Instrukcja obsługi Hikvision DS-2CE16U7T-IT3F

Hikvision Kamera monitorująca DS-2CE16U7T-IT3F

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hikvision DS-2CE16U7T-IT3F (13 stron) w kategorii Kamera monitorująca. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/13
TURBO HD
U7T Series Bullet Camera
User Manual
User Manual
Thank you for purchasing our product. If there are any
questions, or requests, do not hesitate to contact the
dealer.
This manual applies to the models below:
Type
Model
Type I Camera
DS- - 2CE16U7T ITF
Type CameraII
DS- - 2CE16U7T IT3F
DS- - 2CE16U7T IT5F
This manual may contain several technical incorrect
places or prinng errors, and the content is subject to
change without noce. The updates will be added to
the new version of this manual. We will readily improve
or update the products or procedures described in the
manual.
0100001081124
Regulatory Informaon
FCC Informaon
Please take attenon that changes or modicaon not
expressly approved by the party responsible for
compliance could void the user’s authority to operate
the equipment.
FCC compliance: This equipment has been tested and
found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protecon
against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instrucon manual, may cause harmful interference to
radio communicaons. Operaon of this equipment in a
residenal area is likely to cause harmful interference in
which case the user will be required to correct the
interference at his own expense.
FCC Condions
This device complies with part 15 of the FCC Rules.
Operaon is subject to the following two condions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operaon.
EU Conformity Statement
This product and if applicable the - -
supplied accessories too are marked with
"CE" and comply therefore with the
applicable harmonized European
standards listed under the Low Voltage Direcve
20 /35/EU, the EMC Direcve 201 30/EU.14 4/
20 2/1 19/EU (WEEE directive): Products
marked with this symbol cannot be
disposed of as unsorted municipal waste in
the European Union. For proper recycling,
return this product to your local supplier
upon the purchase of equivalent new
equipment, or dispose of it at designated collecon
points. For more informaon see: www.recyclethis.info.
2006/66/EC (baery direcve): This
product contains a baery that cannot be
disposed of as unsorted municipal waste in
the European Union. See the product
documentaon for specic battery
informaon. The battery is marked with this symbol,
which may include leering to indicate cadmium (Cd),
lead (Pb), or mercury (Hg). For proper recycling, return
the baery to your supplier or to a designated
collecon point. For more informaon see, :
www.recyclethis.info.
Industry Canada ICES 003 Compliance-
This device meets the CAN ICES 3 (A)/NMB 3(A) - -
standards requirements.
Warning
This is a class A product. In a domesc environment this
product may cause radio interference in which case the
user may be required to take adequate measures.
Safety Instrucon
These instrucons are intended to ensure that user can
use the product correctly to avoid danger or property
loss.
The precauon measure is divided into “Warnings” and
“Cauons”.
Warnings: Serious injury or death may occur if any of
the warnings are neglected.
Cauons: Injury or equipment damage may occur if any
of the cauons are neglected.
Warnings
In the use of the device, you must be in strict
compliance with the electrical safety regulaons of
the naon and region.
Input voltage should meet both the SELV (Safety Extra
Low Voltage) and the Limited Power Source with 12
VDC according to the IEC60950 1 standard. Refer to -
technical specicaons for detailed informaon.
Do not connect mulple devices to one power
adapter to avoid over heang or a re hazard caused -
by overload.
Make sure that the plug is rmly connected to the
power socket.
Make sure that the device is rmly fixed if wall
mounng or ceiling mounng is adopted.
If smoke, odor or noise rise from the device, turn off
the power at once and unplug the power cord, and
then contact the service center.
Never attempt to disassemble the camera by
unprofessional personal.
Cauons
Do not drop the camera or subject it to physical
shock.
Do not place the camera in extremely hot, cold (the
operang temperature shall be °C to 60°C), dusty -40
or damp locaons, and do not expose it to high
electromagnetic radiation.
Do not touch senor modules with ngers.
If cleaning is necessary, use clean cloth with a bit of
ethanol and wipe it gently.
Do not aim the camera at the sun or extra bright
places.
The sensor may be burned out by a laser beam, so
when any laser equipment is in using, make sure that
the surface of sensor will not be exposed to the laser
beam.
Do not expose the device to high electromagnec
radiaon or extremely hot, cold, dusty or damp
environment.
To avoid heat accumulation, good ventilaon is
required for the operang environment.
Warnings Follow
these safeguards to
prevent serious injury
or death.
Cauons Follow these
precauons to prevent
potenal injury or
material damage.

Specyfikacje produktu

Marka: Hikvision
Kategoria: Kamera monitorująca
Model: DS-2CE16U7T-IT3F

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Hikvision DS-2CE16U7T-IT3F, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Kamera monitorująca Hikvision

Hikvision

Hikvision DS-2TD2637-15 Instrukcja

8 Grudnia 2024
Hikvision

Hikvision DS-2CE56D5T-AIRZ Instrukcja

15 Października 2024
Hikvision

Hikvision DS-2TD2137-7/VP Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2DE7A245IX-AE/S1 Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2TD2166-15/V1 Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2CD2325FWD-I Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2CD2323G2-IU Instrukcja

12 Października 2024
Hikvision

Hikvision DS-2CD2326G2-IU Instrukcja

12 Października 2024
Hikvision

Hikvision DS-2TD6267-100C4L Instrukcja

12 Października 2024
Hikvision

Hikvision DS-2CD7A26G0-IZ(H)SY Instrukcja

11 Października 2024

Instrukcje Kamera monitorująca

Najnowsze instrukcje dla Kamera monitorująca

I-PRO

I-PRO WV-U2542LA Instrukcja

11 Grudnia 2024
I-PRO

I-PRO B-200-PTZ Instrukcja

11 Grudnia 2024
I-PRO

I-PRO WV-U2130LA Instrukcja

11 Grudnia 2024
ClearOne

ClearOne Unite 260 Pro Instrukcja

11 Grudnia 2024
I-PRO

I-PRO WV-X35402-F2LM Instrukcja

11 Grudnia 2024
Imou

Imou Cubo1 Instrukcja

11 Grudnia 2024
Foscam

Foscam PD5 Instrukcja

10 Grudnia 2024
TP-Link

TP-Link InSight S245 Instrukcja

10 Grudnia 2024
Foscam

Foscam R8M Instrukcja

10 Grudnia 2024
AViPAS

AViPAS AV-2000W Instrukcja

10 Grudnia 2024