Instrukcja obsługi Indesit XWDE 751480X K UK
Indesit
Kombinacje pralko-suszarki
XWDE 751480X K UK
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Indesit XWDE 751480X K UK (20 stron) w kategorii Kombinacje pralko-suszarki. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/20
1
GB
Washer-dryer
Instructions for use
! This symbol reminds you to read this instruction
manual.
Contents
Installation, 2-3-4-5
Unpacking and levelling
Connecting the electricity and water supplies
The first wash cycle
Technical data
Care and maintenance, 6
Cutting off the water and electricity supplies
Cleaning the washer-dryer
Cleaning the detergent dispenser drawer
Caring for the door and drum of your appliance
Cleaning the pump
Checking the water inlet hose
Precautions and tips, 7
General safety
Disposal
Opening the porthole door manually
Description of the washer-dryer, 8-9
Control panel
Display
How to run a wash cycle or a drying cycle, 10
Wash cycles and options, 11-12
Table of wash cycles
Wash options
Push&Wash+Dry
Detergents and laundry, 13-14
Detergent dispenser drawer
Preparing the laundry
Special wash cycles
Load balancing system
Troubleshooting, 15-16
Product Guarantee and Repair Information, 17
XWDE 751480
English,1
GB
2
GB
! This instruction manual should be kept in a safe
place for future reference. If the washer-dryer is
sold, transferred or moved, make sure that the
instruction manual remains with the machine so
that the new owner is able to familiarise himself/
herself with its operation and features.
! Read these instructions carefully: they contain
vital information relating to the safe installation
and operation of the appliance.
Unpacking and levelling
Unpacking
1. Remove the washer-dryer from its packaging.
2. Make sure that the washer-dryer has not been
damaged during the transportation process. If
it has been damaged, contact the retailer and
do not proceed any further with the installation
process.
3. R emov e t h e 4
protective screws (used
during transportation)
and the rubber washer
with the corresponding
spacer, located on
the rear part of the
appliance ( ).see figure
4. Close off the holes using the plastic plugs
provided.
5. Keep all the parts in a safe place: you will
need them again if the washer-dryer needs to
be moved to another location.
! Packaging materials should not be used as
toys for children.
Levelling
1. Install the washer-dryer on a flat sturdy floor,
without resting it up against walls, furniture
cabinets or anything else.
2. If the floor is not
p e r f e c t l y l e v e l ,
c o m p e n s a t e f o r
any unevenness by
tightening or loosening
the adjustable front
feet ( ); the see figure
angle of inclination,
measured in relation to
the worktop, must not
exceed 2°.
Levelling the machine correctly will provide it with
stability, help to avoid vibrations and excessive
noise and prevent it from shifting while it is
operating. If it is placed on carpet or a rug, adjust
the feet in such a way as to allow a sufficient
ventilation space underneath the washer-dryer.
Connecting the electricity and
water supplies
Connecting the water inlet hose
1. Connect the supply
pipe by screwing it
to a cold water tap
using a ¾ gas threaded
connection (see figure).
Before performing the
connection, allow the
water to run freely until
it is perfectly clear.
2. Connect the inlet
hose to the washer-
dryer by screwing it
onto the corresponding
wat er inl et of t he
appliance, which is
situated on the top
right-hand side of
the rear part of the
appliance . (see figure)
3. Make sure that the hose is not folded over
or bent.
! The water pressure at the tap must fall within
the values indicated in the Technical details table
(see next page).
! If the inlet hose is not long enough, contact a
specialised shop or an authorised technician.
! Never use second-hand hoses.
! Use the ones supplied with the machine.
Installation
3
GB
Connecting the drain hose
Connect the drain
hose, without bending
it, to a draining duct or
a wall drain situated
between 65 and 100
cm from the floor;
The drain hose may
be c o n n ec t e d t o
an under-sink trap.
Before connecting
the drain hose from
the machine ensure
that any blanks or
removable ends have
been taken off the
spigot.
If it is placed over the
edge of a basin or sink
be sure the free end of
the hose should not
be underwater.
! We advise against the use of hose extensions; in
case of absolute need, the extension must have the
same diameter as the original hose and must not
exceed 150 cm in length. Ensure that if the drain
hose is pushed into a standpipe, that the end does
not go down more than 15cms (6 inches). If the hose
is pushed down too far, this may cause the machine
to self -syphon ie. continuously empty as it is filling.
