Instrukcja obsługi Elkay LK1500CR

Elkay Dźwig LK1500CR

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Elkay LK1500CR (4 stron) w kategorii Dźwig. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/4
Screwdriver
SAVE FOR CONSUMER
Groove joint pliers (2) 1/2 Supply Linesin
Wrench
OPTIONAL 2.2GPM AERATOR
Sealant Tape Plumber's Putty
INSTALLATION / OWNER'S MANUAL
LK1501
You choose the ow rate!
This faucet ships with an
eco-friendly 1.5GPM ow regulator
installed.
If you desire higher ow rate, a
2.2GPMow regulator has also
been included in the box.
Switching the ow regulator is
simple! See the "Flow Regulator
Replacement" section for details.
Important!
Single Handle Kitchen Faucet
Model # LK1500, LK1501
LK1500
WARNING: Please carefully read and properly follow the instructions for installation found in this manual.
Shut o water supply at angle stop.
Clean sink surface in preparation for
new faucet.
If your model has a spray, proceed
to step 2. If your model does not
have a spray skip to step 4.
Place faucet in position on sink.
From underneath sink, install rubber
washer (1) and metal washer (2)
onto the threaded mounting shank.
Thread nut (3) onto mounting shank.
Do not overtighten.
STEPS:
For models with spray:
Insert spray hose down through the
support and sink. Attach the spray hose to
the connection beneath the faucet by
aligning the tabs on quick connector. Push
quick connector housing firmly upward
and snap onto receiving tube tab. Pull
down moderately to ensure connection
has been made.
If it is necessary to remove the quick
connector, squeeze tabs on hose between
index nger and thumb, then pull down to
disconnect.
Make connections to water lines.
Use 1/2" I.P.S. faucet connections (1)
or use coupling nuts (3)
with 3/8" O.D.ball-nose riser(2).
Use wrenches to tighten connections.
Do not overtighten.
1
Important: After installation is completed,
remove aerator assembly. Turn on hot
and cold water supplies. Turn handle to
full open position for one minute. Check
for leaks. Replace aerator.
3
2
For models with spray:
Insert spray support through far right
hole on sink. Screw hold - down nut
(1)onto shank and hand tighten.
Place faucet in position on sink.
Install rubber washer (2) and metal
washer (3) onto the threaded
mounting shank. Thread nut (4) onto
mounting shank. Do not overtighten.
2-Ø1 3/8" (Ø35mm)
2
4
3
1
2
CARE AND CLEANING INSTRUCTIONS
FOR CARE AND MAINTENANCE:
·The water in certain areas of the world can be very caustic -
standing water around the product can cause damage. Be
sure to remove standing water with a dry, soft cloth as soon
as possible.
·For polished brass nishes, as often as once a week, you
can apply a paste wax or special, non-abrasive, brass
coating (DO NOT APPLY POLISH).
·Before applying a protective coating, gently brush the entire
xture using a soft tooth brush. This will remove any dirt or
deposit build-up.
·These simple steps will add temporary protective coating to
your faucet and extend the life of the finish.
Failure to follow care and cleaning will void your warranty.
For additional information, please visit elkayusa.com .
This faucet ships with a 1.5GPM aerator installed. An
optional 2.2GPM aerator is also included in the box.
To switch the ow rate of the faucet:
1. Disassemble aerator assembly by separating the
aerator shell (1), aerator (2) and washer (3). Remove
existing aerator (2) and install the new aerator.
(2.2GPM=Red, 1.5GPM=Green)
2. Reinstall the aerator assembly.
FLOW REGULATOR REPLACEMENT
Congratulations on your purchase of an Elkay product.
Although your product is extremely durable, attention should
be given to the care, cleaning and maintenance of this
product. Cleaning agents and abrasives may cause damage,
which may result in oxidation and discoloration.
By following these simple guidelines for proper care and
cleaning, it will give you years of enjoyment:
TO CLEAN: Simply wipe gently with a damp cloth and blot dry
with a soft towel. A common rule of thumb is: when you dry o,
dry o your product.
· Avoid build-up of soap, toothpaste or mineral deposits, as
these tend to have an adverse eect on the appearance of
the product.
· NEVER use cleaning products of any kind on this product -
especially those containing ammonia, bleach or alcohol - or
those with any form of abrasive.
Shut o water supply. Remove set screw plug (1). With
valves in "closed" position, unscrew set screw (2) and
remove handle (3) from valve stem (4). Loosen the screw
(7) from valve stem (4). Loosen the cap (5) from the
sleeve (6).
4
6
3
1
2
Loosen sleeve (1) by turning it counter-clockwise and
lift out the cartridge (2). Remove the old cartridge and
replace with the new cartridge. Replace sleeve and
tighten. Reinstall the handle.
CARTRIDGE REPLACEMENT
7
5
32
11


Specyfikacje produktu

Marka: Elkay
Kategoria: Dźwig
Model: LK1500CR

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Elkay LK1500CR, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Dźwig Elkay

Elkay

Elkay LKSS1141A Instrukcja

8 Października 2024
Elkay

Elkay LKSSVR1141A Instrukcja

8 Października 2024
Elkay

Elkay LK1141A Instrukcja

8 Października 2024
Elkay

Elkay LK109A Instrukcja

8 Października 2024
Elkay

Elkay LKBH1141A Instrukcja

8 Października 2024
Elkay

Elkay LKVRBH1141A Instrukcja

8 Października 2024
Elkay

Elkay LKVR1141A Instrukcja

8 Października 2024
Elkay

Elkay LKEC2037CR Instrukcja

22 Września 2024
Elkay

Elkay LKEC2031LS Instrukcja

21 Września 2024
Elkay

Elkay LKHA1041CR Instrukcja

21 Września 2024

Instrukcje Dźwig

Najnowsze instrukcje dla Dźwig