Instrukcja obsługi Heatmiser DS-SB

Heatmiser termostat DS-SB

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Heatmiser DS-SB (4 stron) w kategorii termostat. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/4

Wiring Diagram

UH3

L N

1 2

SL RT+ RT-

DS-SB

IN ORDER TO AVOID ANY RISK OF ELECTRIC SHOCK, TURN OFF THE POWER TO THE HEATING

SYSTEM BEFORE COMMENCING INSTALLATION.

1. Separate the front part of the thermostat by placing a small at head

terminal driver into the slots on the bottom face of the thermostat.

2. Terminate the thermostat as shown in the wiring diagram.

3. Screw the back plate securely back onto the wall.

4. Clip the front part of the thermostat onto the back plate and turn the power back on.

The Heatmiser DS-SB is a ush mounted set-back thermostat and is ideal for those

who want a simple but energy ecient temperature control system. The DS-SB

features a set-back function. This function automatically reduces the set temperature

by 4°C when no time clock signal is detected.

The DS-SB thermostat has been designed to work in conjunction with the Heatmiser

UH3 wiring centre and TM4 Programmer, but can also be used as a standalone dial

thermostat.

The Heatmiser DS-SB provides the option to work with a remote temperature sensor.

When a compatible remote sensor is connected, the thermostat will automatically

switch from using it’s internal sensor to use the remote sensor instead. This function

is ideal for controlling bathrooms or when the thermostat needs to be installed in a

dierent area of the building to that being measured and controlled.

Want More Information?

Call our support team on:

+44 (0)1254 669090

Or view technical specications

directly on our website:

www.heatmiser.com

Introduction Installation

Remote Sensor

1 2

3 4

Model: DS-SB

PDF FAQ

To change the set point, rotate the dial until it points to the desired temperature. The Heatmiser DS-SB oers a set-back function that automatically reduces the set

temperature by 4°C.

To make use of the set-back function, a 230v time clock is also required on the system.

Place the thermostat slide switch into the time clock position.

When the thermostat receives a 230V signal from the time clock it will control the

temperature according to the dial setting.

When no 230v signal is received from the time clock, the thermostat will operate in set-

back mode and automatically reducing the set temperature by 4°C

Setting The Temperature Set-back Operation

Set-back Mode Position

Left LED

The left LED is the power LED. It is a two colour LED and is used to indicate the

time clock / set-back status.