Instrukcja obsługi Da-Lite Lexington 98109

Da-Lite Niesklasyfikowane Lexington 98109

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Da-Lite Lexington 98109 (8 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/8
INSTRUCTION BOOK FOR
Lectern
2
To remove lectern top from projector stand base, disconnect
power cord and turn the black knob (located under the middle
shelf) counter-clockwise until disengaged. Lift of lectern top and
place in desired location.
Projector stand base features a 110/120 VAC Duplex receptacle
for equipment. Plug line cord into approved 3-wire 110/120 V
outlet. To assemble, reverse this procedure.
Stacking Models
All Models Optional Height Adjustment
Power
Connect power supply to 110/120 VAC 3-wire outlet
(220/240 VAC models to 220/240 VAC source).
Reading Light
Depress light switch to activate light. ADJUST VISOR AS
NECESSARY. Use GE 25T8DC 110v appliance lamp or equivalent
when relamping all 110/120 sound and non-sound lecterns;
GE 1176 12v for 220v lecterns.
Digital Clock/Count Down Timer
Select desired mode; adjust time with SET switch. Unit will
remain operational as long as the main power supply is on.
NOTE: Power interruptions will cause the clock to lash until reset.
Models with optional reading surface adjustment are controlled
by the switch marked HEIGHT and provide up to 8 - 9 inches of
elevation. To raise or lower, depress HEIGHT switch.
3
The Da-Lite sound system is modular in design for ease of
service. The power supply and ampliier are accessed inside
the lectern body. The controls are accessed by removal of
dash panel.
If your lectern fails to operate on a known power source, be
sure to check the circuit breaker located on the Power Supply
for a tripped condition. Reset to restore function. If breaker
continues to trip, discontinue use of product until problem can
be diagnosed.
Service
Sound Models
Plug microphone into shock mount on reading surface. Turn
main power switch located under reading surface on. Rotate
"MAIN MIC", "TREBLE" and "BASS" controls fully counterclockwise
to minimum volume position. Turn speaker switch located on
dash panel to position. While speaking into the microphone, "on"
slowly increase "Main Mic" volume by turning knob clockwise.
Adjust until feedback begins, then decrease volume to stable
condition or lower to desired volume level. Adjust bass and treble
controls to desired tonal quality. Turn SPEAKER SWITCH to "of"
position when done using the sound system.
Auxiliary Microphone (XLR Jack)
The auxiliary mic input is located under the reading surface and
is used for a second mic or wireless microphone input. The
volume control is located on the dash panel. The aux. mic input
is balanced low impedance (600 ) and is phantom powered so Ω
condenser type microphone can be used.
Auxiliary Line Input (1/4" Phone Jack)
The auxiliary input is used for playback of tape
player, musical instrument, VCR, or an audio feed
from another sound system. The volume control
is located on dash panel.
Auxiliary Line Output (1/4" Phone Jack)
The signal output is a composite of all the inputs and can be fed
directly to an audio or video tape recorder. Or, the line output
can be fed to another sound system to combine systems for
greater output, or it may be fed to the input of a hearing
impaired system.
External Speaker Outputs (1/4" Phone Jack)
The external speaker outputs can be used to drive external
speakers in lieu of the internal lectern speaker. When a plug is
inserted into the external speaker jacks, the internal speaker is
disconnected. The powerful (50 watts) is adequate to drive
several speakers provided the total load impedance is not less
than 2 ohms. The output of the ampliier is self-protecting against
overload; however, low impedance loads (below 2 ) will cause Ω
excessive heating reducing ampliier output.
Light
HeightSpeaker
Clock
Digital Clock-Timer
Minute
Timer
Set Mode
Hour
On
Up
On
OfDown
Of
Main MIC. AUX. MIC. AUX. Line Bass Treble

Specyfikacje produktu

Marka: Da-Lite
Kategoria: Niesklasyfikowane
Model: Lexington 98109

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Da-Lite Lexington 98109, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Niesklasyfikowane Da-Lite

Da-Lite

Da-Lite Parallax 29849 Instrukcja

12 Października 2024
Da-Lite

Da-Lite Wireline Advantage 29872E Instrukcja

8 Października 2024
Da-Lite

Da-Lite Wireline Advantage 29739EG Instrukcja

6 Października 2024
Da-Lite

Da-Lite Wireline Advantage 29869E Instrukcja

30 Września 2024
Da-Lite

Da-Lite Flex Plex 29535 Instrukcja

29 Września 2024
Da-Lite

Da-Lite Wireline Advantage 29741 Instrukcja

27 Września 2024
Da-Lite

Da-Lite Flex Plex 29531 Instrukcja

21 Września 2024
Da-Lite

Da-Lite Wireline Advantage 29745EG Instrukcja

16 Września 2024
Da-Lite

Da-Lite The Providence 98143 Instrukcja

16 Września 2024
Da-Lite

Da-Lite Lexington 83146 Instrukcja

16 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024
Husqvarna

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024
Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024