Instrukcja obsługi Indesit WIXXL 86 (EU)
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Indesit WIXXL 86 (EU) (72 stron) w kategorii Pralki. Ta instrukcja była pomocna dla 14 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/72
1
GB
Instruction booklet
WASHING MACHINE
WIXXL 86
English
GB
Contents
Installation, 2-3
Unpacking, 2
Remove the transit fixings, 2
Levelling, 2
Water connections, 2
Drainage and electrical connections, 3
Technical Details, 3
Washing machine description, 4-5
Control panel, 4
LEDs, 5
Starting and programmes, 6
Briefly: starting a programme, 6
Programme table, 6
Personalisations, 7
Setting the temperature, 7
Setting the spin speed, 7
Options, 7
Detergents and laundry, 8
Detergent dispenser, 8
Maximum load size, 8
Precautions and advice, 9
General safety, 9
Disposal, 9
Saving energy and respecting
the environment, 9
Care and Maintenance, 10
Switching off the water or electricity supply, 10
Cleaning, 10
Caring for your appliance door and drum, 10
Cleaning the pump, 10
Checking the water inlet hose, 10
Troubleshooting, 11
Service, 12
Before calling for assistance, 12
2
GB
Keep this instruction manual in a safe place for future
reference. Should the appliance be sold, transferred or
moved, make sure the instruction manual
accompanies the washing machine to inform the new
owner as to its operation and features.
! Read these instructions carefully: they contain vital
information on installation, use and safety.
Unpacking
1. Unpack the machine.
2. Check whether the machine has been damaged
during transport. If this is the case, do not install it and
contact your retailer.
Remove the transit fixings
IMPORTANT: Follow these instructions to remove the
TWO transit fixings (see Description for location).
Situated on either side of the
rear panel, BOTH transit boltsBOTH transit boltsBOTH transit boltsBOTH transit boltsBOTH transit bolts
MUST be rMUST be r
MUST be rMUST be rMUST be removed beforemoved befor
emoved beforemoved beforemoved before usee use
e usee usee use.
! Failure to do so may cause
damage to your machine.
It is important the transit bolt
and spacer (see pic) come out
intact.
1. Unscrew the bolt using a
13mm spanner.
2. STOP when 3 threads can be
seen.
3. Hold, slide sideways and pull
to remove.
4. For safety, insert one of the
the plastic covers (supplied with
your machine) over the hole.
! Repeat steps 1 to 4 to remove
the second transit bolt.
! Packaging materials are not
children’s toys.
Levelling
Your machine will be noisy if the two front feet are not
adjusted so that the machine stands firm and level.
! The machine should be levelled from side to side and
from front to back.
1. Move your machine into its final location.
- Take care not to trap or kink
the hoses.
2. Turn one or both front feet
anti-clockwise by hand until the
feet cannot be turned any more.
When adjusting the feet, use a
spirit level to check the machine
stands level, from side to side
and from front to back.
- The spring on each foot will stop them coming loose.
! If it is placed on a fitted or loose carpet, adjust the
feet in such a way as to allow enough room for
ventilation beneath the machine.
Water connection
Connecting the water inlet hose.
Remember that this is a cold-fill machine.
! Check that seal is in place
inside the hose end cap.
Before making the water connections to gas ¾ thread,
allow the water to run freely from the supply tap until it
is perfectly clear.
Screw the inlet end with the blue
cap onto the cold water supply
tap.
Turn the taps on and check for leaks: tighten if
necessary.
! Make sure there are no kinks or bends in the hose.
! The water pressure at the tap must be within the
values indicated in the Technical details table (next
page).
! If the water inlet hose is not long enough, contact a
specialist store or an authorised serviceman.
! Always use new hoses.
! Check the water hose at least once a year, replace
any that are cracked as worn hoses could split under
water pressure.
Installation
3
GB
Drainage connections
A. Connect the drain
hose, without kinking it,
to a draining duct or a
wall drain fixed at a
height between 65 and
100cm from the floor.
B. Alternatively, place it
over the edge of a basin,
sink or tub, fastening the
hose supplied to the tap.
The free end of the hose should not be under water.
! We advise against the use of hose extensions. In
case of absolute need, the extension must have the
same diameter as the original hose and must not
exceed 150cm in length.
Electrical connections
Before plugging the appliance into the mains socket,
make sure that:
• the socket is earthed and in compliance with the
applicable law.
• the socket is able to sustain the appliances
maximum power load indicated in the Technical
Details table (on the right).
• the supply voltage is included within the values
indicated in the Technical Details table (on the right).
• the socket is compatible with the washing machines
plug. If this is not the case, replace the socket or
the plug.
! The washing machine should not be installed in an
outdoor environment, not even when the area is
sheltered, because it may be very dangerous to leave
it exposed to rain and thunderstorms.
! When the washing machine is installed, the mains
socket must be within easy reach and should be
connected to a suitable electrical supply.
! Do not use extensions or multiple sockets.
! The power supply cable must never be bent or
dangerously compressed.
! The power supply cable must only be replaced by an
authorised serviceman.
! The company denies all liability if and when these
norms are not respected.
The first wash cycle
Once the appliance has been installed and before you
use it for the first time, run a wash cycle without
detergent and no laundry, setting the 90°C
programme without a pre-wash cycle.
