Instrukcja obsługi Honeywell F300E1019

Honeywell Niesklasyfikowane F300E1019

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Honeywell F300E1019 (6 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/6

OWNER’S GUIDE

69-0756-07

F50F and F300E Electronic

Air Cleaners

CONTENTS

Operating Your Electronic Air Cleaner ....................... 2

Getting the Most From Your Electronic Air Cleaner 2

Cleaning Prefilter(s), Cell(s) and Postfilter(s) ......... 3

How Electronic Air Cleaning Works ............................. 5

Before You Call for Service .............................................. 6

Resideo 10 Year Ultraclean Coil Guarantee™ .......... 6

Limited Five-year Warranty ............................................ 7

Product Registration ......................................................... 8

M38810

F50F AND F300E ELECTRONIC AIR CLEANERS

3 69-0756—07

CLEANING PREFILTER(S),

CELL(S) AND POSTFILTER(S)

CAUTION

Sharp edges.

Can cause personal injury.

Carefully handle cell(s) or wear protective gloves to

avoid cuts from sharp metal edges.

Setting a regular cleaning schedule

To ensure optimum performance from the air cleaner, the

prefilter(s) and cell(s) must be cleaned regularly— twice a

year with normal use or more frequently with heavy use.

Use the wash reminder schedule below to help establish

and maintain a regular cleaning schedule. Mount the

wash reminder schedule in a convenient location.

NOTE: You may let the heating or air conditioning sys-

tem operate normally while the cell(s) are being

washed. Simply turn off the air cleaner switch.

Cleaning your Prefilter

1. The quickest and easiest way to clean your prefilter

is to use the brush attachment of your vacuum

cleaner to vacuum the lint off the dirty side of the

prefilter. Greasy dirt may require soaking the prefilter

in a tub or rinsing with the garden hose. Do not wash

the prefilter in the dishwasher or car wash

2. The prefilter should be cleaned every 6 months or

more frequently with heavy use. This will keep the

prefilter clean of air choking lint that can make your

system work harder.

Vacuum the prefilter with a brush attachment, rinse it with

a hose, or soak it in a tub. Do wash the prefilter(s) in not

the dishwasher or car wash.

Cleaning your Cells

1. A quick cleaning of the cells can be done by simply

wiping down the ionizer wires with a damp cloth.

This will help boost the efficiency of the air cleaner

between full cleaning cycles. Ths quick clean can be

done every time the prefilters are cleaned.

2. A full cleaning of the cells will return the air cleaner

to its peak efficiency. An easy way to wash the cells is

in a tub of hot, soapy water. Just soak the cells until

the water cools, agitate and rinse. For details on

cleaning cells, see below for Washing the cell(s) in a

tub or Washing the cell(s) in your automatic dish-

washer.

3. Because the efficiency of the air cleaner remains

high even as it loads up with dirt, a full cleaning of

the cells can be put off for yearly maintenance and a

quick cleaning can be done more often. Those wish-

ing to renew to peak efficiency or with heavier use

may want to wash more frequently.

Replacing your Postfilter

1. The postfilter is an optional filter that boosts the effi-

ciency of the air cleaner. Do not wash the postfilter

because that will neutralize the factory applied

charge.

2. The postfilter should be replaced every six months to

ensure peak performance.

ELE

M982A

JJA

S O

N D

TIO

F50F AND F300E ELECTRONIC AIR CLEANERS

69-0756—07 4

CAUTION

Burn Hazard.

Can cause personal injury.

Allow cell(s) to cool completely in dishwasher and

at tend of wash cycle or wear protective gloves.

Washing the cell(s) in your automatic

dishwasher

Hot water can accumulate in the tubes supporting the

collector plates.Tip the cell(s) so these tubes can drain.

IMPORTANT

• Check your dishwasher Owner’s manual. Some

manufacturers do not recommend washing elec-

tronic cell(s) in their dishwashers.

• If the dishwasher has upper and lower arms, posi-

tion the cell(s) carefully to allow good water circu-

lation.

• Be careful to avoid damaging the cell(s) when

placing them in the dishwasher. Broken ionizer

wires or bent collector plates are not covered

under the Warranty.

• Very dirty cell(s), especially from tobacco or cook-

ing smoke, can discolor the plastic parts and the

lining of some dishwashers.This discoloration is

not harmful. To minimize it, wash the cell(s) more

frequently or try a different brand of detergent.

• Do NOT allow the dishwasher to run through the

dry cycle. This bakes on any contaminants not

removed during the wash cycle and reduces air

cleaner efficiency.

