
- Pulpit Alienware
- Pulpit Parisot
- Pulpit Maxdata
- Pulpit Wehkamp
- Pulpit InFocus
- Pulpit Targa
- Pulpit Peaq
- Pulpit Shuttle
- Pulpit Vorago
- Pulpit VXL
- Pulpit Foxconn
- Pulpit Ibm
- Pulpit Packard Bell
- Pulpit Advantech
- Pulpit Kogan
- Pulpit MP
- Pulpit Elitegroup
- Pulpit Smart Things
- Pulpit ONYX
- Pulpit System76
- Pulpit Zoostorm
- Pulpit Bestar
- Pulpit Pelco
- Pulpit Altra
- Pulpit Dell Wyse
- Pulpit AOpen
- Pulpit NComputing
- Pulpit MvixUSA
- Pulpit Faytech
- Pulpit AIS
- Pulpit Wyse
Najnowsze instrukcje dla Pulpit
15 Października 2024
15 Października 2024
14 Października 2024
12 Października 2024
10 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
8 Października 2024
8 Października 2024