Instrukcja obsługi Chief KCD320

Chief Wsparcie dla płaskich paneli KCD320

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Chief KCD320 (16 stron) w kategorii Wsparcie dla płaskich paneli. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/16
Chief Manufacturing, a products division of
Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8832-000065 Rev. P
©2011 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
08/11
I N S T A L L A T I O N I N S T R U C T I O N S
BEFORE YOU BEGIN
Small Flat Panel Mounts
Model: K-Series
This Instruction Manual covers most of the K-Series wall,
desk, and pole mounts for single, dual, and triple
displays. In addition, this Instruction Manual also covers
selected K-Series accessories.
NOTE: Some K-Series mounts, such as Extreme Tilt,
Grommet, and Table, as well as most K-Series
accessories, have separate Instruction Manuals.
See Specifications for a complete list of models
covered by this Instruction Manual.
NOTE: If an accessory such as an optional laptop tray is
being installed, complete all required installation
procedures within this document prior to installing
the accessory.
K-Series Mounts (Examples)
WARNING: It is the installer’s responsibility to make sure all components are properly assembled and installed
using the instructions provided. Failure to read, thoroughly understand, and follow all instructions can result in
serious personal injury, damage to equipment, or voiding of factory warranty.
• If you have any questions about this these instructions or your specific installation, contact Chief Manufacturing.
DISCLAIMER:
Milestone AV Technologies and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and
complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for
every possible contingency in connection with the installation or use of this product. The information contained in this document is subject to change
without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained
herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
Model: K-Series Installation Instructions
2
IMPORTANT WARNINGS AND CAUTIONS!
WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury
or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is
attached can support five times the combined weight of all equipment. Reinforce the structure as required before
installing the component.
WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of all components does not exceed the maximum support
weight as stated in the Specifications section.
WARNING: Allowing any part of your body or component cables to be caught between movable parts can result in
serious personal injury or damage to equipment!
CAUTION: Overtightening fasteners may result in improper operation, excessive wear or damage to equipment,
and/or voiding of factory warranty!
CONTENTS
TOOLS REQUIRED FOR INSTALLATION ...............................................................................................................2
SPECIFICATIONS.....................................................................................................................................................3
MOUNT INSTALLATION ...........................................................................................................................................4
DISPLAY INSTALLATION .........................................................................................................................................7
ARRAY ASSEMBLY (DUAL / TRIPLE DISPLAY; ALL EXCEPT KCY-210/-220).......................................................9
MULTI-DUAL ARM ASSEMBLY (KCY-210/-220 ONLY)..........................................................................................10
CABLE MANAGEMENT.......................................................................................................................................... 11
ADJUSTMENT ........................................................................................................................................................12
TOOLS REQUIRED FOR INSTALLATION
• Phillips Screwdriver, #1 and #2
• 9/16" Wrench (KSA-1015/-1016 Only)
• Drill (All Wall Mounts)
• 1/8" Drill Bit (All Wall Mounts except KSA-1015/-1016)
• 1/4" Drill Bit (KSA-1015/-1016 Only)
• 2.5mm Hex Key (approximately 3/32"; provided with Desk Mounts)
• 5/32" Hex Key (provided with applicable K-Series mounts)
• 3/16" Hex Key (provided with all K-Series mounts)
NOTE: Other tools may be required depending on your method of installation.
Installation Instructions Model: K-Series
3
SPECIFICATIONS
Table 1: Mounts
MODEL NO. OF
DISPLAYS
SUPPORTING
STRUCTURE
NO. OF
MOUNTING
ARMS
ADJUSTABLE
HEIGHT
MAX.
EXTENSION
(INCHES)
MIN.
CLOSED
DEPTH
(INCHES)
MAX.
SUPPORT
WEIGHT
(LBS.)
PER MONITOR
KWP-110 Single Wall None 40No None 2.9
KWV-110 Single Wall Single Yes 13 252.2
KWS-110 Single Wall Single No 9.5 2.2 40
KWG-110 19.5 25Single Wall Dual Yes 2.2
KWD-110 16 40Single Wall Dual No 2.2
KWB-110 Single Wall Triple Yes 26 252.2
KCV-110 Single Desk Single Yes 13.5 252.2
KCS-110 Single Desk Single No 10 402.2
KCG-110 Single Desk Dual Yes 20 252.2
KCD-110 Single Desk Dual No 16.5 402.2
KCB-110 Single Desk Triple Yes 26.5 252.2
KPP-110 Single Pole None 40No None 2.2
KPS-110 Single Pole Single No 9.5 2.2 40
KPD-110 Single Pole Dual No 16 402.2
KPG-110 Single Pole Single Yes 16.5 252.2
KPV-110 Single Pole Single Yes 13.3 252.2
KWD-130 Single Wall Single Yes 18.6 255.1
KWS-220 Dual Wall Single No 13.5 176.4
KWD-220 20 17Dual DualWall No 6.4
KCS-220 Dual Desk Single No 14 406.4
KCD-220 Dual DualDesk No 20.5 176.4
KCY-210 Dual Desk Multi-Dual Yes (one arm) 20 202.2
KCY-220 Dual Desk Multi-Dual Yes (two arms) 20 202.2
KWD-230 Dual Wall Single No 18.6 405.9
KWS-320 Triple SingleWall No 13.5 106.4
KWD-320 Triple Wall Dual No 20 106.4
KCS-320 Triple Desk Single No 14 106.4
KCD-320 Triple Desk Dual No 20.5 106.4
KGL-110 Tray Desk Single Yes 29.5 1814
KGL-220 Single/Tray Desk Dual Yes 29.5 14 40 total
Table 2: Accessories
MODEL NO. OF
MONITORS
SUPPORTING
STRUCTURE
NO. OF
MOUNTING
ARMS
ADJUSTABLE
HEIGHT
MAX.
EXTENSION
(INCHES)
MIN.
CLOSED
DEPTH
(INCHES)
MAX.
SUPPORT
WEIGHT
(LBS.)
PER MONITOR
KMA-220 Dual N/A N/AN/A N/A N/A 17
KMA-320 Triple N/A N/AN/A N/A N/A 10
KMA-325 Triple N/A N/AN/A N/A N/A 10
KSA-1015 N/A Wall Single No 16 6.4 75
KSA-1016 N/A 6.4Wall Dual No 24.5 75 total