Electric connection
Before plugging the appliance into the mains
socket, make sure that:
• the socket is earthed and in compliance with
the applicable law;
• the socket is able to sustain the appliance’s
maximum power load indicated on the Technical
Data Plate fixed on the machine;
65 - 100 cm
Where it connects to
the waste water pipe
cut end off spigot or
remove the blanking cap
• the supply voltage is included within the values
indicated on the Technical Data Plate fixed on
the machine.
• the socket is compatible with the washing
machine’s plug. If this is not the case, replace
the socket or the plug.
Your appliance is now supplied with a 13 amp
fused plug it can be plugged into a 13 amp
socket for immediate use. Before using the
appliance please read the instructions below.
WARNING - THIS APPLIANCE MUST BE EARTHED.
THE FOLLOWING OPERATIONS SHOULD BE
CARRIED OUT BY A QUALIFIED ELECTRICIAN.
Replacing the fuse:
When replacing a faulty fuse, a 13 amp ASTA
approved fuse to BS 1362 should always be
used, and the fuse cover re-fitted. If the fuse
cover is lost, the plug must not be used until a
replacement is obtained.
Replacement fuse covers:
If a replacement fuse cover is fitted, it must be of
the correct colour as indicated by the coloured
marking or the colour that is embossed in words
on the base of the plug. Replacements can be
obtained directly from your nearest Service Depot.
Removing the plug:
If your appliance has a non-rewireable moulded
plug and you should wish to re-route the mains
cable through partitions, units etc., please
ensure that either:
the plug is replaced by a fused 13 ampere
rewireable plug bearing the BSI mark of approval.
or:
the mains cable is wired directly into a 13
amp cable outlet, controlled by a switch, (in
compliance with BS 5733) which is accessible
without moving the appliance.
Disposing of the plug:
Ensure that before disposing of the plug itself,
you make the pins unusable so that it cannot be
accidentally inserted into a socket.
Instructions for connecting cable to an alternative
plug:
Important: the wires in the mains lead are
coloured in accordance with the following code:
Green & Yellow Earth
Blue Neutral
Brown Live
Specyfikacje produktu
| Marka: | Indesit |
| Kategoria: | Kombinacje pralko-suszarki |
| Model: | XWDE 751480X K UK |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Indesit XWDE 751480X K UK, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Kombinacje pralko-suszarki Indesit
14 Października 2024
12 Października 2024
12 Października 2024
12 Października 2024
11 Października 2024
7 Października 2024
9 Sierpnia 2024
8 Sierpnia 2024
5 Lipca 2024
5 Lipca 2024
Instrukcje Kombinacje pralko-suszarki
- Kombinacje pralko-suszarki Bauknecht
- Kombinacje pralko-suszarki Samsung
- Kombinacje pralko-suszarki Electrolux
- Kombinacje pralko-suszarki Beko
- Kombinacje pralko-suszarki LG
- Kombinacje pralko-suszarki Amica
- Kombinacje pralko-suszarki Sharp
- Kombinacje pralko-suszarki Bosch
- Kombinacje pralko-suszarki Candy
- Kombinacje pralko-suszarki Whirlpool
- Kombinacje pralko-suszarki Miele
- Kombinacje pralko-suszarki Lamona
- Kombinacje pralko-suszarki Infiniton
- Kombinacje pralko-suszarki Hoover
- Kombinacje pralko-suszarki Brandt
- Kombinacje pralko-suszarki Siemens
- Kombinacje pralko-suszarki Haier
- Kombinacje pralko-suszarki Blomberg
- Kombinacje pralko-suszarki Hotpoint
- Kombinacje pralko-suszarki Hotpoint Ariston
- Kombinacje pralko-suszarki Neff
- Kombinacje pralko-suszarki Zanussi
- Kombinacje pralko-suszarki Rosieres
- Kombinacje pralko-suszarki Sanyo
- Kombinacje pralko-suszarki Frilec
- Kombinacje pralko-suszarki Summit
- Kombinacje pralko-suszarki Belling
- Kombinacje pralko-suszarki Euromaid
- Kombinacje pralko-suszarki Tricity Bendix
- Kombinacje pralko-suszarki Zanussi-electrolux
- Kombinacje pralko-suszarki Servis
- Kombinacje pralko-suszarki Voltas BEKO
- Kombinacje pralko-suszarki Elba
- Kombinacje pralko-suszarki Creda
Najnowsze instrukcje dla Kombinacje pralko-suszarki
13 Października 2024
13 Października 2024
11 Października 2024
10 Października 2024
10 Października 2024
8 Października 2024
29 Września 2024
9 Sierpnia 2024
9 Sierpnia 2024
9 Sierpnia 2024