Instrukcja obsługi Dimplex CAS1000

Dimplex nieskategoryzowany CAS1000

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Dimplex CAS1000 (20 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 14 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/20
CAS1000R
The product complies with the European Safety Standards and the European Standard Electromagnetic Compatibility (EMC). These cover the
essential requirements of EMC Directives and the LVD Directive.
08/53960/0 Issue 2
OCN 11177
CAS500R
1
Dimplex CAS500R, CAS1000R
Important Safety Advice
Introduction
Please read this information guide carefully to be able to safely install, use and maintain your product.
When using electrical appliances, basic precautions should always be followed to reduce the
risk of re, electrical shock and injury to persons, including the following:
If the appliance is damaged, check with the supplier before installation and operation.
Do not use outdoors.
Do not use in the immediate surroundings of a bath, shower or swimming pool.
Do not locate the appliance immediately below a xed socket outlet or connection box.
This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided
that it has been placed or installed in its intended normal operating position and they have been
given supervision or instruction concerning use of the appliance in a safe way and understand
the hazards involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
CAUTION: Some parts of this product can become very hot and cause burns. Particular
attention has to be given where children and vulnerable people are present.
Do not use this appliance in series with a thermal control, a program controller, a timer or any
other device that switches on the heat automatically, since a re risk exists when the heater is
accidentally covered or displaced.
Ensure that furniture, curtains or other combustible material are positioned no closer than 1
meter from the appliance.
In the event of a fault unplug the appliance.
Unplug the appliance when not required for long periods.
Although this appliance complies with safety standards, we do not recommend its use on deep
pile carpets or on long hair type of rugs.
The appliance must be positioned so that the plug is accessible.
If the supply cord is damaged it must be replaced by the manufacturer or service agent or a
similarly qualied person in order to avoid a hazard.
Keep the supply cord away from the front of the appliance.
WARNING: In order to avoid overheating, do not cover the appliance. Do not place material or
garments on the appliance, or obstruct the air circulation around the appliance.
The appliance carries a DO NOT COVER warning symbol.
This appliance is not equipped with a device to control the room temperature. Do not use this
appliance in small rooms when they are occupied by persons not capable of leaving the room
on their own, unless constant supervision is provided.
2
General Information
Installation Instructions
This section describes how to install and set up your re.
Before you start:
Ensure that all packing items are removed (read any warning labels carefully) and retain all packing for possible future
use.
Before connecting the appliance, check that the supply voltage is the same as that stated on the appliance.
CONNECTIONS REQUIRED IN ADVANCE OF INSTALLATION
Electrical Connection
Please ensure a 230V / 16A power socket is located within 1m of the product. The electrical connection should be
accessible during product installation so that the connection can be made to the product easily.
BUILDING THE PRODUCT SURROUND/ENCLOSURE
This product can be built into a wall, surround or structure. Please take note of the product dimensions (Fig.1) and build
your wall, surround or structure accordingly. Suitable clearance should be provided to allow the product to be installed
easily.
You are required to leave a minimum of 400mm from the base of the fuel bed to any shelf/enclosure above the product
(Fig. 2). This will allow enough space above the product to allow the ame effect to form fully and not to be obstructed.
When determining a location for the product, ensure that the unit will not be susceptible to drafts, vents, ceiling fans and
other air currents. Similar to a candle, large movements of air will affect the unit’s ability to create and maintain the ame
effect. If the desired location is susceptible to signicant air movement, i.e. air vents, the different installation options
illustrated in Fig 2 can be used.
VENTILATION
This product needs free ventilation from underneath to operate correctly. There are slots on the underside of the product
to allow this free air through the product. The free ventilation helps keep the electronic components cool and allows the
mist to rise and leave the product. Please see Fig 3 & 4 for examples of the required ventilation. Please take note of the
requirement for a ventilation opening on the shelf where the product sits, to allow a clear path for the air to get to the
product.
CAS500R Free Ventilation Area: Minimum 210cm2
CAS1000R Free Ventilation Area: Minimum 420cm2
ELECTRICAL CONNECTION
Plug the re into a 16amp/230 Volt outlet. Be sure to have access to the plug after installation to allow for disconnection.
Ensure that the supply cable exits at the back of the re at the right or left hand corner to suit your supply socket location
and is not trapped under the re such that it might cause it to be damaged.
The appliance can be connected to the xed wiring of the premises through a suitable connection box positioned
adjacent to the appliance. This electrical installation must be carried out by a competent electrician and be in strict
Only use ltered/decalcied water in this appliance.
Unpack the appliance carefully and retain the packaging for possible future use, in the event of moving or returning
the re to your supplier.
Always ensure that the appliance is sitting on a level surface.
The appliance is a ame effect only.
The appliance is designed to be built into a surround or built into a wall.
Please note: Used in an environment where background noise is very low, it may be possible to hear a sound which is
related to the operation of the ame effect. This is normal and should not be a cause for concern.
Once installed, never move this appliance or lay on its back, without draining the water from sump and water tank.
The water tank, sump, sump lid, tank cap and air lters must be cleaned once every 2 weeks, particularly in hard
water areas.
If you intend not using the appliance for longer than 2 weeks, drain the water from sump and water tank and dry the
sump.
The sump and the water tank in this product are treated with a biocidal product, Silver Biocide. This conforms to the
latest relevant ISO standard
s this product contains and utilises water as an aspect of its operation, the adherence to the cleaning requirement as
detailed within the instructions is necessary to ensure that risk/s through bacterial proliferation are minimised. It is ad-
ditionally recommended that if this unit is connected to a water supply, that it becomes included within any Legionella
assessment. Please refer to the Maintenance section in the following instruction booklet for details on the cleaning
Do not drink the water from the sump or from the water tank(s).

Specyfikacje produktu

Marka: Dimplex
Kategoria: nieskategoryzowany
Model: CAS1000

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Dimplex CAS1000, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje nieskategoryzowany Dimplex

Dimplex

Dimplex CABM1 Instrukcja

5 Czerwca 2024
Dimplex

Dimplex ARC10E Instrukcja

5 Czerwca 2024
Dimplex

Dimplex DAB20AR Instrukcja

5 Czerwca 2024
Dimplex

Dimplex DAB20A Instrukcja

5 Czerwca 2024
Dimplex

Dimplex DAB20W Instrukcja

5 Czerwca 2024
Dimplex

Dimplex WFC3NS Instrukcja

5 Czerwca 2024
Dimplex

Dimplex ARC20E Instrukcja

5 Czerwca 2024
Dimplex

Dimplex CAB15ER Instrukcja

5 Czerwca 2024
Dimplex

Dimplex CAB20WR Instrukcja

5 Czerwca 2024
Dimplex

Dimplex DAB15AR Instrukcja

5 Czerwca 2024

Instrukcje nieskategoryzowany

Najnowsze instrukcje dla nieskategoryzowany

Meec Tools

Meec Tools 010-084 Instrukcja

6 Października 2024
Outwell

Outwell Scenic Road 250 Instrukcja

5 Października 2024
Impact

Impact Qualite QL-3560-LED Instrukcja

4 Października 2024
Impact

Impact QuikBalance Instrukcja

4 Października 2024
Impact

Impact CA-112 Instrukcja

4 Października 2024
Impact

Impact Forever Ready Cool FRC-24-LED Instrukcja

4 Października 2024
Impact

Impact LS-BHA Instrukcja

4 Października 2024
Impact

Impact LKB-5C Instrukcja

4 Października 2024
Impact

Impact Varipole Drop Ceiling Adapter Instrukcja

4 Października 2024
Impact

Impact RST-001 Instrukcja

4 Października 2024