Instrukcja obsługi Emerson CKS1900

Emerson nieskategoryzowany CKS1900

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Emerson CKS1900 (3 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 19 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/3
1.) Read these instructions.
2.) Keep these instructions.
3.) Heed all warnings.
4.) Follow all instructions.
5.) Do not use this apparatus near water.
6.) Clean only with dry cloth.
7.) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8.) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9.) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong is provided for your safety. If the provided plug does not
fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10.) Prot ect the po wer co rd from be ing wal ked on or pin ched pa rtic ular ly at plug s, co nven ienc e
receptacles, and the point where they exit from the apparatus.
11.) Only use attachments / accessories specified by the manufacturer.
12.) Unplug this apparatus during lightning storms or when unused for long periods of time.
13.) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
14.) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or
sold with the apparatus. When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.
15.) The apparatus shall not be exposed to dripping or splashing and that no
objects filled with liquids, such as vases, shall be placed on apparatus.
16.) Mains plug is used as disconnect device and it should remain readily
operable during intended use. In order to disconnect the apparatus from the
mains completely, the mains plug should be disconnected from the mains
socket outlet completely.
17.) Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Danger of explosion if battery is incorrectly replaced. Replace only with theCAUTION:
same or equivalent type.
PRÉCAUTION: Danger d’explosion si les piles sont remplacées de facon incorrect. Remplacer
les piles seulement par le méme type de pile ou l’équivalent.
◀ ▶
Press the or button to adjust the Year;
Setting the Year
Setting the Date
Setting the Time
Checking the Current Year-Date-Day of Week-Time Settings
Press briefly the button repeatedly to see the cycle of CLOCK SET
year, date, day of week and time. To restore time display mode,
leave it idle for few secs.
the button until the Year 'Flashes',CLOCK SET
the button;
5
6
7
8
9
Press the button again and release, the Date 'Flashes';CLOCK SET
Press the or button to adjust the Minutes;
Press the or button to adjust the Month;
For example, May 21th will appear as '5.21';
Press the button again and release, CLOCK SET
the Hour 'Flashes';
Press the or button to adjust the Hour (where AM
indicator 'On' is AM, 'Off' is PM);
Press the button again, or leave CLOCK SET
it idle for few seconds, to store all new settings
and restore it to time display mode.
press and hold the  AL1
7.) (FM Radio) Indicator.MHz
8.) (AM Radio) Indicator.KHz
9.) Indicator ('On'=AM,'Off'=PM)AM 20.) Time/Date Display
18.) Down/Volume- Button▼
11.) Button TIME ZONE/ ON/OFF
10.) AC adapter (Back Cabinet).
16.) Set-/Tune- Button ◀
17.) Set+/Tune+ Button▶
13.) Setting/ (Store) Button.AL1 STO.
21.) Speaker(Top Cabinet)
19.) Up/Volume+ Button▲
15.) / / ButtonSLEEP SNOOZE DIMMER
14.) Setting/ (Memory) ButtonAL2 MEM.
12.) Select ButtonCLOCK SET/ BAND
11 12 13 14 15 16 17 18 19
20
21
10
1
2
3
4
9
8
7
6
5
Press to select week mode.◀ ▶or
Front Panel
Top Panel
press and hold until the
display Flashes‘ ’
Release
Note：Time zone and clock settings can only be adjusted in Standby mode,where the
AM/FM Radio is disabled(i.e.the indicators of kHz and MHz are Off‘ ’)
IMPORTANT:Alarm settings can only be adjusted in Standby mode.
Adjusting The Wake Up Time and Alarm Week Mode
•Press and hold either the or button until the display blinks and changes fromAL1 AL2
the current time to the Alarm 1 or Alarm 2 wake up time.
•Release the ( ) button,press the or button to adjust Hour press the AL1 AL2 ◀ ▶
▼ ▲ or to adjust Minutes.
•Press the ( ) button again,Alarm Week Mode will blink .Press the orAL1 AL2 ◀ ▶
button repeatedly to select your desired Alarm Week Mode:d1-7,d1-5 or d6-7
•Press the ( ) button again to store the alarm setting and resume to clock mode.AL1 AL2
d1-7
d1-5
d6-7
week
time.Press
it week
Remove any descriptive labels,stickers or protective films on the front or top
of the cabinet,if any.
and hold
Week
you may use one alarm for weekdays and the other for weekend wake up times.The
procedure for adjusting the wake up times is the same for both Alarm1and Alarm2.
Week press
Alarm Week Mode
Alarm Week Mode
Week
Press
TUNE−TUNE＋VOL−VOL＋
DIMMER SLEEP
SNOOZE
TIME
ZONE
CLOCK
SET
ON/OFF BAND STO. MEM.
CKS1900-20221202-01 Printed in China
◀
▶
▲
▼
▲
▼
STO.
▲
▼
STO.
MEM.
▲
▼
briefly
steps below:
a long wire located at the back.Extend this antenna wire
2) Press and hold the ( ) button until the display blinks and changes from the AL1 AL2
current time to the Alarm1 or Alarm2 wake up time.
3) Release the ( ) button, press the or button to adjust Hour, and press the AL1 AL2 ◀ ▶
▼or ▲button to adjust Minutes.
4) Press the ( ) button again, press the or button to adjust alarm volume AL1 AL2 ▼ ▲
(V01~V16) that will come on at wake up time.
5) Press the ( ) button again, press the or button to select alarm week mode AL1 AL2 ◀ ▶
(d1-7 everyday, d1-5 weekdays or d6-7 weekends only), if necessary.
6) Press the ( ) button to save the alarm settings.AL1 AL2
7) Press the ( ) button repeatedly, if necessary, until 1♫(2♫) indicator glows AL1 AL2
(alarm activated)
8
9
10
reaches
AL1
ON/OFF
Week
1 or 2
1 2
Note: Wake-to-buzzer alarm volume is fixed, cannot be adjusted.
ON/OFF button once.
There is a gap next to the marking that can be filled by fingernail for lifting up the battery^,
holder.
CLOCK SET
previous page to
Follow the instructions on sections to set the clock to Setting the Year/Date/Time
the correct year,date and time
Press the button repeatedly to check the year,date and time.CLOCK SET
Make final adjustment if necessary.
3 to 5
(1 or 2♫ ♫)
fully and orient it for better FM reception.
band the BAND
BAND
Press the ( ) button repeatedly to turn the Alarm1 (Alarm2) lndicator On. AL1 AL2
Press the button to turn ON the radio first. ON/OFF
Then press
(default sleep timer setting).

