Instrukcja obsługi Coyote C1ELCT21

Coyote Niesklasyfikowane C1ELCT21

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Coyote C1ELCT21 (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/2

www coyoteoutdoorcom

DIMENSIONAL RENDERINGS

DIMENSIONAL RENDERINGSDIMENSIONAL RENDERINGS

Model No.

Model No.Model No.

Power Supply

Power SupplyPower Supply Watts

Watts

WattsWatts Amps

Amps

AmpsAmps

C1EL120SM 120V AC 1300 11

Model No. Height Width Depth

C1EL120SM 16"

C1EL120SM

Cutout Dimensions for Island

Cutout Dimensions for IslandCutout Dimensions for Island

Overall Product Dimensions

Overall Product DimensionsOverall Product Dimensions

15"

16 1/4" 3 3/8"

18 1/8"11 3/8"

Portable Specs

Portable SpecsPortable Specs

Built-In Specs

Built-In SpecsBuilt-In Specs

HzHz

C1EL120SM

C1EL120SM C1EL120SM INSTALL GUIDE

INSTALL GUIDE

INSTALL GUIDEINSTALL GUIDE

Important

ImportantImportant Note

Note

NoteNote to

toto Installer:

Installer:

Installer:Installer:

This file is not intended to r eplace your Owners' Manual which contains specific safety requirements

and consumer guidelines. Please refer to your Owners' Manual prior to installing or operating your grill. electric

www coyoteoutdoorcom

C1EL120SM

C1EL120SM C1EL120SM INSTALL GUIDE

INSTALL GUIDE

INSTALL GUIDEINSTALL GUIDE

Installation of this grill must meet the location requirements shown in the above installation illustration

All dimensions listed are minimum requirements for safe operation

Failure to locate the grill without proper clearances will result in a fire hazard

For built-in situations, a minimum height clearance of 6-1/4" is required from the top of the counter top to any combustible material below the

grill.

This grill is approved for indoor or outdoor use, however a ventilation hood is always recommended for use indoors to provide additional air

circulation

Ventilation of any built-in enclosure is required for safety. Refer to your state, municipal and local codes for required specifications

The grill should be installed by a qualified installer or technician that can follow all stated instructions within this guide and the owners manual

of the grill

Important

ImportantImportant Note

Note

NoteNote to

toto Installer:

Installer:

Installer:Installer:

This file is not intended to replace your Owners' Manual which contains specific safety

requirements and consumer guidelines. Please refer to your Owners' Manual prior to installing or operating your built-in grill.

Maximum depth of overhead cabinets can be 13”

Minimum height of countertop from floor should be 36”

The minimum flat countertop surface that the grill will rest upon must be equal to or greater than the overall grill dimensions

30” minimum clearance between the top of the grill and the bottom of an unprotected wood or metal cabinet OR 24” minimum clearance

when the bottom of wood or metal cabinet is protected by not less than ” thick flame retardant mill board covered with not less than No. 1/4

28 MSG sheet steel, .015” thick stainless steel, .024” thick aluminum or .020” thick copper

4” minimum from backsplash of countertop to edge of grill. 1-1/2” minimum from front of counter to grill

18" min

36"

FLOOR TO

COUNTERTOP

30" min

COUNTERTOP

TO COMBUSTIBLE

MATERIALS

SEE COUNTERTOP

CUT-OUT TOP RIGHT

2" 2"

TO COMBUSTIBLE

SIDE

SIDESIDE

CABINET

CABINETCABINET

13"

max

FRONT VIEW

FRONT VIEWFRONT VIEW SIDE VIEW

SIDE VIEW

SIDE VIEWSIDE VIEW

16"

CUT-OUT WIDTH

COUNTERTOP CUT

COUNTERTOP CUTCOUNTERTOP CUT

-OUT

-OUT-OUT

FRONT

15"

CUT-OUT

DEPTH

11/2" min

4" min

REAR - BACKSPLASH

Electrical Requirements:

Electrical Requirements:Electrical Requirements:

Installation Requirements:

Installation Requirements:Installation Requirements:

Clearance Requirements:

Clearance Requirements:Clearance Requirements:

This electric grill must be installed in accordance with National Electric Codes, as well as state, municipal and local codes

The correct voltage, frequency and amperage must be supplied to the grill from a dedicated grounded circuit which is protected by a properly

sized circuit breaker or time delay fuse.

The proper voltage, frequency and amperage ratings are listed on the product rating plate.

The grill must be properly grounded at all times when electrical power is applied

TO COMBUSTIBLE

Specyfikacje produktu

Marka:	Coyote
Kategoria:	Niesklasyfikowane
Model:	C1ELCT21
Kolor produktu:	Grey,Metallic
Wbudowany wyłącznik:	Tak
Częstotliwość wejściowa AC:	50 - 60 Hz
Napięcie wejściowe AC:	100 - 240 V
Wysokość produktu:	44 mm
Szerokość produktu:	480 mm
Głębokość produktu:	118 mm
Waga produktu:	2200 g
Podręcznik użytkownika:	Tak
Szerokość opakowania:	222 mm
Wysokość opakowania:	78 mm
Głębokość opakowania:	146 mm
Certyfikaty:	FCC, CE, RoHS
Kraj pochodzenia:	Tajwan
Standardy komunikacyjne:	IEEE 802.3,IEEE 802.3u,IEEE 802.3x
Pełny dupleks:	Tak
Obsługa PoE:	Tak
Zakres temperatur (eksploatacja):	0 - 45 °C
Zakres wilgotności względnej:	10 - 90 %
Przewody:	Prąd przemienny
Kod zharmonizowanego systemu (HS):	85176990
Waga wraz z opakowaniem:	2600 g
Diody LED:	Activity,PoE,Power
Zakres temperatur (przechowywanie):	-40 - 70 °C
Dopuszczalna wilgotność względna:	10 - 90 %
Prąd wejściowy:	5 A
Możliwości montowania w stelażu:	Tak
Podstawowe przełączanie RJ-45 Liczba portów Ethernet:	16
Podstawowe przełączania Ethernet RJ-45 porty typ:	Fast Ethernet (10/100)
Złącze zasilania:	DC-in jack
Obsługa 10G:	Nie
Wielkość tabeli adresów:	4096 wejścia
Przepustowość rutowania/przełączania:	3.2 Gbit/s
Podpora kontroli przepływu:	Tak
Całkowita Power over Ethernet (PoE) budżetu:	240 W
Technologia okablowania Copper Ethernet:	10BASE-T,100BASE-TX
Automatyczne MDI/MDI-X:	Tak
Store-and-forward:	Tak
Rozmiar bufora:	160 KB
Auto-Negocjacja:	Tak
Funkcje ochrony zasilania:	Over current,Short circuit
Zakres przekazywania pakietów (100 Mbps):	148000 pps
Zakres przekazywania pakietów (10 Mbps):	14880 pps
Ilość portów Fast Ethernet (PoE):	16
Zasilanie przez Ethernet (PoE) zasilanie na port:	30 W