Instrukcja obsługi Hotpoint Ariston ECOT7F 1292 EU

Hotpoint Ariston pralka ECOT7F 1292 EU

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hotpoint Ariston ECOT7F 1292 EU (84 stron) w kategorii pralka. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/84
GB
1
Contents
Installation, 2-3
Unpacking and levelling
Connecting the electricity and water supplies
The first wash cycle
Technical data
Care and maintenance, 4
Cutting off the water or electricity supply
Cleaning the washing machine
Caring for your appliance door and drum
Cleaning the pump
Checking the water inlet hose
How to clean the detergent dispenser
Precautions and tips, 5
General safety
Disposal
Saving energy and respecting the environment
Description of the washing machine
and starting a wash cycle, 6-7
Control panel
Indicator lights
How to open and shut the drum
Starting a wash cycle
Wash cycles, 8
Table of wash cycles
Personalisation, 9
Setting the temperature
Setting the spin speed
Functions
Detergents and laundry, 10
Detergent dispenser drawer
Bleach cycle
Preparing the laundry
Garments requiring special care
Load balancing system
Troubleshooting, 11
Service, 12
ECOT7F 1292
Instructions for use
WASHING MACHINE
English,1
GB F
Français,13
IT
ES CIS
UK
GR
Українська,73
Italiano,25
Español,37 Ελληνικά,49 Русский,61
2
GB
Installation
! Keep this instruction manual in a safe place for
future reference. Should the appliance be sold,
transferred or moved, make sure the instruction
manual accompanies the washing machine to
inform the new owner as to its operation and
features.
! Read these instructions carefully: they contain
vital information on installation, use and safety.
Unpacking and levelling
Unpacking
1. Unpack the washing machine.
2. Check whether the washing machine has
been damaged during transport. If this is the
case, do not install it and contact your retailer.
3. Remove the four
protective screws and
the rubber washer with
the respective spacer,
situated on the rear
of the appliance (see
figure).
4. Seal the gaps using
the plastic plugs provi-
ded.
5. Keep all the parts:
you will need them
again if the washing
machine needs to be
moved to another lo-
cation.
Warning: should the screws be re-used, make
sure you fasten the shorter ones at the top.
! Packaging materials are not children’s toys.
Levelling
1. Install the washing machine on a flat sturdy
floor, without resting it up against walls, furniture
cabinets or other.
2. If the floor is not per-
fectly level, compensa-
te for any unevenness
by tightening or loo-
sening the adjustable
front feet ; (see figure)
the angle of inclination,
measured according to
the worktop, must not
exceed 2°.
Levelling your appliance correctly will provide it
with stability and avoid any vibrations, noise and
shifting during operation.
If it is placed on a fitted or loose carpet, adjust
the feet in such a way as to allow enough room
for ventilation beneath the washing machine.
Electric and water connections
Connecting the water inlet hose
1. Connect the supply
pipe by screwing it to
a cold water tab using
a ¾ gas threaded con-
nection (see figure).
Before performing the
connection, allow the
water to run freely until
it is perfectly clear.
2. Connect the other
end of the water inlet
hose to the washing
machine,
screwing it onto the ap-
pliance’s cold water in-
let, situated on the top
right-hand side on the
rear of the appliance
(see figure).
3. Make sure there are no kinks or bends in the
hose.
! The water pressure at the tap must be within
the values indicated in the Technical details
table .(on the next page)
! If the water inlet hose is not long enough,
contact a specialist store or an authorised
serviceman.
! Never use hoses that have already been used.
GB
3
Technical details
Model ECOT7F 1292
Dimensions
40 cm wide
85 cm high
60 cm deep
Capacity from 1 to 7 kg
Electric
connections
Please refer to the technical
data plate fixed to the ma-
chine.
Water
connections
maximum pressure 1 MPa
(10 bar) minimum pressure
0.05 MPa (0.5 bar) drum
capacity 42 litres
Spin speed up to 1200 rpm
Test wash
cycles in
accordan-
ce with
directives
1061/2010
and
1015/2010.
Programme 2:
Cotton standard 60°C;
Programme 3:
Cotton standard 40°C.
This appliance is compliant
with the following European
Community Directives:
- 2004/108/CE (Electroma-
gnetic Compatibility)
- 2006/95/CE (Low Voltage)
- 2012/19/EU
Connecting the drain hose
Connect the drain
hose, without bending
it, to a drainage duct
or a wall drain located
at a height between
65 and 100 cm from
the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct sup-
plied to the tap (see
figure). The free end
of the hose should
not be underwater.
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity
socket, make sure that:
the socket is earthed and complies with all
applicable laws;
the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
the power supply voltage falls within the va-
lues indicated in the Technical data table (see
opposite);
the socket is compatible with the plug of the
washing machine. If this is not the case, repla-
ce the socket or the plug.
! The washing machine must not be installed
outdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washing machine has been installed,
the electricity socket must be within easy reach.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held respon-
sible in the event that these regulations are not
respected.
The first wash cycle
Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using the
wash cycle .2
65 - 100 cm


Specyfikacje produktu

Marka: Hotpoint Ariston
Kategoria: pralka
Model: ECOT7F 1292 EU
Kolor produktu: Biały
Typ kontroli: Buttons, Rotary
Wbudowany wyświetlacz: Tak
Położenie urządzenia: Wolnostojący
Wysokość produktu: 850 mm
Szerokość produktu: 400 mm
Głębokość produktu: 600 mm
Kolor drzwiczek: Biały
Opóźniony start czasomierza: Tak
Opóźniony start: 24 h
Pobór wody na cykl: - l
Tryb wyłączenia: 1 W
Zabezpieczenie przed dziećmi: Tak
Klasa efektywności energetycznej (stara): A++
Pranie zużywające energię: 1.143 kWh
Typ ładowania: Od góry
Zawias drzwiczek: W górę
Kategoria prania: A
Pojemność znamionowa: 7 kg
Maksymalna prędkość obrotu: 1200 RPM
Klasa wirowania (suszenia): B
Poziom hałasu (pranie): 61 dB
Pozostała wilgoć: 53 %
Poziom hałasu (wirowanie): 74 dB
Programy prania: Hygiene/anti-allergy, Black, Blouse/shirt, Cotton, Hand/wool, Mix, Quick, Synthetics, Delicate/silk
Czas cyklu (max): 195 min
Regulowana prędkość obrotów: Tak
Zabezpieczenie przed przepełnieniem: Tak
Roczne zużycie energii pranie: 197 kWh
Roczne zużycie wody pranie: 9029 l
Czas cyklu (program szybki): 30 min

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Hotpoint Ariston ECOT7F 1292 EU, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje pralka Hotpoint Ariston

Instrukcje pralka

Najnowsze instrukcje dla pralka