Instrukcja obsługi Crystal Quest CQE-CT-00141


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Crystal Quest CQE-CT-00141 (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/4
Crystal Quest® Countertop
Replaceable Water Filter Systems
INSTALLATION AND OPERATION GUIDE
ONLINE WARRANTY INFORMATION
CrystalQuest.com/warranty.html
Copyright 2020
Crystal Quest®
All rights reserved
MADE IN THE USA
2
Please read all instructions and precautions before installing and using your Crystal Quest
® Countertop Water Filter.
Numbered diagrams correspond with numbered steps.
Use this system on a potable (safe-to-drink) COLD water supply only. Do not install on hot water line.
Do not use non-Crystal Quest
® replacement cartridges.
Do not use non-Crystal Quest
® parts or modify/tamper with unit.
WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without ate disinfection before
or after the system. Systems certied for cyst reduction may be used on disinfected water tha n lterable cysts.
CAUTION: Filter must be protected against freezing which can cause cracking of the lte e.
NOTE:
Filter cartridge life varies depending on lter type, usage, and water conditi used
with this system has a limited service life. Changes in taste, odor, or r
edu dicate
that the cartridge should be replaced.
The contaminants or other substances removed or reduced by thes r. Ask your
local water municipality for a copy of their water analysis or have er testing lab.
After prolonged periods of non-use (such as during a vacation ushed thoroughly.
Let water run for 5-6 minutes before using. Repeat if nece
A drinking water cartridge may contain carbon nes (very ne
black powder). After installation, ush the cartridge 3-4 times
per ush for 5-10 minutes to remove the nes before using the
water. Repeat as required.
It is recommended that you run the tap at least 20 seconds prior
to each use for drinking or cooking purposes.
During initial use, your water may appear cloudy. This cloudiness
is caused by air that has been trapped in the cartridge. If the
water sits for 5 minutes in a glass, you will notice the cloudiness
disappear from the bottom up. This phenomenon is not harmful
and will clear up in time as the remaining air is ushed from the
cartridge.
CONNECTING DIVERTER VALVE TO
OPERATION
NOTE: Adapt most faucets. To create
a tight seal, you ket from your faucet’s
aerator in addition uded with the adapters. If
the adapters do not  local plumbing or hardware
supplier for assistance i g the correctly threaded adapter.
OPERATING SPECIFICATIONS
Pressure Range: 30-60 psi (2.1-4.2 bar)
Temperature Range: 40-85°F (4.4-29.4°C)
Rated Service Flow: 0.3-0.5 gpm
IMPORTANT INFORMATION
i
3
A. Turn off faucet. Unscrew the top of the housing us when housing is removed.
Empty excess water into sink. Set top of lter
B. Pull out lter cartridge to remove from the with warm water, mild dish soap
and a soft cloth. Do not use harsh deterg s they may damage the system.
C. Set base of lter on counter. Insert n onal arrow on the cartridge which
indicates “This End Towards Cap”
NOTE: Make sure both black O-rin make sure to lubricate O-rings with cooking oil.
(Do not use coconut oil).
D. Screw top of lter hous ch until very snug.
E. Turn on water and th times for 5 to 10 minutes to remove any media nes
before using wat
FILTER CARTRIDGE REPLACEMENT
A. Leaks between base and housing:
Turn off faucet and unscrew base of housing.
Check to make sure both O-rings are clean, lubricated with non-petroleum oil (do not use coconut oil) and
undamaged. Replace if necessary.
Use thread seal tape around sump threading.
Reinsert cartridge into base according to the directional arrow on the cartridge w dicated “This End
Downward Towards Cap” and screw on sump using sump wrench. Be careful n hread or
overtighten. If leak persists, contact Technical Support at service@crystalqu
B. Diverter valve will not release:
Unscrew diverter valve from faucet.
Soak in white vinegar up to one hour to remove scale build-up a
C. Decreased f ow or return of bad taste/odor:
Replace filter cartridge.
TROUBLESHOOTING


Specyfikacje produktu

Marka: Crystal Quest
Kategoria: Niesklasyfikowane
Model: CQE-CT-00141

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Crystal Quest CQE-CT-00141, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Niesklasyfikowane Crystal Quest

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024