Instrukcja obsługi GE JSS26BDBB

GE piekarnik JSS26BDBB

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla GE JSS26BDBB (12 stron) w kategorii piekarnik. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/12
11
229C4053P557-2
31-10567-2 05-04 JR
Installation
30” Electric
Instructions Slide-In Range
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
•IMPORTANT — Save these
instructions for local inspector’s use.
•IMPORTANT — Observe all
governing codes and ordinances.
•Note to Installer – Be sure to leave these
instructions with the Consumer.
•Note to Consumer – Keep these
instructions for future reference.
•Skill level – Installation of this appliance
requires basic mechanical skills.
•Completion time – 1 to 3 hours
• Proper installation is the responsibility of
the installer.
• Product failure due to improper installation
is not covered under the Warranty.
WARNING — This appliance must
be properly grounded.
FOR YOUR SAFETY:
CAUTION: —For Personal Safety
remove house fuse or open circuit breaker
before beginning installation. Failure to do so
could result in serious injury or even death.
ANTI-TIP DEVICE
WARNING —To reduce the risk
of tipping, the appliance must be secured by
properly installed Anti-Tip bracket packed
with this appliance.
If the Anti-Tip device supplied with the range
does not fit this application, use the universal
Anti-Tip device WB2X7909.
WARNING —
• All ranges can tip
• Injury to persons could result
• Install Anti-Tip bracket packed
with range
• See Installation Instructions
If you pull the range out and away from the
wall for any reason, make sure the Anti-Tip
bracket is engaged when the range is pushed
back against the wall.
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com
2
Installation Instructions
FOR YOUR SAFETY:
All rough-in and spacing dimensions must be
met for safe use of your range. Electricity to
the range can be disconnected at the outlet
without moving the range if the outlet is in
the preferred location (remove lower drawer).
To reduce the risk of burns or fire when
reaching over hot surface elements, cabinet
storage space above the cooktop should be
avoided. If cabinet storage space is to be
provided above the cooktop, the risk can
be reduced by installing a range hood that
sticks out at least 5″beyond the front of the
cabinets. Cabinets installed above a cooktop
must be no deeper than 13″.
Be sure your appliance is properly installed
and grounded by a qualified technician.
PREPARE TO INSTALL THE RANGE
TOOLS YOU WILL NEED
Straight Edge
Drill with 1/8″Bit
Hand or Saber Saw
Pencil
Safety Glasses
Tape Measure
REMOVE SHIPPING MATERIALS
Remove all parts from the plastic bag found
inside the prepack of the oven and save
packaging tape.
1
ANTI-TIP DEVICE INSTALLATION
Before placing range in the counter, check the
factory location of the stability device on the
back of the range. For convenience you can
hook the stability chain in the upper set of
holes. Make sure there is no structural
interference when using the upper set of holes.
Decide on a location
that has no electrical
wiring or plumbing.
With the long screw
provided anchor the
chain to the floor or wall.
Make sure the
screw is going
into the wall plate
or stud at the
base of the wall
at least 3/4″.
Attach the stability chain so that it lines up
with the bracket on the back of the range.
Tug the chain to make sure it is securely
fastened.
Take the packaging
tape and temporarily
attach the loose end
of the chain to the
rear of the countertop.
Slide the range
into the counter
leaving enough
space behind to attach
the chain to the bracket.
G
F
E
D
C
B
A
2
Backguard (some models)
Mainback
Bracket Optional
Location
Chain
Chain
Chain
Long
Screw
Washer
Tape
Wall
Plate
Washer
and
Screw
Bracket Factory
Location
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Chain
MINIMUM CLEARANCES (CONT.)
MINIMUM DIMENSIONS BETWEEN
COOKTOP AND CABINETS OR WALLS
Electrical Outlet Area
(Back of counter in cutout not shown for clarity)
• The distance from the floor to the top
of the counter must be at least 35-7/8″.
The maximum countertop height is 38″.
Make sure the wall coverings, countertop and
cabinets around the cooktop can withstand
the heat (up to 200°F) generated by the range.
NOTE: Dimension for Wall to Front of Door
Handle (door closed).
*28″FOR MODELS – JSP26, JSS26, JSC26,
JSS16, RS734, RS504
**28-1/2″FOR MODELS – JSP39, JSP38, JSP31,
JSP28, RS744, RS622, JS960, JSP40, JSP34
3
3
Installation Instructions
MINIMUM CLEARANCES
• The distance from the floor to the top
of the counter must be at least 35-7/8″.
The maximum counter height is 38″.
•30″ranges conform to U.L. requirements
for 0″spacing from vertical walls above
countertops. However, some kitchen cabinet
finishes can be damaged by heat from the
range surface elements. Where varnished
wood or plastic film finishes are used,
a minimum clearance of 6″must be
maintained.
• For listed over-the-range microwave
ovens, the microwave ovens can be
installed above the cooktop as per
manufacturer’s installation instructions.
•The range may be placed with 0″clearance
(flush) at the back wall and side walls if the
range side trims extend beyond the cabinet
fronts at least 1/4″.
• See Figures 1 and 2 for all rough-in and
spacing dimensions. These dimensions
must be met for safe use of your range.
The location of the electrical outlet may
be changed as needed, but electricity to
the range can be disconnected at the outlet
without moving the range if the outlet is
in the suggested location (remove lower
drawer).
3
ANTI-TIP DEVICE INSTALLATION
(CONT.)
Slip the nearest link of the chain onto the
bracket. Pull to make sure it is as snug as
possible.
Slide the range all the way back. It is
normal to have some slack in the chain,
but it should not be excessive.
I
H
2
0”
18” Min.
30” Min.
0”
6”
Min.
6”
41⁄ ”2
21⁄ ”4
30”
36”
30”
Acceptable
electrical
outlet area.
Backguard (some models)
Mainback
Bracket Optional
Location
Chain
Bracket Factory
Location
281⁄2”** Wall to front
of door handle
(door closed) 45”
with door open
Fig. 5
Fig. 6
Fig. 7
28”*
1⁄ ”4
5”

