Instrukcja obsługi ICOM IC-2800H

ICOM odbiornik IC-2800H

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla ICOM IC-2800H (88 stron) w kategorii odbiornik. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/88
INSTRUCTION MANUAL
This device complies with Part 15 of the FCC rules. Operation is sub-
ject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
i2800H
DUAL BAND FM TRANSCEIVER
i
FOREWORD
READ ALL INSTRUCTIONS carefully and completely
before using the transceiver.
SAVE THIS INSTRUCTION MANUAL — This in-
struction manual contains important operating instructions for
the IC-2800H.
EXPLICIT DEFINITIONS
The explicit definitions below apply to this instruction manual.
CAUTIONS
RWARNING! NEVER connect the transceiver to an AC
outlet. This may pose a fire hazard or result in an electric
shock.
RWARNING! NEVER operate the transceiver while dri-
ving a vehicle. Safe driving requires your full attention—any-
thing less may result in an accident.
RWARNING! HIGH VOLTAGE! NEVER disassem-
ble the remote controller. There is a high voltage circuit in-
side.
NEVER connect the transceiver to a power source of more
than 16 V DC or using reverse polarity. This will ruin the trans-
ceiver.
NEVER cut the DC power cable between the DC plug and
fuse holder. If an incorrect connection is made after cutting,
the transceiver may be damaged.
NEVER place the transceiver where normal operation of the
vehicle may be hindered or where it could cause bodily injury.
NEVER let objects impede the operation of the cooling fan
on the rear panel.
DO NOT push the PTT when not actually desiring to trans-
mit.
WORD
R
WARNING
CAUTION
NOTE
DEFINITION
Personal injury, fire hazard or electric
shock may occur.
If disregarded, inconvenience only. No risk
of personal injury, fire or electric shock.
Equipment damage may occur.
Versions of the IC-2800H which display the “CE” symbol on the
serial number seal comply with the European harmonised stan-
dard ETS300 684 (EMC product standard for Commercially Avail-
able Amateur Radio Equipment).
ii
DO NOT operate the transceiver near unshielded electrical
blasting caps or in an explosive atmosphere.
During mobile operation, DO NOT operate the transceiver
without running the vehicle’s engine. When transceiver power
is ON and your vehicle’s engine is OFF, the vehicle’s battery
will soon become exhausted.
AVOID using or placing the transceiver in direct sunlight or
in areas with temperatures below –10°C (+14°F) or above
+60°C (+140°F).
AVOID the use of chemical agents such as benzine or al-
cohol when cleaning, as they can damage the transceiver’s
surfaces.
Place unit in a secure place to avoid inadvertent use by chil-
dren.
BE CAREFUL! The transceiver will become hot when op-
erating it continuously for long periods.
USE Icom microphones only (supplied or optional). Other
manufacturer’s microphones have different pin assignments
and may damage the transceiver if attached.
For LCD display
DO NOT press the LCD screen. Excessive pressure may
cause permanent damage to the LCD.
DO NOT tap or scratch the LCD using sharp objects.
BE CAREFUL when cleaning the LCD. Dust can easily
scratch the surface.
LCDs are produced using high-density manufacturing tech-
nology resulting in 99.98% active dots, however, up to 0.02%
of the dots may be non-active and/or continuously active. This
is normal and does not indicate LCD malfunction.
Uneven areas may be displayed depending on display con-
tents in some cases.
After displaying the same screen continuously for long peri-
ods, image ‘burn-in’ may occur. In such cases, turn the power
OFF and discontinue operation for at least 24 hours.
For U.S.A. only
CAUTION: Changes or modifications to this device, not ex-
pressly approved by Icom Inc., could void your authority to
operate this device under FCC regulations.

Specyfikacje produktu

Marka: ICOM
Kategoria: odbiornik
Model: IC-2800H

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z ICOM IC-2800H, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje odbiornik ICOM

ICOM

ICOM IC-4008E Instrukcja

5 Października 2024
ICOM

ICOM AT-140 Instrukcja

5 Października 2024
ICOM

ICOM IC-25H Instrukcja

5 Października 2024
ICOM

ICOM IC-M120 Instrukcja

29 Września 2024
ICOM

ICOM IC-502A Instrukcja

28 Września 2024
ICOM

ICOM IC-T7H Instrukcja

27 Września 2024
ICOM

ICOM i703 Instrukcja

26 Września 2024
ICOM

ICOM IC-M600E Instrukcja

22 Września 2024
ICOM

ICOM IC-PS25 Instrukcja

20 Września 2024
ICOM

ICOM IC-H12 Instrukcja

20 Września 2024

Instrukcje odbiornik

Najnowsze instrukcje dla odbiornik

Marantz

Marantz SR-8000 Instrukcja

15 Stycznia 2025
AKAI

AKAI AM-32 Instrukcja

15 Stycznia 2025
Peavey

Peavey CKd 608 Instrukcja

15 Stycznia 2025
OSD Audio

OSD Audio Nero HTX4150 Instrukcja

14 Stycznia 2025
S.M.S.L

S.M.S.L PA200 Instrukcja

14 Stycznia 2025
Pyle

Pyle PFMRA340BB.5 Instrukcja

13 Stycznia 2025
Wavtech

Wavtech link700.4plus Instrukcja

13 Stycznia 2025
Behringer

Behringer NU6000DSP Instrukcja

12 Stycznia 2025
Denon

Denon DRA-935R Instrukcja

12 Stycznia 2025
Kenwood

Kenwood KMM-BT508DAB Instrukcja

12 Stycznia 2025