Instrukcja obsługi Electro Harmonix Nano Metal Muff

Electro Harmonix Niesklasyfikowane Nano Metal Muff

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Electro Harmonix Nano Metal Muff (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/4

Nano Metal Muff

with Noise Gate

Congratulations on your purchase of the Nano Metal Muff, a pocket-sized offering of

EHX’s classic Metal Muff. The Nano Metal Muff utilizes three powerful EQ bands and a

newly added noise gate to tame unwanted noise and hum between riffs. The Nano

Metal Muff offers commanding bass, sculpted mids, and defined high coupled with s

user-controlled distortion from pinched-edge to totally crushing making it a true —

heavy metal machine.

C ONTROLS

DIST Knob – Adjusts the amount of distortion and saturation. Turn clockwise for

more saturation.

GATE Knob Removes unwanted hum by adjusting the noise floor threshold. The –

gate mutes the OUTPUT jack when the signal at the INPUT jack is below the threshold

setting of the GATE knob. As GATE is turned clockwise, a louder guitar signal at the

INPUT jack is required to unmute the OUTPUT jack Set GATE fully counter-clockwise .

to disable.

Setting the GATE knob: start with GATE fully counterclockwise, DIST above noon, and

your guitar volume at max, you may want to hold the strings so they don’t ring out.

Slowly turn GATE clockwise until the Nano Metal Muff mutes. Now turn GATE a little

further clockwise and then test it. If you have to play with too much force to unmute

the gate then turn GATE a little counter-clockwise. If you want the gate to act more

quickly at the end of notes, turn GATE further clockwise.

GATE LED – This LED lights when the internal gate mutes the output signal. When

the GATE LED is off, the signal is allowed to pass through to the output jack.

VOL Knob – Sets the overall output level.

BASS Knob Provides up to 14dB of cut and boost in the bass frequency range. –

MID Knob Provides up to 15dB of cut and boost in the middle frequency range. –

TREBLE Knob – Provides up to 10dB of cut and boost in the treble frequency range.

BYPASS Footswitch & STATUS LED Toggles the Nano Metal Muff between effect –

and buffered bypassed. The STATUS D lights when the pedal is engaged. LE

C & P ONNECTIONS OWER

INPUT Jack Nano Metal Muff. The input – This ¼” jack is the audio input to the

impedance presented at the INPUT jack is 1M . Ω

OUTPUT Jack Nano Metal Muff. In – This ¼” jack is the audio output from the

Bypass mode, the OUTPUT jack is connected to the INPUT jack through a buffer

circuit. The output impedance at the OUTPUT Jack is 600 . Ω

9V Power Jack An optional 9VDC, center-negative power supply can be inserted –

into this jack to power the Nano Metal Muff. The Nano Metal Muff requires mA at 24

9VDC on a center-negative plug. Do not exceed at the power jack. 12V

When using a 9V battery, plugging into the INPUT jack activates power. The input

cable should be removed when the unit is not in use to avoid running down the

battery.

To change the 9-volt battery, you must remove the 4 screws on the

bottom of the Nano Metal Muff. Once the screws are removed, you can

take off the bottom plate and change the battery. Please do not touch the

circuit board while the bottom plate is off or you may damage a

component.

N & S OTES PECIFICATIONS

• Audio input impedance at INPUT jack: 1MΩ

• Audio output impedance at OUTPUT jack: 600Ω

• Current draw: mA 24

• Maximum input signal level in bypass, before clipping +8.5 : dBu

To achieve its biting distortion, the Nano Metal Muff has very high maximum gain.

This requires that both the pickups and cables be well shielded and properly

grounded to avoid excessive hum when high sustain control settings are used.

C OMPLIANCE

Note:

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more

of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help .

Modifications not expressly approved by the manufacturer could void the user's authority to

operate the equipment under FCC rules.

The CE logo indicates that this product has been tested and shown to conform with all

applicable European Conformity directives.

The logo indicates that this product is made up of electronic WEEE or “trashcan”

components that should not be trashed alongside household waste but instead should

be recycled by a proper electrical waste facility.

Specyfikacje produktu

Marka:	Electro Harmonix
Kategoria:	Niesklasyfikowane
Model:	Nano Metal Muff

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Electro Harmonix Nano Metal Muff, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Niesklasyfikowane Electro Harmonix

Electro Harmonix Cock Fight Instrukcja

7 Października 2024

Electro Harmonix Cock Fight Plus Instrukcja

7 Października 2024

Electro Harmonix Holy Grail Max Instrukcja

7 Października 2024

Electro Harmonix Spruce Goose Instrukcja

5 Października 2024

Electro Harmonix Germanium 4 Big Muff Pi Instrukcja

5 Października 2024

Electro Harmonix LPB-3 Instrukcja

5 Października 2024

Electro Harmonix Deluxe Memory Man 550-TT Instrukcja

5 Października 2024

Electro Harmonix 2X12 Speaker Cabinet Instrukcja

3 Października 2024

Electro Harmonix Rerun Instrukcja

3 Października 2024

Electro Harmonix 15Watt Instrukcja

30 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024

Stihl HT 70 Instrukcja

15 Października 2024

Ernesto H14270 Instrukcja

15 Października 2024

Uniden BT MIC KIT Instrukcja

15 Października 2024

Vaude Omnis Bike 26 Instrukcja

15 Października 2024

ART ProChannel II Instrukcja

15 Października 2024

Aukey DR02J Instrukcja

15 Października 2024

Master Lock 653EURD Instrukcja

15 Października 2024

Roland FR-18 Diatonic Instrukcja

15 Października 2024