Instrukcja obsługi Futaba FP8SSHP


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Futaba FP8SSHP (36 stron) w kategorii Zabawki sterowane radiem. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/36
Futaba
DIGITAL PROPORTIONAL
RADIO CONTROL
PCM
SINGLE STICK
PULSE CODE MODULATION SYSTEM
D60421
Thank you for purchasing a Futaba digital
proportional radio control set.
Please read this manual carefully before using
your set.
When reading this manual, refer to the foldout at the end of this manual.
CONTENTS
FEATURES
.......................................
1~2
CONTENTS AND RATINGS
...............................
2
TRANSMITTER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3
~ 2 0
RECEIVER
AND
SERVOS
.............................
21
~23
AIRCRAFT ADJUSTMENTS
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
24~29
TRANSMITTER CONTROLS
.. . . . ... . . . ... . . . ... . . . ... .
30 31~
SPLINED HORN AND FREQUENCY CHANNEL NO. FLAG COLOR. .. . 32
S130 EXPLODED
VIEWS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
33
•FEATURES
The FP-8SSHP is a digital proportional R/C set with PCM (Pulse Code Modulation) for helicopters.
The system is extremely noise and dead-point resistant digital proportional R/C sets with a micro-
processor in the transmitter and receiver.
The FP-8SSHP was specially developed for FAI RC aerobatics F3C use.
Please read this manual before using your set.
TRANSMITTER FP-T8SSHP
Newly designed rotatable open gimbal stick
provide maximum operation feel. Stick posi-
tion and spring tension can be adjusted.
RF module system. The frequency band can
be changed with one touch.
•DSC Servo (Direct Controller). The servos can
be operated without turning on the trans-
mitter.
Wire operation is also possible by using the
special
cord supplied
with
the
set.
(FSC-1)
•Servo reversing switch on all channels. The
direction of operation of each servo can be
reversed
with
the
flip
of
a
switch.
•Dual
rates
or non
linear
VTR
(variable
trace
ratio) on the aileron, elevator, and rudder
channels. Aileron and elevator dual rate can
be switched simultaneously, or independently.
Easy-to-adjust two-knob revolution mixing.
Pitch control -> rudder and throttle -> pitch
control mixing.
Revolution mixing compensation. The revolu-
tion mixing (pitch control -> rudder mixing)
up side can be set in the direction at which
the mixing amount to the rudder becomes
smaller. This increases high-speed straightfor-
ward flight and also minimizes the power loss.
Acceleration mixing.
•Throttle hold function for auto-rotation.
•Throttle
hold
delay.
The
pitch
servo
operating
time at throttle hold can be freely set with a
built-in delay circuit.
•Four
(4)
pitch-curve trimmers
for
best
pitch
for hovering and maneuvering.
•New single-chip microprocessor allows one-
touch fail safe setting and introduction of an
automatic transmission system which elimi-
nates the need for fail safe setting at the be-
ginning of each flight and improves safety.
•Hovering throttle permits independent adjust-
ment of the hovering point throttle position.
•Hovering pitch lever permits independent
adjustment of the hovering point pitch with-
out regard to the throttle.
•Two
idle
up
functions
used
for
static
and
dynamic aerobatics.
Hovering memory reproduces the best mixing
point at any throttle position & even during
performance of flight.
Throttle ATL (Adjustable Throttle Limiter)
allows simple and reliable throttle linkage
hook-up.
•Rudder button with timer is convenient in
540* stall turns.
Tachometer/timer with tachometer,built-in
up timer, down timer, integrating timer, and
battery alarm.
•New
ATV
(Adjustable Travel Volume)
on all
channels allows independent pushbutton ad-
justment of servo left, right, up, and down
throw.
•Second ATV. Besides new pushbutton ATV
on aileron and
elevator, conventional tri
mmer
ATV is also installed.
•Monitor lamp glows when two idle up systems
or throttle hold is set and ashes when they
are working.
Fail
safe
switch
(safety
switch). Internal
switches that turn the throttle hold, idle up,
and other functions on and off. If the internal
switch is set to off beforehand, when that
function is not used, it will not operate even
if the switch on the transmitter is set to on.
•Built-in
power
error
back-up
circuit.
When
the
internal Nicd battery approaches the fully
discharged state, an LED blinks to indicate
that the memory circuit (memory, ATV, FS,
etc.) is not working.
•Two
servo
test functions. A
slow
sweep
to
check neutral characteristic, trackability and
to
cycle servo to test servo operation.
•Highest
quality
aluminum
case
with
sophisti-
cated design. The transmitter fits easily in
your hand.
•Optional CCPM (Cyclic Corrective Pitch Mix-
ing).
Trainer system offers
an easy training of
flight for beginners.
1


Specyfikacje produktu

Marka: Futaba
Kategoria: Zabawki sterowane radiem
Model: FP8SSHP

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Futaba FP8SSHP, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Zabawki sterowane radiem Futaba

Futaba

Futaba 12Z Instrukcja

4 Października 2024
Futaba

Futaba 2PL Instrukcja

27 Września 2024
Futaba

Futaba 6EX-2 Instrukcja

14 Września 2024
Futaba

Futaba FC28 Instrukcja

14 Września 2024
Futaba

Futaba 6EXA Instrukcja

11 Września 2024
Futaba

Futaba FP2F Instrukcja

9 Września 2024
Futaba

Futaba SG14 Instrukcja

26 Sierpnia 2024
Futaba

Futaba FP6NPK Instrukcja

21 Sierpnia 2024
Futaba

Futaba 3PDF Instrukcja

21 Sierpnia 2024

Instrukcje Zabawki sterowane radiem

Najnowsze instrukcje dla Zabawki sterowane radiem