Instrukcja obsługi Hotpoint HDA3600HWW

Hotpoint Pomywaczka HDA3600HWW

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hotpoint HDA3600HWW (32 stron) w kategorii Pomywaczka. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/32
READ CAREFULLY
KEEP THESE INSTRUCTIONS
CHECK THE FOLLOWING
Dishwasher is square and level at both the top and
bottom of the cabinet opening, with no twisting or
distortion of the tub or door.
All 4 legs of the dishwasher are firmly in contact with
the floor.
Drain hose is not pinched between the dishwasher
and adjacent cabinets or walls.
FOR YOUR SAFETY
Read and observe all WARNINGS and CAUTIONS
shown throughout these instructions.
While performing installations described in this
booklet, gloves, safety glasses or goggles should
be worn.
IMPORTANT – Observe all governing codes and
ordinances.
• Note to Installer – Be sure to leave these instructions
for the consumer’s and local inspector’s use.
• – Keep these instructions with Note to Consumer
your Owner’s Manual for future reference.
• – Installation of this dishwasher requires Skill Level
basic mechanical, electrical and plumbing skills.
Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the Warranty. See Warranty
information.
• . New installations Completion Time – 1 to 3 Hours
require more time than replacement installations.
IMPORTANT – The dishwasher MUST be installed to
allow for future removal from the enclosure if service is
required.
Care should be exercised when the appliance is installed
or removed,
to reduce the likelihood of damage to the
power supply cord.
If you received a damaged dishwasher, you should
immediately contact your dealer or builder.
Optional Accessories – See the Owner’s Manual for
available custom panel kits.
Your dishwasher is a water heating appliance.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
31-31587-2 02-19 GEA
• Remove all power leading to the appliance from the
circuit breaker or fuse box before beginning installation.
Failure to do so can result in a risk of electrical shock.
•
To reduce the risk of electric shock, fire, or injury to persons,
the installer must ensure that the dishwasher is completely
enclosed at the time of installation.
• The improper connection of the equipment grounding
conductor can result in a risk of electric shock. Check
with a qualified electrician or service representative
if you are in doubt that the appliance is properly
grounded. If house wiring is not 2-wire with ground, a
ground must be by the installer. When house wiring
is aluminum, be sure to use UL-Listed anti-oxidant
compound and aluminum-to-copper connectors.
•
To reduce the risk of electric shock, fire, or injury to
persons, the installer should check to ensure that wires are
not pinched or damaged, the house wiring is attached to the
junction box bracket through a strain relief, and all electrical
connections made at the time of install (wire nuts) are
contained inside of
the junction box cover.
WARNING
• Retire todos los conductores de corriente del
electrodoméstico de disyuntor o de la caja del fusible
antes de comenzar con la instalación. Si no cumple con
esto, se podrá producir el riesgo de descargas eléctricas.
• Para reducir el riesgo de descarga eléctrica, incendio
o lesiones a personas, el instalador debe asegurarse
de que el lavaplatos esté completamente cerrado en
el momento de la instalación.
• La conexión inadecuada del conductor de conexión a
tierra del equipamiento puede provocar un riesgo de
descarga eléctrica. Consulte a un electricista calificado
o representante de servicio técnico si tiene dudas
sobre la correcta conexión a tierra del aparato. Si el
cableado doméstico no cuenta con un cable de 2 hilos
con conexión a tierra, un instalador debe realizar una
conexión a tierra. Cuando el cableado doméstico es de
aluminio, asegúrese de usar un compuesto antioxidante
y conectores de aluminio a cobre aprobados por UL.
• Para reducir el riesgo de descarga eléctrica, incendio
o lesiones a personas, el instalador deberá realizar un
control para asegurar que los cables no estén pellizcados
ni dañados, que el cableado del hogar esté conectado a la
ficha de la caja de empalmes a través de un amortiguador
de refuerzo, y que todas las conexiones eléctricas
realizadas en el momento de la instalación (tuercas para
cables) estén dentro de la tapa de la caja de empalmes.
ADVERTENCIA
See your Owner’s Manual for details on how to contact us regarding installation questions
Built-In & Spacemaker®
Dishwashers
Installation
Instructions
PARTS SUPPLIED IN
INSTALLATION PACKAGE:
• Two 8-18 x 5/8” Phillips-head wood screws
• #10 hex head screw and junction box cover
• Drain hose (78” long)
• Hose clamp
• Literature, product samples and/or coupons
TOOLS YOU WILL NEED:
• Phillips-head screwdriver
• 1/4” and 5/16” nutdriver
• 6” Adjustable wrench
• Level
• Carpenter’s square
• Measuring tape
• Safety glasses
• Flashlight
