Instrukcja obsługi Intel Baby Canyon NUC7i7BNH
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Intel Baby Canyon NUC7i7BNH (10 stron) w kategorii Pulpit. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/10
Intel NUC Kit NUC7i7BNH, NUC7i5BNH NUC7i3BNH User Guide &
1
Intel®
NUC Kit
NUC7i7BNH
Intel®
NUC Kit
NUC7i5BNH
Intel®
NUC Kit
NUC7i3BNH
User
Guide
Intel NUC Kit NUC7i7BNH, NUC7i5BNH NUC7i3BNH User Guide &
2
Before You Begin
CAUTIONS
The procedures in this user guide sume familiarity with the general terminology associated with as
personal computers and with the safety practices a regulatory compliance required for using nd
and modifying electronic equipment.
Disconnect the computer from its power so ce and from any telecommunications link or netwo before ur rk
performi any of the procedures described in this guide. Failure to disconnect power, ng
telecommunications nks, or orks before you open the computer or perform procedures can li netw any
result in personal injury or equipment damage. Some circuitry on the board can continue operate to
even though the front panel power bu on is f.tt of
Follow these guidelines before you begin:
Always follow the steps in each procedure in the correct order.
Set up a log to record information about your computer, such as mo l, serial numbersde ,
installe tions, an conf at n informat d op d igur io ion.
Electrostati ischarge (ESD) can damage components. rform the procedures describe in c d Pe d
thi ch tes ap r onl at an ESD workstat n ing an a tatic wr t strap and a conductive foam y io us ntis is
pad. If such a stat n is not available, you n provide some ESD protection by wearing an io ca
antistatic wrist strap and attaching to a metal part of the computer chassis. it
Installation Precautions
When you inst an test the I el NUC, observe l warning an caut ns in the installat n all d nt al s d io io
instruct ns. io
To avoid injury, be careful of:
Sharp pins on connecto rs
Sharp pins circuit boards on
Rough edges and sharp corners on the chassis
Hot components (such as SSDs, processors, voltage regulators, a heat sinks) nd
Damage wires that could cause a short circuit to
Observe l rning caut ns that instruct you fe computer serv ng to qualifal wa s and io to re r ici ied
tec perso el. hnical nn
Observe Safety and Regulatory Requirements
If you do not f w instruct ns, you increase your safety risk and the possibility of ollo these io
noncom iance wipl th regional laws and regul ions. at
Intel NUC Kit NUC7i7BNH, NUC7i5BNH NUC7i3BNH User Guide &
3
Thi guide s you w to: s tell ho
•
Install an M.2 SSD
•
Install and remove mory me
•
Install a 2.5” drive
•
Install a VESA mount bracket
•
Connect power
•
Install an operating system
•
Install the latest drivers
Open the Intel NUC Chassis
To open the Intel NUC chassis, follow these steps:
1. Unscrew the four corner screws on the bottom cover of the chassis and lift the cover.
Install a M.2 SSDn
Intel NUC Kits NUC7i7BNH, NUC7i5BNH, and NUC7i3 support 80mm and 42mm M.2 SSDs. For a list BNH
of tested M.2 SSDs, go to the page on the Support site. Tested Peripherals
Observe the precautions in "Before You Begin" on page 2.
If you are installing an 80mm M.2 SSD:
1. Remove the small silver screw from the 80mm metal standoff on the motherboard (A).
2. Remove the standoff from the 42mm position (B).
3. A gn the small notch at the bo om edge of the M.2 card with the key in the connector. li tt
Specyfikacje produktu
| Marka: | Intel |
| Kategoria: | Pulpit |
| Model: | Baby Canyon NUC7i7BNH |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Intel Baby Canyon NUC7i7BNH, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Pulpit Intel
13 Września 2024
13 Września 2024
13 Września 2024
13 Września 2024
12 Września 2024
12 Września 2024
11 Września 2024
11 Września 2024
11 Września 2024
11 Września 2024
Instrukcje Pulpit
- Pulpit Sony
- Pulpit Samsung
- Pulpit Supermicro
- Pulpit Lenovo
- Pulpit Gigabyte
- Pulpit Acer
- Pulpit Fujitsu
- Pulpit LC-Power
- Pulpit Promethean
- Pulpit Viewsonic
- Pulpit Asus
- Pulpit Medion
- Pulpit MSI
- Pulpit Toshiba
- Pulpit Haier
- Pulpit HP
- Pulpit Tripp Lite
- Pulpit Moxa
- Pulpit ZTE
- Pulpit Dell
- Pulpit JYSK
- Pulpit Apple
- Pulpit Vtech
- Pulpit NEC
- Pulpit Axis
- Pulpit Optoma
- Pulpit Asrock
- Pulpit Microsoft
- Pulpit Sharkoon
- Pulpit ECS
- Pulpit BDI
- Pulpit Zotac
- Pulpit Alienware
- Pulpit Parisot
- Pulpit Maxdata
- Pulpit Wehkamp
- Pulpit InFocus
- Pulpit Targa
- Pulpit Peaq
- Pulpit Shuttle
- Pulpit Vorago
- Pulpit VXL
- Pulpit Foxconn
- Pulpit Ibm
- Pulpit Packard Bell
- Pulpit Advantech
- Pulpit Kogan
- Pulpit MP
- Pulpit Elitegroup
- Pulpit Smart Things
- Pulpit ONYX
- Pulpit System76
- Pulpit Zoostorm
- Pulpit Bestar
- Pulpit Pelco
- Pulpit Altra
- Pulpit Dell Wyse
- Pulpit AOpen
- Pulpit NComputing
- Pulpit MvixUSA
- Pulpit Faytech
- Pulpit AIS
- Pulpit Wyse
Najnowsze instrukcje dla Pulpit
15 Października 2024
15 Października 2024
14 Października 2024
12 Października 2024
10 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
8 Października 2024
8 Października 2024