Instrukcja obsługi Dimplex DXUF20TN
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Dimplex DXUF20TN (2 stron) w kategorii grzejnik. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/2
Fan Heaters
Model(s) : DXUF20TN & DXUF30TN
Installation and Operating Instructions
08/52522/1 Issue 1
IMPORTANT SAFETY ADVICE
READ THESE INSTRUCTIONS BEFORE USE.
DO NOT use the heater on deep pile carpets or
the long hair type of rugs, or less than 750mm
(30”) away from any overhanging surface. Keep
combustible materials such as drapes and other
furnishings clear from the front, sides and rear of
the heater. Do not use heater to dry your laundry.
DO NOT use the heater in the immediate
surroundings of a bath, a shower or a swimming
pool.
DO NOT place the heater directly below a xed
socket outlet.
The socket-outlet must be accessible at all times
to enable the mains plug to be disconnected as
quickly as possible.
DO NOT COVER or obstruct the air inlet and
outlet openings in any way.
The heater must be on a at stable surface when
in use.
DO NOT operate the heater with the mains lead
overhanging the front outlet grille.
The Heater carries the warning symbol
indicating that it must not be covered.
WARNING: In order to avoid overheating do not
cover the heater.
The instruction leaet belongs to the appliance
and must be kept in a safe place. If changing
owners, the leaet must be surrendered to the
new owner.
IMPORTANT: If the mains lead of this appliance is
damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualied person
in order to avoid a hazard.
IMPORTANT : THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
WARNING: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an
external switching device, such as a timer, or
connected to a circuit that is regularly switched
on and off by the utility.
This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of
expierience or knowledge if they have been given
supervision or instruction concerning the use of
the appliance in a safe way and understand the
hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall
not be made by children without supervision.
Children of less than 3 years should be kept away
unless contiuously supervised.
Children aged from 3 years and less than 8 years
shall only switch on/off the appliance provided
that it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning the
use of the appliance in a safe way and understand
the hazards involved. Children aged from 3
years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user
maintenance.
CAUTION: Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vunerable people are present.
Avoid use of an extension cord because the
extension cord may overheat and cause risk of
re.
Fig. 1
Model(s) Specication
DXUF20TN 2.0kW Thermostat & Switch
DXUF30TN 3.0kW Thermostat & Switch
H W D
243 230 163
(See Fig. 3) (See Fig. 2)
The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC)
EN55014, EN60555-2 and EN60555-3 which cover the essential requirements of EEC Directives 73/23 and 89/336
[c] Glen Dimplex UK Limited
All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex UK Limited.
Electrical connection
This heater must be used on an supply only and the voltage A.C.~
marked on the heater must correspond to the supply voltage. This
heater is tted with a plug incorporating a 13 amp fuse. When
replacing the fuse, a 13 amp fuse approved by ASTA to BS 1362
must be used.
If the plug is not suitable for the socket outlets in your home, the
plug must be cut off and an appropriate one tted. A plug cut off
from a mains lead will give a shock hazard if inserted into a 13
amp socket elsewhere in the house. To avoid this, it should be
disposed of immediately.
NOTE: The fuse cover of a non-rewirable plug must be retted
when changing the fuse. Should the cover become lost, the plug
must not be used until the correct replacement fuse cover is
obtained from your supplier or by contacting our customer helpline.
IMPORTANT : The wires in this mains lead are coloured in
accordance with the following code :
BLUE : NEUTRAL
BROWN : LIVE
As the colours of the wires in the mains lead may not correspond
with the coloured markings in your plug, proceed as follows :
Connect the wire to the terminal marked ‘ ’ or coloured BROWN L
RED BLUE. Connect the wire to the terminal marked ‘N’ or
coloured .BLACK Note : ‘L’ or ‘ ’ must not be connected to the N
EARTH E terminal marked ‘ ’ or ‘ ’ or coloured or GREEN GREEN
AND YELLOW.
If in doubt, consult your electrician.
Using the Heater
Main Elements - See Fig 1.
Heat Control - see Fig. 2
Fig. 2
Thermostat Control - see Fig. 3
The heat output is controlled by the
thermostat, according to the room
temperature.
Turn the thermostat knob fully clockwise
to maximum setting initially. When the
room is warm enough, reduce the
setting slowly until the heater just
clicks off.
The heater will now cycle on and off to maintain your
selected room temperature. An audible click may be heard
when the thermostat operates - this is normal.
Note : If the heater does not come on when the thermostat is
at a low setting, this is normally because the room is warmer
than the thermostat setting and is not a fault.
* When the heat control is set to ‘ ’ for cool blow, set the
thermostat control to maximum.
