Instrukcja obsługi Chief FWS110B

Chief Wsparcie dla płaskich paneli FWS110B

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Chief FWS110B (16 stron) w kategorii Wsparcie dla płaskich paneli. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/16

I N S T A L L A T I O N I N S T R U C T I O N S

CHIEF MANUFACTURING INC.

1-800-582-6480 952-894-6280 FAX 952-894-6918

8401 EAGLE CREEK PARKWAY, STE 700

SAVAGE, MINNESOTA 55378 USA

8832-000173 RevB

www.chiefmfg.com

03/07

BEFORE YOU BEGIN

Small Flat Panel Mounts

Model: F-Series

This Instruction Manual covers most of the F-Series wall

and desk mounts, as well as selected F-Series pole

mounts.

NOTE: Some F-Series mounts (e.g., Table, Pole) and F-

Series accessories have separate Instruction

Manuals.

See Specifications on page 3 for a complete list of

models covered by this Instruction Manual.

IMPORTANT ! : If an accessory such as an optional

laptop tray is being installed, complete all required

installation procedures within this document prior to

installing the accessory.

F-Series Mounts (Examples)

WARNING: It is the installer’s responsibility to make sure all components are properly assembled and installed

using the instructions provided. Failure to read, thoroughly understand, and follow all instructions can result in

serious personal injury, damage to equipment, or voiding of factory warranty.

• If you have any questions about this these instructions or your specific installation, contact Chief Manufacturing

at 1-800-582-6480 or 952-894-6280.

DISCLAIMER:

CSAV, Inc., and its affiliated corporations and subsidiaries (collectively, "CSAV"), intend to make this manual accurate and complete. However,

CSAV makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible

contingency in connection with the installation or use of this product. The information contained in this document is subject to change without notice

or obligation of any kind. CSAV makes no representation of warranty, expressed or implied, regarding the information contained herein. CSAV

assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.

Model: F-Series Installation Instructions

IMPORTANT WARNINGS AND CAUTIONS!

WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.

CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the

corresponding instructions.

WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury

or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is

attached can support five times the combined weight of all equipment. Reinforce the structure as required before

installing the component.

WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the

installer’s responsibility to make sure the combined weight of all components does not exceed the maximum support

weight as stated in the Specifications on page 3.

WARNING: Allowing any part of your body or component cables to be caught between movable parts can result in

serious personal injury or damage to equipment!

CAUTION: Overtightening fasteners may result in improper operation, excessive wear or damage to equipment,

and/or voiding of factory warranty!

CONTENTS

TOOLS REQUIRED FOR INSTALLATION................................................................................................................2

SPECIFICATIONS.....................................................................................................................................................3

MOUNT INSTALLATION ...........................................................................................................................................4

DISPLAY INSTALLATION..........................................................................................................................................7

ARRAY ASSEMBLY (DUAL / TRIPLE DISPLAY; FMA-220/-320 ONLY) ................................................................10

MULTI-DUAL ARM ASSEMBLY (FCY-210/-220 ONLY).......................................................................................... 11

CABLE MANAGEMENT..........................................................................................................................................13

ADJUSTMENT ........................................................................................................................................................14

TOOLS REQUIRED FOR INSTALLATION

• Phillips Screwdriver, #1 and #2

• Drill (All Wall Mounts)

• 1/8" Drill Bit (All Wall Mounts)

• 2.5mm Hex Key (approximately 3/32"; provided with Desk Mounts)

• 5/32" Hex Key (provided with applicable F-Series mounts)

• 3/16" Hex Key (provided with all F-Series mounts)