Instrukcja obsługi GoldAir GCT430


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla GoldAir GCT430 (5 stron) w kategorii Podgrzewacz. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/5
Operating Instructions
Electronic Ceramic Tower Heater
Model: GCT430
Thank you for choosing a Goldair Ceramic Fan Heater. This Goldair Heater has been
designed and manufactured standards engineering and with proper use andto high of
care, described this leaflet, will give you years useful service. Please readas in of
these instructions carefully.
General Care and Safety Guide
TECHNICAL SPECIFICATION
Model : GCTNo 430
Supply: -220 240 50VAC Hz
Wattage: W2000
1. onUse only the voltage specified the rating
label the appliance.of
2. atKeep all objects least 1 metre from the front,
sides rear the appliance. placeand of Do not
appliance close radiant source.to heat
3. not areas orDo operate in where petrol, paint
other flammable liquids used stored.are or
4. not orDo insert allow foreign objects enterto
any or asventilation exhaust opening, this may
cause electric shock, fire damage thean or to
appliance. sit the appliance.Do not on
5. notDo operate this appliance with a damaged
cord, plug after the appliance malfunctionsor or
has or anybeen dropped damaged in manner.
Return a qualified electrical person forto
examination, electrical service repair.or
6. This appliance intended for household useis
only for commercial industrial use.and not or
7. asUse this appliance only described thisin
manual. Any other use recommendedis not by
the manufacturer may cause fire, electricaland
shock injury.or
8. ofThe common cause overheating depositsis
of ordust fluff the appliance. Ensure thesein
deposits removed regularly unpluggingare by
the appliance vacuum cleaning the airand
vents grills.and
9. not onDo use abrasive cleaning products this
appliance. Clean with a damp cloth wet)(not
rinsed soapy water only. Always removein hot
plug from the mains supply before cleaning.
10. Do not connect the appliance mains supplyto
until completely assembled adjusted.and
11. andSwitch off use handle provided when
moving.
12. not up asDo operate with cord set coiled a heat
build likely, which could sufficientup is be to
become a hazard.
13. It is recommended that this heater pluggedis
directly into the wall socket. Power boards are
not rated supply power high wattageto to
appliances.
14. A correctly specified, undamaged extension
cord may used with this heater providedbe it is
used a safe manner.in
15. notDo remove plug from power socket until the
appliance switched off.has been
16. not byDo remove plug from power socket
pulling cord; always grip plug.
17. notAlways unplug appliance when in use.
18. not anyDo locate the heater directly below
power socket during operation.
19. not orDo twist, kink wrap the cord around the
appliance, this may cause the insulationas to
weaken and split. Always ensure that all cord
has been removed from cord storageany area
and is unrolled before use.
20. not byThis appliance is intended for use
persons (including children) with reduced
physical, sensory mental capabilities lackor or
of areexperience and knowledge, unless they
supervised have been given instructionor
concerning the use the appliance aof by
person responsible for their safety.
21. notDo use this appliance the immediatein
surrounds a bath, a shower, a swimmingof or
pool or notother liquids. The appliance must
be any immersed in liquids.
22. When the appliance has been unpacked,
check for transport damage ensure allif and
parts have been delivered. parts missingIf are
or hasthe appliance been damaged, contact
the Goldair Customer Services Team.
23. or notIf your appliance does not work, is
working properly, contact the place purchaseof
or the Goldair Customer Services Team.
Repair work the appliance unqualifiedon by
persons can cause serious risk the user.to
24. areThere no user serviceable parts installed in
the unit.
25. not orDo place the unit wardrobesin other
enclosed spaces this may cause fireas
hazards.
26. not orThis unit is supposed usedto be in
around locations where foodstuffs, works of art
or of are delicate articles science, etc stored.
27. Indoor use only.
28. Children should supervised ensure thatbe to
they play with the appliance.do not
29. on heatEnsure heater is a flat, stable, -
resistant surface.
30. do notIt is important that you cover this heater.
WARNING Keep all objects at least 1 metre from
the front, sides and rear of the appliance.
Note: When the heater is turned on for the first
time, it may release a slight, odour or smoke.
This odour or smoke is a normal occurrence
caused by the initial heating of the internal
heating elements and should not occur again.
OPERATION
Check that the Power Switch the back theat of
heater set the Off position before pluggingis to
the heater turning the mains supply.in and on
Turn the Power Switch the back the heaterat of
to the position. You will a .“I” hear beep
Press the Power button the control panelon to
turn the heater . The LED will display theon
current temperature begin blowroom and to out
air Heat mode.on Low
To turn the unit off, press the Power Button on
the control panel and then turn the Power Switch
at of the back the heater position.to “O”
Please note: the fan will continue evento run
though the elements have switched off. This is
normal.
THERMOSTAT
Press the arrow arrow down buttonsup or to
adjust the temperature your desired settingto
(from - ° . Once you have set the desired15 35 C)
temperature, the LED will display the room
temperature again and will rise the roomas
temperature increases.
Once the heater reaches the set temperature it
will cycle and off maintain the seton to
temperature.
MODE
Press Mode button once for High heat, twice for
Fan Only and a third time back Lowto go to
Heat.
For greater economy, use the High Heat setting
initially then switch the Heat setting.and to Low
For the and High Heat settings the fanLow
remains the same speed; only the elementat
changes create the greater/lesser output.to heat
Always choose a safe location for the heater, keeping mind the safetyin
precautions outlined. Ensure packaging has been removed from unitall the
before use. This appliance requires installation, should used solely no it be as
a portable appliance.
OSCILLATION
The button turns the heater oscillation“OSC”
function off.on and
TIMER
The timer function allows you set the lengthto of
operation time before the unit shuts Off.
When the heater , press the Timer button.is On
The timer icon will display the control panelon
and ofthe amount time remaining before the unit
switches Off will displayed.be
Set the amount time before shutdownof by
pressing the Timer button one more times. Theor
set time will increase one hour increments aby to
maximum 9 .of hours
The control panel will return display the currentto
mode setting the symbol indicate you haveand to
set the timer will display the screen. When theon
programmed time been reached the heater willas
turn off.
To cancel the timer, increase the set time 9to
hours and then press the Timer button again. The
timer symbol will disappear from the screen.
REMOTE CONTROL
The remote control buttons perform the same
functions those the control the unit.as on panel of
For best results, aim the remote directly theat
remote sensor the front panel the heater.on of
The remote a 3 metre operation.has range of
The remote control requires two type batteryAA"
(not included).
IMPORTANT! NEVER COVER THIS HEATER!
CAUTION: The Heater generates heat during
use. Proper precautions must be taken to
prevent the risk of burns, scalds, fires or other
damage to persons.
Do not use this heater with a programmer,
remote-control system, separate timer or any
other device that switches the heater on
automatically.
Do not attempt to dismantle the heater. There are
no user serviceable parts. For service or repair,
contact an authorised electrical service
technician.
Operating your Ceramic Tower Heater