• Bucket to catch water when flushing the line
• 15/16” socket (optional for skid removal)
• Gloves
• Pliers
For New Installations Only:
• Tubing cutter
• Drill and appropriate bits
• Hole saw set
MATERIALS YOU WILL NEED:
• WX09X70910 or WX09X70911 power cord if
applicable to your installation, or electrical cable
• UL-Listed wire nuts (3)
• Thread seal tape
• 90° elbow (¾” hose internal thread on one end,
opposite end sized to fit water supply)
• GPF65 Side-mount bracket kit for use with granite
countertops
For New Installations Only:
• Electrical cable
• Water line–3/8” minimum copper tubing (including
ferrule and compression nut)
• Strain relief for electrical connection
• Hand shut-off valve (recommended)
• Air gap for drain hose, if required
• Waste tee for house plumbing, if applicable
• GPF10S drain hose (10’ long), if needed
• Screw-type hose clamps
• Cord protector (power cord models only
as needed)
• Conversion leads (power cord models only
as needed)
Installation Preparation
2
Hole Saw Set
Measuring Tape
Tubing Cutter Drill and Bits
Phillips-Head
Screwdriver
15/16” Socket
1/4” and 5/16”
Nutdriver
Bucket
Flashlight
Gloves
Carpenter’s
Square
Safety Glasses
Level
Pliers
6” Adjustable
Wrench
78" Drain Hose
#8
Phillips-Head
Wood Screws
5/8" long
Screw Kit
#10
Hex Head
Junction Box Screw
1/2" long
Cord Protector
- Optional -
(Power Cord
Models Only)
Conversion Leads
WD21X10107
- Optional -
(Power Cord
Models Only)
Thread
Seal Tape
3 Wire Nuts
Hot Water Line–3/8"
Minimum Copper Tubing
Electrical Cable
or WR09X70910 or
WX09X70911 Power Cord
Screw-Type
Hose Clamps
Strain Relief Shut-Off
Valve
GPF65 Side-Mount
Bracket Kit
Optional 10'
Drain Hose
GPF10S
Waste Tee
Coupler for optional
drain hose
90° Elbow
Air
Gap
Hose Clamp Literature
Junction
Box Cover
CLEARANCES:
• When installed into a
corner, allow 2” min.
clearance between
dishwasher and adjacent
cabinet, wall or other
appliances.
• Allow 27” min. clearance
from the front of the
dishwasher for door
opening.
3
Countertop
27"
Dishwasher
Clearance for Door
Opening 2” Minimum
Installation Preparation
To reduce the risk of electric shock, fire, or injury to
persons, the installer must ensure that the dishwasher
is completely enclosed at the time of installation.
WARNING Para reducir el riesgo de
descarga eléctrica, incendio
o lesiones a personas, el instalador debe asegurarse
de que el lavaplatos esté completamente cerrado en
el momento de la instalación.
ADVERTENCIA
PREPARE DISHWASHER ENCLOSURE
Built-In Models Only: Spacemaker® Models Only:
• The rough cabinet opening must be at least 24” deep,
24” wide and approximately 34-1/2” ± 1/4” high from
floor to underside of the countertop.
• The dishwasher must be installed so that drain hose is
no more than 10’ in length for proper drainage.
• The dishwasher must be fully enclosed on the top, sides
and back, and must not support any part of the enclosure.
• The back wall should be free of pipes or wires.
• Adjacent cabinets should be square and plumb to
ensure a good fit.
• Make sure the floor is level inside the opening and
even with the finished floor of the kitchen. This will
facilitate removal of the dishwasher at a later date for
service, if needed.
Min.
Min.
• The rough cabinet opening must be at least 24” deep,
24” wide and approximately 34-1/4” ± 1/4” height.
• This dishwasher fits under a special sink with a depth
of 6” or less in a 1-1/2” countertop.
• The dishwasher must be installed so that drain hose is
no more than 10’ in length for proper drainage.
• The dishwasher must be fully enclosed on the top, sides
and back, and must not support any part of the enclosure.
• The back wall should be free of pipes or wires.
• Water line to
sink faucet
and drain from
sink can be run
through Area
“A.”
• Hot water line
to dishwasher
is installed in
Area “B.”
• Garbage
disposer, water
lines to faucet,
waste trap, air
gap and water
shut-off valve
are installed in
a 12” wide cabinet, Area “C”.
• Sink opening for garbage disposer must be dimensioned
as shown (7-1/2”) in Area “C.” This will provide clearance
for disposer and plumbing in Area “C” when using either
single or double bowl sink.
• Adjacent cabinets should be square and plumb to
ensure a good fit.
NOTE: A gap between the dishwasher tub front flange and
the front of the base cabinet may result due to either the
cabinet being less than 24” deep or the sink bowl not being
installed to specifications. If the gap is more than 3/4”, the
sink bowl must be relocated to meet specified dimensions.
Cabinet Side
Adjacent to Dishwasher
Sink
Installation
Cutout
8" X 20"
Adjacent Cabinet
Rear Cutout
12"
3-1/4"
12-1/2"
24”
min
24” min
5"
C
5"
7-1/2"7-1/2"
Dishwasher
Side View
11-3/4" Max.
Plumbing
4"
Max.
34-1/4"
1/4"
+_
10-1/4" MA .
PLUMBING
DEPTH
1" Max. To
Sink Flange
20-1/2" Max.
Sink Bowl
11" Min.
Drain
6" Max.
3/4" Min.
1-1/4"
1-1/2"
Close Elbow
Min. I.R.
24" Min.
Cabinet
Wall
B
A
X

