Instrukcja obsługi Futaba 9ZHP_part1
Futaba
Sterowanie radiowe
9ZHP_part1
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Futaba 9ZHP_part1 (78 stron) w kategorii Sterowanie radiowe. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/78
Futaba
DIGITAL PROPORTIONAL
RADIO CONTROL
PCM1024ZA
PCM1024ZH
PULSE CODE MODULATION SYSTEM
Thank you for purchasing
a Futaba digital proportional radio control set.
Please read this manual carefully
before using your set.
ATTENTION:
1. Application of Product
This product is not intended for use in any application other than for the
control of models for hobby and recreational purposes. This product is
subject to regulations of the Ministry of Radio/Telecommunications and is
restricted under Japanese low to such purposes. The laws of other countries
may similarly restrict the use of this product. Futaba is not
responsible for any use that is not in compliance with applicable law.
2. Exportation of Product
If the product is exported from Japan, the prior approval of the Ministry of
Radio/Telecommunications is required regarding the country of destination.
If this product is reexported from other countries, it may be subject to
restrictions on such reexport and prior approval of government authorities
may be required.
3. Modification, Adjustment & Replacement of Parts
Futaba is not responsible for any use of this product that is not in
compliance with applicable law and disclaims all responsibility for any modi-
fication or alteration of the product, including the incorporation of the prod-
uct into other products by third parties, that is not in compliance with appli-
cable law.
ATTENTION:
The product that you have purchased contains a rechargeable battery.
The battery is recyclable. At the end of its useful life, under various state
and local laws, it may be illegal to dispose of this battery into the
municipal waste stream. Check with your local solid waste officials for
details in your area for recycling options or proper disposal. (For U.S.A.)
Ni-Cd
THE FOLLOWING STATEMENT APPLIES TO THE RECEIVER
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
(For U.S.A.)
Manual Introductory Section
TABLE OF CONTENTS
System Features
......................
2
Introduction
........................
3
System
Usage
........................
4
Manual Layout
.......................
6
FLYING SAFETY
.....................
7
Notable System Features
.................
9
PCM 1024Z System Contents. ..............
10
Power-On Screen Displays
.................
11
Working With The CAMPac Memory Module .....
.12
Using
The
Soft
Keys
....................
1
3
Operation Without Radio Transmission .........
14
System Monitor Lights & Warnings ............
14
System Status and Alarm Displays ............
15
Using Your Futaba System Contents. . .........
16
Radio Installation
.....................
1
7
Charging & Direct Servo Connect Operation .....
.18
Stick Length Adjustment
.................
19
Stick Tension Adjustment .................
19
Stick Angle Adjustment ..................
20
Antenna Angle Adjustment ................
20
Transmitter Battery Replacement ............
21
Rubber Protective Pad Installation ............
21
Transmitter RF Module ..................
35
Synthesized Frequency
Module & Receiver
......
.99
Flight
Condition
Switching
................
23
SYSTEM MENU
Contents ...........................
94
MSL
-
Model Selection
...................
95
VLT - Battery Voltage Display. ..............
26
TAC - Tachometer .....................
97
SRV - Servo Cycle & Bar Graph Display .........
93
TRN - Trainer System ...................
99
DTN - Data Transfer Function ..............
30
CPM - Copy Model Function ...............
31
CPC
-
Copy Condition
Function
.............
39
PAR - Parameters (Sets Auto-Off and
Screen Contrast) ..................
33
UNA- User Name Registration ..............
34
FRO - Trans. Freq. Set ..................
35
Setting The Frequency Synthesizer Receiver ......
36
SWT - Switch setting ....................
37
PMX
-
Programmable
mixing
...............
65
STM
-
Subtrim
.......................
68
TOF
-
Trim
offset
.....................
69
CNA
-
Condition
naming
.................
70
TRM
•
Digital
trim
.....................
71
AIRPLANE SECTION
Table of Contents
.....................
73
Airplane Controls & Functions
..............
74
Airplane
Receiver
and Servo
Connections
........
76
Airplane Setup Instructions
................
77
Aileron
Differential [ADF]
................
80
Rudder Coupling
[A—R]
.................
81
V-Tail [VTL]
........................
32
Rudder—Aileron
[R-A]
.................
83
Elevons [EVN]
.......................
84
Elevator-»Flap
[E—F]
...................
85
Flap-Elevator
mix
[F—E]
.................
86
Collective Pitch [CPT]
..................
37
Ailvators
[ALV]
......................
33
Flaperons [FPN]
......................
39
Airbrake [ABK]
......................
91
Snap Roll
[SNP]
......................
