Instrukcja obsługi FMS PA-18 Super Cub

FMS Zabawki sterowane radiem PA-18 Super Cub

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla FMS PA-18 Super Cub (48 stron) w kategorii Zabawki sterowane radiem. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/48

FLOAT

Optional float

RIGID

Strong durable EPO

STABLE

Smooth flying performance

WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating.

Failure to operate the product correctly can result in damage to the product,personal property and cause serious injury.

This is a sophisticated hobby product and NOT a toy. It must be operated with caution and common sense and failure to do so

could result in injury or damage to the product or other property. This product is not intended for use by children without direct

adult supervision.

This manual contains instructions for safety operation and maintenance. It is essential to read and follow all the instructions and

warnings in the manual prior to assembly, setup or use, in order to operate and avoid damage or serious injury.

WARNING

As the user of this product, you are solely responsible for operating in a manner that does not endanger yourself and others or

result in damage to the product or the property of others. This model is controlled by a radio signal subject to interference from

many sources outside your control. This interference can cause momentary loss of control so it is advisable to always keep a

safe distance in all directions around your model, as this margin will help avoid collisions or injury.

Age Recommendation: Not for children under 14 years. This is not a toy.

·Never operate your model with low transmitter batteries.

·Always operate your model in an open area away from cars, traffic or people.

·Avoid operating your model in the street where injury or damage can occur.

·Never operate the model in populated areas for any reason.

·Carefully follow the directions and warnings for this and any optional support equipment you use (chargers,rechargeable

battery packs, etc.)

·Keep all chemicals, small parts and anything electrical out of the reach of children.

·Moisture causes damage to electronics. Avoid water exposure to all equipment not specifically designed and protected for this

purpose.

·Never lick or any place of any your model in your mouth as it could cause serious injury or even death.

Lithium Polymer (Li-Po) Battery Warning

CAUTION: Always follow the manufacturer’s instructions for safe use and disposal of batteries. Fire, property

damage, or serious injury can result from the mishandling of Li-Po batteries.

By handling, charging or using a Li-Po Battery you assume all risks associated with lithium batteries.

If at any time the batteries begin to swell or balloon, discontinue use immediately!

Always store the batteries at room temperature in a dry area to extend the life of the battery. Always transport

or temporarily store the battery in a temperature range of 40-120F. Do not store the battery or model in a car or in direct sunlight.

If stored in a hot car, the battery can be damaged or even catch fire.

Never use a Ni-Mh Charger to charge Li-Po Batteries. Failure to charge the battery with a Li-Po compatible charger

may cause fire resulting in personal injury and property damage.

Never discharge Li-Po Cells below 3V.

Never leave charging batteries unattended.

Never charge damaged batteries.

Charging the Flight Battery Warning

Use a battery charger that is designed to safely charge the Li-Po Battery. Read the charger instructions care

fully before use. When charging the battery, make certain the battery is on a heat resistant surface. It is also highly

recommended to place the Li-Po Battery inside a fire resistant charging bag readily available at hobby shops or

online.

p w

Before assembly, please inspect the contents of the kit. The

photo below details the contents of the kit with labels. If any

parts are missing or defective, please identify the name or

part number (refer to the spare parts list near the end of the

manual) then contact your local shop or email us: support

Kit contents

A: Fuselage

B: Main wing

C: tHorizon al stabilizer

D: Landing gear H: Wing/ Horizontal Stabilizer spar

I:F ts loa and accessoriesE: Propeller

F: Sc s rew and pushrods

G: Antenna

Introduction

Kit contents

Model assembly

Battery installation

Receiver diagram

Preflight check

Clevis installation

Control horn and servo arm settings

Center of gravity(CG)

Before flying the model

Flying course

Troubleshooting

Spare parts list content

Table of contents

·····························································

·····

·························································3

·······················································4

············································· ········ 7

·········································

··

········ 8

··································

·····

····················································10

··························

·················

··············································· 10

··············································11

···························································11

······················································12

············································12

Introduction

The Piper PA-18 Super Cub is a two-seat, single-engine

monoplane. It was developed from the Piper PA-11. In close to

40 years of production, over 9,000 were built. Super Cubs are

commonly found in roles such as bush flying, banner towing and

glider towing.

As a relative of the popular 1400mm J-3 Cub, the 1700mm

PA-18 Super Cub retains great flight characteristics while

offering increased power and wingspan.

Thanks to its functional flaps, high-lift airfoil, rugged landing

gear and oversized balloon tires- the 1700mm PA-18 Super Cub

has impressive short take-off and landing (STOL) performance,

allowing it to operate from just about any terrain.

Utilizing the latest FMS hardware and design, the 1700mm

PA-18 Super Cub has pre-installed ball-link type pushrods,

integrated servo connectors in the wing structure and can be

assembled very easily using no glue at all.

For pilots wanting to get the genuine bush-plane experience, the

PA-18 Super Cub can be equipped with floats.

Versatile, fun and exceptionally relaxing to fly- the 1700mm

PA-18 Super Cub is a great addition to any fleet!

Wingspan: 1700mm(66.9in)

Overall length: 1136mm(44.7in)

Flying weight: ~ 2100g

Motor size: 3541-KV750

Wing load: 50g/dm²(0.11oz/in²)

Wing area: 42dm²(651sq.in)

ESC: 45A

Servo: 17g Servo x 6

Recommended battery: 14.8V 2200-2600mAh 35C

Specifications

@fmsmodel.com.

Features:

• Powerful 3541- KV750 Outrunner motor with Predator 45A

ESC provides adequate thrust for any situation

• CNC metal landing gear structure for less-than-perfect landings

• 6.25-inch oversized balloon tires for all-terrain operations

• STOL capable (Takes off in less than 3m/10ft)

• Pre-installed navigation and landing lights

• Two-piece wing and horizontal stabilizer for easy transportation

• Integrated servo connectors

• Screw-together assembly

• Large battery bay

• Ball-linked pushrods for increased precision

• Tough two bladed Nylon propellers

• Functional flaps

• Optional floats and stainless-steel wing struts

B. C.

G. H.

D. E.

Specyfikacje produktu

Marka:	FMS
Kategoria:	Zabawki sterowane radiem
Model:	PA-18 Super Cub
Kolor produktu:	Black, Grey, White
Typ produktu:	Samolot
Materiał obudowy:	Ekspandowana poliolefina (EPO)
Waga produktu:	2100 g
Pojemność baterii:	2200 mAh
Liczba kanałów:	6 kan.
Rodzaj baterii:	35C
Zalecany wiek (min):	14 lat(a)
Wymagane baterie:	Tak
Nieodpowiedni dla dzieci poniżej 3 r.ż.:	Tak
Oryginalna nazwa modelu:	Piper PA-18 Super Cub
Rodzaj konstrukcji:	Plug-N-Play (PNP)
Rozpiętość skrzydeł:	1700 mm
Napięcie baterii:	14.8 V
Długość produktu:	1136 mm
Czas lotu:	15 min
Rodzaj silnika:	Silnik elektryczny
Montaż wymagany:	Tak
Czas montażu:	15 min
Środek ciężkości (CG):	80 - 85 mm
Elektroniczny kontroler prędkości silnika (ESC):	Tak
Liczba serw:	6
Rozmiar silnika:	3541-KV750
Obciążenie skrzydeł:	0.5 g/cm²
Poziom trudności:	Średnio-zaawansowany
Powierzchnia skrzydeł:	4200 cm²
Replica:	Tak
Zalecana bateria:	14.8V 2200-2600mAh 4s 35C
Serwo waga:	17 g