Instrukcja obsługi Delfield CoolScapes GBR2P-GH

Delfield lodówka CoolScapes GBR2P-GH

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Delfield CoolScapes GBR2P-GH (9 stron) w kategorii lodówka. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/9
Series GC, GB & GBS Reach-Ins
CoolScapes™
Original Instructions
Installation, Operation and Maintenance Manual
This manual is updated as new information and models are released. Visit our website for the latest manual.
Part Number: 9294839 03/17
Part Number: 9294839 03/17 5
DANGER
Installation must comply with all applicable fire and
health codes in your jurisdiction.
DANGER
Use appropriate safety equipment during installation
and servicing.
nWarning
Do not damage the refrigeration circuit when installing,
maintaining or servicing the unit.
Location
nWarning
This equipment must be positioned so that the plug is
accessible unless other means for disconnection from
the power supply (e.g., circuit breaker or disconnect
switch) is provided.
nWarning
Adequate means must be provided to limit the
movement of this appliance without depending on or
transmitting stress to the electrical conduit or gas lines.
nWarning
To avoid instability the installation area must be capable
of supporting the combined weight of the equipment
and product. Additionally the equipment must be level
side to side and front to back.
nWarning
This equipment is intended for indoor use only. Do not
install or operate this equipment in outdoor areas.
The location selected for the equipment must meet the
following criteria. If any of these criteria are not met, select
another location.
• The location MUST be level, stable and capable of
supporting the weight of the equipment.
• The location MUST be free from and clear of
combustible materials.
• Equipment MUST be level both front to back and side to
side.
• Position the equipment so it will not tip or slide.
• Front casters MUST be locked once positioned.
• Recommended air temperature is 60° - 100°F
(16° - 38°C).
• Proper air supply for ventilation is REQUIRED AND
CRITICAL for safe and efficient operation. Refer to
Clearance Requirements chart on page 6.
• Do not obstruct the flow of ventilation air. Make sure the
air vents of the equipment are not blocked.
• Do not install the equipment directly over a drain.
Steam rising up out of the drain will adversely affect
operation, air circulation, and damage electrical /
electronic components.
Section 2
Installation
Section 2 Installation
Part Number: 9294839 03/17 15
T-1 Tray Slide Installation
Edge Support for 18” x 26” pans
Installed T-1 Tray Slide for 18”x 26” Pans
System Name T-1
Slide Style Tray
Support Style Edge
Compatible with 12” x 20” Pans No
Compatible with 18” x 26” Pans Yes
The T-1 tray slide system is designed to support 18” x 26”
pans by the edge of the pan. The slides are shaped as a C
channel.
Each set of tray slides is mounted at the same height across
a door section. If the tray slides are not at the same height,
the pan cannot be held securely. For each pan, one set of
two (2) tray slides is used. The only exception to this rule is
when 1.5” pan spacing is desired. For 1.5” spacing, the tray
slides are mounted every 3” and the top and bottom of
each tray slide is used to hold a pan.
Centers
1.5” 2.0” 3.0” 4.0” 5.0” 6.0”
Maximum Tray Slides for a Full Section
17 26 17 13 10 8
Maximum Tray Slides for a Half Section (Top)
7 10 6 5 4 4
Maximum Tray Slides for a Half Section (Bottom)
8 12 8 6 5 4
T-1 Installation Instructions
1. For each pan, mount a pair of tray slides; one on each
side of the door section at the same height. Mount the
tray slides onto the pilasters by sliding the tray slide
tabs down into the cutouts. Make sure that all tabs are
engaged securely to each pilaster.
NOTE: A dead-blow hammer is recommended to seat the
tab into the cutouts.
Pilaster
Slider
2. Verify that all tray slides are lined up evenly.
NOTE: An easy check to verify correct installation is to slide
an 18” x 26” pan onto each slide. If the pan is held securely,
and is level inside the door section, the installation has
been successful.

Specyfikacje produktu

Marka: Delfield
Kategoria: lodówka
Model: CoolScapes GBR2P-GH

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Delfield CoolScapes GBR2P-GH, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje lodówka Delfield

Delfield

Delfield CoolScapes GBSR3P-G Instrukcja

22 Września 2024
Delfield

Delfield F5MC72DP Instrukcja

22 Września 2024
Delfield

Delfield F5MC48DP Instrukcja

21 Września 2024
Delfield

Delfield CoolScapes GBSR1P-GH Instrukcja

19 Września 2024
Delfield

Delfield NLFACP-12 Instrukcja

18 Września 2024
Delfield

Delfield CoolScapes GBR3P-S Instrukcja

18 Września 2024
Delfield

Delfield CoolScapes GBR2P-GH Instrukcja

18 Września 2024
Delfield

Delfield CoolScapes GBR1P-SH Instrukcja

18 Września 2024
Delfield

Delfield CoolScapes GBR2P-S Instrukcja

18 Września 2024
Delfield

Delfield F5PC48DP Instrukcja

17 Września 2024

Instrukcje lodówka

Najnowsze instrukcje dla lodówka

Samsung

Samsung RT32K5030EF Instrukcja

15 Października 2024
Liebherr

Liebherr CBNes 4875 Instrukcja

15 Października 2024
Frigidaire

Frigidaire FFPH44M4LM Instrukcja

15 Października 2024
AEG

AEG Santo 70318 KG1 Instrukcja

15 Października 2024
Whirlpool

Whirlpool ART 550 Instrukcja

15 Października 2024
Indesit

Indesit TLA 1 (UK) (0) Instrukcja

15 Października 2024
Hotpoint

Hotpoint HTH18GBCCC Instrukcja

15 Października 2024
Zanker

Zanker ZKK8021 Instrukcja

15 Października 2024
Hoover

Hoover HFF 618 DW Instrukcja

15 Października 2024
Frigidaire

Frigidaire FRT15HB3DQ Instrukcja

15 Października 2024