Specyfikacje produktu

Marka: GoldAir
Kategoria: Podgrzewacz
Model: GCT430

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z GoldAir GCT430, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Podgrzewacz GoldAir

GoldAir

GoldAir GHOR900 Instrukcja

1 Października 2024
GoldAir

GoldAir GFH340 Instrukcja

23 Września 2024
GoldAir

GoldAir GOC215 Instrukcja

22 Września 2024
GoldAir

GoldAir GCV125 Instrukcja

22 Września 2024
GoldAir

GoldAir GSFH150 Instrukcja

22 Września 2024
GoldAir

GoldAir GFH267 Instrukcja

22 Września 2024
GoldAir

GoldAir GFH260 Instrukcja

21 Września 2024
GoldAir

GoldAir GFH320 Instrukcja

21 Września 2024
GoldAir

GoldAir GIR180 Instrukcja

21 Września 2024

Instrukcje Podgrzewacz

Najnowsze instrukcje dla Podgrzewacz

Jotul

Jotul F 361 Instrukcja

15 Października 2024
Adler

Adler AD 7752 Instrukcja

15 Października 2024
MSW

MSW -TTEH-3000 Instrukcja

15 Października 2024
MSW

MSW IR-DRYER2000.2 Instrukcja

15 Października 2024
MSW

MSW IR-DRYER3000.1 Instrukcja

15 Października 2024
MSW

MSW IR-DRYER2000.1 Instrukcja

15 Października 2024
MSW

MSW IR-DRYER3000.2 Instrukcja

15 Października 2024
MSW

MSW -CHEH-3300 Instrukcja

15 Października 2024
MSW

MSW -CTEH-15000 Instrukcja

15 Października 2024