93
Throttle Curve
Adj.
(TCV)
................
94
HELICOPTER SECTION
Table of Contents
.....................
95
Helicopter Controls
....................
96
Helicopter Receiver and Servo
Connections
.......
93
Sample Helicopter Setup Instructions
..........
99
Pitch
Curve
[PCV]
....................
.104
Hovering Pitch [PHV] ...................105
Pitch Trim [PTM] .....................106
Throttle Curve [TCV]
..................
.107
Hovering Throttle [THV] .................108
Hovering Offset [HOF] ..................109
Throttle Hold [HLD] ...................110
Swashplate
Type
[SWP]
...................................111
Pitch—Rudder [P—R] .................. .112
Rudder—Throttle
[R—T]
.................
.11
3
Gyro Sensitivity [GYR] ..................114
Acceleration [ACC]
........................................
115
Inverted Pitch [INV] .................. .117
MODEL SETTING SECTION
Contents........................... 39
CSL
-
Condition
Select
..................
40
TIM - Timers & Elapsed Time Counter .........
41
F/S - Failsafe/Hold Setting ................
42
PMD - Pulse Mode FM/PCM ................
43
REV -Servo Reversing Function .............
44
FNC
-
Function
Control
..................
45
RST - Data Reset ......................
46
CUT - Engine Cut .....................
47
CHD
-
Condition
Hold
...................
48
TYP - Model Type Selection ...............
49
CH9- Channel 9 Switch Definition ...........
50
MNA - Model Name Definition ..............
51
ALT - Alternate Switch ..................
52
THR - Throttle Curve ...................
53
SWH -Swashplate Type ..................
54
RDR
-
Rotor
Direction
..................
56
INV - Inverted Pitch ....................
57
PIT - Pitch Curve ......................
58
COMMON CONDITIONS
Contents...........................
59
ATV - Adjustable travel volume & Channel delay ...
60
AFR
-
Adjustable
function
rate
..............
62
D/R
-
Dual rates
&
EXP
curve.
..............
64
SAILPLANE SECTION
Table of Contents
....................
. 118
Sailplane Condition Menus ................119
Sailplane Transmitter Controls and Functions . . . .
.120
Sailplane
Receiver
and Servo
Connections
......
.121
Example Sailplane Setup Instructions ..........
195
Aileron Differential [ADF] ................
125
Aileron—Rudder Mixing
[A-R].
............
.126
Aileron-Speed Flap Coupling [ASF] ..............................
127
V-Tail [VTL] .......................
.128
Airbrake
Mixing
[ABE]
..................
129
Elevator—Brake
Flap Mixing [EBF]
.............
.
130
Elevator—Speed Flap
Coupling
(ESF)
.........
.131
Brake Flap Mixing [BKF]
..................... . . .132
Speed Flap Mixing .....................
135
Speed
Flap
Trim
[SFT]
..................
139
Butterfly Mixing [BFY] ..................
140
Butterfly
Trim
Mix [BYE]
................
142
Elevator
Trim
(ETM)
...................
143
Trim Mix 1 [TM1] & Trim Mix 2 [TM2] - 4-S .....
145
Flap-Elevator
mix
[F—E]
................
..147
Elevator-Flap Mix [E—F] ................. .143
Flaperon Mixing (FPN] -
2-S
............... 149
COMMAND
LIST
.....................
151
Manual Introductory Section, Page 1
Specyfikacje produktu
| Marka: | Futaba |
| Kategoria: | Sterowanie radiowe |
| Model: | 9ZHP_part1 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Futaba 9ZHP_part1, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Sterowanie radiowe Futaba
27 Września 2024
27 Września 2024
27 Września 2024
27 Września 2024
27 Września 2024
27 Września 2024
26 Września 2024
26 Września 2024
26 Września 2024
26 Września 2024
Instrukcje Sterowanie radiowe
- Sterowanie radiowe Spektrum
- Sterowanie radiowe Reely
- Sterowanie radiowe Saturn
- Sterowanie radiowe Graupner
- Sterowanie radiowe Multiplex
- Sterowanie radiowe Robbe Futaba
- Sterowanie radiowe Hitec
- Sterowanie radiowe Robbe
- Sterowanie radiowe JRpropo
- Sterowanie radiowe Sanwa
- Sterowanie radiowe Rush
Najnowsze instrukcje dla Sterowanie radiowe
14 Października 2024
27 Września 2024
26 Września 2024
25 Września 2024
24 Września 2024
23 Września 2024
23 Września 2024
23 Września 2024
22 Września 2024
22 Września 2024