1. Put the cell(s) on the lower rack of the dishwasher

with the airflow arrow pointing up. It may be neces-

sary to remove the upper rack. Do not block water

flow to the upper arm.

HINT: Lay a few large water glasses between the spikes on

the lower rack, and rest the cell(s) on them so the spikes do

not damage the aluminum collector blades.

2. Using your regular dishwashing detergent, allow the

dishwasher to run through the complete wash and

rinse cycle. Do not use the dry cycle. To avoid burns,

let the cell(s) cool completely before removing, or

wear protective gloves when removing the cell(s).

Remember that water may be trapped inside the

cell(s) plates. Tip the cell(s) so these tubes can drain.

3. Wipe the ionizer wires and contact board on the end

of the cell using your thumb and forefinger with a

small, damp cloth.

4. Inspect the dishwasher. You may want to rerun the

wash and/or rinse cycle with the dishwasher empty if

you see dirt or residue from washing the cell(s). If

dirt or residue seems excessive, wash the cell(s)

more often or try a different detergent.

CAUTION

Hazardous Chemical.

Can cause personal injury.

Do not splash detergent solution in eyes.

Washing the cell(s) in a tub

• Wear rubber gloves to avoid prolonged detergent

contact with your skin.

• Keep detergent and solution out of reach

of children.

NOTE: Always wash the cell(s) first, then the prefilter(s),

to keep heavy prefilter lint from getting caught in

the cell(s).

1. Use a large enough container, such as a laundry tub

or trash container, to hold one or both cell(s).

NOTE: Sharp corners on the cell(s) can scratch the sur-

face of a bathtub.

2. Dissolve about three-fourth cup of automatic dish-

washer detergent per cell in enough hot water to

cover the cell(s). If the detergent does not dissolve

readily, or forms a scum on the water, try another

brand, or use softened water.

3. After the detergent has completely dissolved, place

the cell(s) in the container and allow to soak for 15 to

20 minutes or until water cools. Agitate them up and

down a few times and remove. Repeat steps 2 and 3,

if necessary, for very dirty cells.

4. Next, wash the prefilter(s) the same way. Empty and

rinse the wash container.

5. Rinse the cell(s) with a hard spray of very hot water;

rinse the tub clean, then fill the tub with clean hot

water and soak for 5 to 15 minutes. Rinse until the

water draining from the cell(s) and prefilter(s) no

longer feels slippery.

6. Soak cell(s) in a final clear water rinse for ten min-

utes.

7. Wipe the ionizer wires and contact board on the end

of the cell using your thumb and forefinger with a

small, damp cloth.

Replacing electronic air cleaner

components

1. Inspect the cell(s) for broken ionizer wires and bent

collector plates. Repair, as necessary, or call your

contractor for service.

2. Slide the prefilter(s) into the upstream prefilter

guides.

3. Slide the air cleaner cell(s) in so the air flow arrow

points downstream and the handle(s) face outward.

4. Firmly close the access door.

5. Turn on the air cleaner. If the cell(s) and prefilter(s)

are wet, the neon light may not come on and you

may hear arcing. If the arcing is annoying, simply

turn the air cleaner off for two to three hours or until

the cell(s) are dry.

Specyfikacje produktu

Marka:	Honeywell
Kategoria:	Niesklasyfikowane
Model:	F300E1019

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Honeywell F300E1019, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Niesklasyfikowane Honeywell

Honeywell TrueZONE HZ432 Instrukcja

15 Września 2024

Honeywell Evohome HR92WE Instrukcja

11 Września 2024

Honeywell EvoHome THR99C3102 Instrukcja

3 Września 2024

Honeywell RCHSIMV1 Instrukcja

2 Września 2024

Honeywell F300E1019 Instrukcja

31 Sierpnia 2024

Honeywell 32003796-001 Instrukcja

28 Sierpnia 2024

Honeywell F100F1620/U Instrukcja

27 Sierpnia 2024

Honeywell QuietSet HY254E Instrukcja

20 Sierpnia 2024

Honeywell AQ25542B Instrukcja

13 Sierpnia 2024

Honeywell TrueZONE HZ322 Instrukcja

3 Lipca 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024

Stihl HT 70 Instrukcja

15 Października 2024

Ernesto H14270 Instrukcja

15 Października 2024

Uniden BT MIC KIT Instrukcja

15 Października 2024

Vaude Omnis Bike 26 Instrukcja

15 Października 2024

ART ProChannel II Instrukcja

15 Października 2024

Aukey DR02J Instrukcja

15 Października 2024

Master Lock 653EURD Instrukcja

15 Października 2024

Roland FR-18 Diatonic Instrukcja

15 Października 2024