Specyfikacje produktu

Marka: GE
Kategoria: piekarnik
Model: JSS26BDBB

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z GE JSS26BDBB, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje piekarnik GE

GE

GE JB710WHWW Instrukcja

15 Października 2024
GE

GE Adora JBP73HLBB Instrukcja

14 Października 2024
GE

GE JGP330SEKSS Instrukcja

14 Października 2024
GE

GE JBP62BMWH Instrukcja

9 Października 2024
GE

GE PC2S930YPFS Instrukcja

8 Października 2024
GE

GE Profile PB911DJBB Instrukcja

8 Października 2024
GE

GE JP346BMBB Instrukcja

7 Października 2024
GE

GE Profile JS966KDCC Instrukcja

7 Października 2024
GE

GE JBP68SHSS Instrukcja

6 Października 2024
GE

GE JBP84DMBB Instrukcja

6 Października 2024

Instrukcje piekarnik

Najnowsze instrukcje dla piekarnik

Wolf

Wolf M Series Instrukcja

15 Października 2024
Princess

Princess 112741 Instrukcja

15 Października 2024
Boretti

Boretti VFPNR 1202 IX Instrukcja

15 Października 2024
Ilve

Ilve MDC-120 Instrukcja

15 Października 2024
Frigidaire

Frigidaire FCWD2727AW Instrukcja

15 Października 2024
Fisher & Paykel

Fisher & Paykel CG302DLPGB4 Instrukcja

15 Października 2024
AEG

AEG IKK74545FB Instrukcja

15 Października 2024
Ilve

Ilve HCPT75D Instrukcja

15 Października 2024
Zanker

Zanker KOU65902XK Instrukcja

15 Października 2024
Hoover

Hoover PHC3B25CXHH64DCT Instrukcja

15 Października 2024