Specyfikacje produktu

Marka: Chief
Kategoria: Wsparcie dla płaskich paneli
Model: KCD320

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Chief KCD320, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Wsparcie dla płaskich paneli Chief

Chief

Chief TS218SU Instrukcja

9 Grudnia 2024
Chief

Chief PFQUB Instrukcja

6 Października 2024
Chief

Chief MFQUB Instrukcja

5 Października 2024
Chief

Chief PFMUB Instrukcja

5 Października 2024
Chief

Chief K4G210B Instrukcja

23 Września 2024
Chief

Chief MF26000B Instrukcja

23 Września 2024
Chief

Chief FSB018BLK Instrukcja

23 Września 2024
Chief

Chief TPK1 Instrukcja

22 Września 2024
Chief

Chief PDR2612B Instrukcja

22 Września 2024
Chief

Chief CMA395 Instrukcja

22 Września 2024

Instrukcje Wsparcie dla płaskich paneli

Najnowsze instrukcje dla Wsparcie dla płaskich paneli

Rocstor

Rocstor Y10N027-B1 Instrukcja

11 Grudnia 2024
StarTech.com

StarTech.com ARMQUADSS Instrukcja

10 Grudnia 2024
CTA Digital

CTA Digital ADD-AVPMB Instrukcja

10 Grudnia 2024
Gabor

Gabor FPC-85 Instrukcja

10 Grudnia 2024
Gabor

Gabor FPS-L Instrukcja

10 Grudnia 2024
Gabor

Gabor TM-UL Instrukcja

10 Grudnia 2024
Kanto

Kanto FMX2 Instrukcja

9 Grudnia 2024
Gabor

Gabor FSM-L Instrukcja

9 Grudnia 2024
Dell

Dell MDS19 Instrukcja

8 Grudnia 2024
Proaim

Proaim CT-SDCF-PRO Instrukcja

7 Grudnia 2024