Specyfikacje produktu

Marka: Emerson
Kategoria: nieskategoryzowany
Model: CKS1900

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Emerson CKS1900, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje nieskategoryzowany Emerson

Emerson

Emerson Sensi RS01-SG Instrukcja

14 Sierpnia 2024
Emerson

Emerson SmartSet CKS1507 Instrukcja

18 Czerwca 2024
Emerson

Emerson AV510 Instrukcja

18 Czerwca 2024
Emerson

Emerson BO61 Instrukcja

18 Czerwca 2024
Emerson

Emerson CKS1702 Instrukcja

18 Czerwca 2024
Emerson

Emerson SB329 Instrukcja

18 Czerwca 2024
Emerson

Emerson CKD5809 Instrukcja

18 Czerwca 2024
Emerson

Emerson CKD1612 Instrukcja

18 Czerwca 2024
Emerson

Emerson CKS1500 Instrukcja

18 Czerwca 2024
Emerson

Emerson CK5859 Instrukcja

18 Czerwca 2024

Instrukcje nieskategoryzowany

Najnowsze instrukcje dla nieskategoryzowany

Asko

Asko DBI644MIB.S.TW/1 Instrukcja

28 Października 2024
Asko

Asko DFS233IB.S.TW/1 Instrukcja

28 Października 2024
Emko

Emko EZM-9920 Instrukcja

27 Października 2024
Emko

Emko ESM-3712-H Instrukcja

27 Października 2024
Emko

Emko ATS-10 Instrukcja

27 Października 2024
Emko

Emko EAOM-11.2 Instrukcja

27 Października 2024
Emko

Emko EPM-3790 Instrukcja

27 Października 2024
Emko

Emko EPM-7790 Instrukcja

27 Października 2024
Livarno Lux

Livarno Lux IAN 108340 Instrukcja

27 Października 2024
Livarno Lux

Livarno Lux HG06009A-BS Instrukcja

27 Października 2024