Specyfikacje produktu

Marka: Hotpoint
Kategoria: Pomywaczka
Model: HDA3600HWW

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Hotpoint HDA3600HWW, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Pomywaczka Hotpoint

Hotpoint

Hotpoint HA3FC10BS7A0S Instrukcja

8 Stycznia 2025
Hotpoint

Hotpoint HSFO 3T223 WC X Instrukcja

12 Grudnia 2024
Hotpoint

Hotpoint HI 5030 WEF Instrukcja

12 Grudnia 2024
Hotpoint

Hotpoint HFO 3O32 CW X Instrukcja

12 Grudnia 2024
Hotpoint

Hotpoint HIC 3C26N WF Instrukcja

12 Grudnia 2024
Hotpoint

Hotpoint HIC 3C26 CW Instrukcja

12 Grudnia 2024
Hotpoint

Hotpoint HIE 2B19 C N Instrukcja

12 Grudnia 2024
Hotpoint

Hotpoint HSFC 3T127 C Instrukcja

12 Grudnia 2024
Hotpoint

Hotpoint HB 4010 B Instrukcja

12 Grudnia 2024
Hotpoint

Hotpoint HFC 3T232 WG Instrukcja

12 Grudnia 2024

Instrukcje Pomywaczka

Najnowsze instrukcje dla Pomywaczka

AEG

AEG F88080IA Instrukcja

15 Stycznia 2025
Candy

Candy CI 7300 Instrukcja

15 Stycznia 2025
Miele

Miele G 1220 SC Instrukcja

15 Stycznia 2025
Inventum

Inventum VVW7020 Instrukcja

15 Stycznia 2025
AEG

AEG F56322W0 Instrukcja

15 Stycznia 2025
AEG

AEG FFB52600ZM Instrukcja

15 Stycznia 2025
AEG

AEG F55000W0 Instrukcja

15 Stycznia 2025
Indesit

Indesit idl 600 Instrukcja

15 Stycznia 2025
Atag

Atag VA2013RT Instrukcja

15 Stycznia 2025
Atag

Atag VA8017SRT Instrukcja

15 Stycznia 2025