B
A
TECHNICAL DETAILS
Model WIXXL 86
Dimensions
59.5 cm wide
85 cm high
52.5 cm deep
Capacity from 1 to 7 kg
Electric
connections
voltage 220 - 240 volts 50 Hz
absorbed power 1700 – 2100 W
Water
connection
maximum pressure 1 MPa (10 bar)
minimum pressure 0,05 MPa (0,5 bar)
drum capacity 53 litres
Spin speed up to 800 rpm
Control
programmes
according to
the IEC456
directive
programme 2 with temperature set to
60°C run with a load of 7 kg.
This appliance is compliant with the
following European Community
directives:
- 73/23/CEE of 19/02/73 (Low Voltage)
and subsequent amendments
- 89/336/CEE of 03/05/89
(Electromagnetic Compatibility) and
subsequent amendments
Specyfikacje produktu
| Marka: | Indesit |
| Kategoria: | Pralki |
| Model: | WIXXL 86 (EU) |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Indesit WIXXL 86 (EU), zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Pralki Indesit
15 Stycznia 2025
14 Stycznia 2025
15 Października 2024
13 Października 2024
13 Października 2024
13 Października 2024
12 Października 2024
12 Października 2024
11 Października 2024
9 Sierpnia 2024
Instrukcje Pralki
- Pralki Bauknecht
- Pralki Samsung
- Pralki Electrolux
- Pralki DeLonghi
- Pralki AEG
- Pralki Balay
- Pralki Beko
- Pralki Teka
- Pralki LG
- Pralki Amica
- Pralki Gorenje
- Pralki Sharp
- Pralki Russell Hobbs
- Pralki Simpson
- Pralki Bosch
- Pralki Candy
- Pralki Whirlpool
- Pralki Miele
- Pralki Midea
- Pralki Lamona
- Pralki Hisense
- Pralki Infiniton
- Pralki Panasonic
- Pralki Baumatic
- Pralki Black & Decker
- Pralki OK
- Pralki Adler
- Pralki Hoover
- Pralki Toshiba
- Pralki Westinghouse
- Pralki Maytag
- Pralki Domo
- Pralki GE
- Pralki Brandt
- Pralki Siemens
- Pralki Haier
- Pralki Cylinda
- Pralki Hyundai
- Pralki Blomberg
- Pralki Fisher & Paykel
- Pralki Dyson
- Pralki Hotpoint
- Pralki Kenwood
- Pralki Thor
- Pralki Amana
- Pralki Hotpoint Ariston
- Pralki Bomann
- Pralki Stirling
- Pralki CDA
- Pralki Philco
- Pralki Neff
- Pralki Corbero
- Pralki Zanussi
- Pralki Fagor
- Pralki Koenic
- Pralki Ardo
- Pralki Manta
- Pralki Pyle
- Pralki KitchenAid
- Pralki Exquisit
- Pralki Arçelik
- Pralki Hanseatic
- Pralki Sanyo
- Pralki SVAN
- Pralki Caple
- Pralki AEG-Electrolux
- Pralki Bush
- Pralki New Pol
- Pralki Kenmore
- Pralki VOX
- Pralki Insignia
- Pralki Orima
- Pralki Kernau
- Pralki Hitachi
- Pralki Zerowatt
- Pralki Frigidaire
- Pralki RCA
- Pralki Kelvinator
- Pralki Gaggenau
- Pralki Avanti
- Pralki Asko
- Pralki Esatto
- Pralki Daewoo
- Pralki Scandomestic
- Pralki Ignis
- Pralki Magic Chef
- Pralki Constructa
- Pralki Euromaid
- Pralki Atlas
- Pralki Zanker
- Pralki Ariston
- Pralki Tricity Bendix
- Pralki Saturn
- Pralki Nordland
- Pralki Zanussi-electrolux
- Pralki Rasonic
- Pralki John Lewis
- Pralki Prima
- Pralki Mabe
- Pralki Iberna
- Pralki Logik
- Pralki Currys Essentials
- Pralki Alhafidh
- Pralki Hoover-Helkama
- Pralki Defy
- Pralki Servis
- Pralki Schulthess
- Pralki Marijnen
- Pralki Otsein-Hoover
- Pralki Campomatic
- Pralki Premium
- Pralki White Knight
- Pralki Nordmende
- Pralki Friac
- Pralki Dexter
- Pralki Costway
- Pralki Elba
- Pralki Everglades
- Pralki Saivod
- Pralki Freggia
- Pralki Edesa
- Pralki EAS Electric
- Pralki Lloyd
- Pralki Speed Queen
- Pralki WhiteLine
- Pralki Roper
- Pralki Estate
- Pralki Fram
- Pralki Stoves
- Pralki Edy
- Pralki Upo
- Pralki Trieste
- Pralki Videocon
- Pralki Neufunk
Najnowsze instrukcje dla Pralki
15 Stycznia 2025
15 Stycznia 2025
15 Stycznia 2025
15 Stycznia 2025
15 Stycznia 2025
14 Stycznia 2025
14 Stycznia 2025
14 Stycznia 2025
14 Stycznia 2025
14 Stycznia 2025