Position ‘ ’ will turn the heater on and off to maintain a
temperature of approximately 5°C.
Safety - overheat protection
For your safety, this appliance is tted with a thermal cut-out.
In the event that the product overheats, the cut-out switches
the heater off automatically. To bring the heater back into
operation, remove the cause of overheating, then turn off
the electrical supply to the heater for a few minutes.
When the heater has cooled sufciently reconnect and
switch on the heater.
If the cut-out operates repeatedly, contact your supplier.
Cleaning
WARNING ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
Do not use detergents, abrasive cleaning powders or polish
of any kind on the heater.
Wipe with a dry cloth to remove dust and a damp cloth (not
wet) to clean off stains. Be careful not to allow moisture
into the heater.
Ensure that dust or uff does not accumulate inside the
heater as this could lead to overheating of the element.
Use a vacuum cleaner to remove any uff which does
accumulate.
Recycling
For electrical products sold within the
European Community.
At the end of the electrical products useful
life it should not be disposed of with
household waste. Please recycle where
facilities exist. Check with your Local
Authority or retailer for recycling advice in
your country.
After Sales Service
Your product is guaranteed for three years from the date of
purchase. After sales information or assistance with this
product can be found on our website:
www.dimplex.co.uk/support.
Your rights under this guarantee are additional to your
statutory rights, which in turn are not affected by this
guarantee.
Please do not return a faulty product to us as this may
result in loss or damage and delay in providing you with a
satisfactory service.
If after following these steps your product still does not
operate you should return it to your point of purchase.
Please retain your receipt as proof of purchase.
1. Power Indicator Light
2. Thermostat Control Knob
3. Switch Knob
4. Air Outlet
- Off
- Cool Blow*
- Half Heat
- Full Heat
Fig. 3
Specyfikacje produktu
| Marka: | Dimplex |
| Kategoria: | grzejnik |
| Model: | DXUF20TN |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Dimplex DXUF20TN, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje grzejnik Dimplex
5 Czerwca 2024
5 Czerwca 2024
5 Czerwca 2024
5 Czerwca 2024
5 Czerwca 2024
5 Czerwca 2024
5 Czerwca 2024
5 Czerwca 2024
5 Czerwca 2024
5 Czerwca 2024
Instrukcje grzejnik
- grzejnik Bauknecht
- grzejnik Tesy
- grzejnik DeLonghi
- grzejnik Götze & Jensen
- grzejnik Tefal
- grzejnik Nedis
- grzejnik Adler
- grzejnik Rinnai
- grzejnik Domo
- grzejnik Ardes
- grzejnik Taurus
- grzejnik Orbegozo
- grzejnik Einhell
- grzejnik Bimar
- grzejnik Honeywell
- grzejnik Concept
- grzejnik Chauvet
- grzejnik Fuxtec
- grzejnik Broan
- grzejnik Mestic
- grzejnik Wilfa
- grzejnik Eureka
- grzejnik DEDRA
- grzejnik Emerio
- grzejnik Melissa
- grzejnik Beper
- grzejnik Ravanson
- grzejnik Thermex
- grzejnik Trotec
- grzejnik Thomson
- grzejnik Trumatic
- grzejnik Klarstein
- grzejnik Danfoss
- grzejnik Güde
- grzejnik JANDY
- grzejnik Qlima
- grzejnik Scarlett
- grzejnik GUTFELS
- grzejnik Harvia
- grzejnik Clatronic
- grzejnik SVAN
- grzejnik Solac
- grzejnik Hama
- grzejnik Orion
- grzejnik Blumfeldt
- grzejnik Zibro
- grzejnik Becken
- grzejnik Thermotec
- grzejnik Reer
- grzejnik Vitek
- grzejnik Eurom
- grzejnik Lifesmart
- grzejnik Lasko
- grzejnik Flama
- grzejnik Yellow Garden Line
- grzejnik Toyotomi
- grzejnik Soler & Palau
- grzejnik Monzana
- grzejnik Bestron
- grzejnik Optimum
- grzejnik Profile
- grzejnik TaoTronics
- grzejnik Anslut
- grzejnik Eldom
- grzejnik Creda
- grzejnik Kambrook
- grzejnik Noveen
- grzejnik Waldbeck
- grzejnik Waves
- grzejnik Ecoteck
- grzejnik Mirpol
- grzejnik Ausclimate
- grzejnik Hortus
- grzejnik Mission Air
- grzejnik Bromic
- grzejnik Airo
- grzejnik Ionmax
Najnowsze instrukcje dla grzejnik
26 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
24 Września 2024
24 Września 2024
24 Września 2024
24 Września 2024
24 Września 2024