Instrukcja obsługi CDA AS1CM
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla CDA AS1CM (7 stron) w kategorii umywalka. Ta instrukcja była pomocna dla 12 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/7
www.cda.eu
Composite
Sinks
Installation, Use and Maintenance
3
sink, wipe o immediately with a dry cloth, wash with mild detergent
and rinse with water.
• Do not use abrasive liquids, powders or steel pads to clean the sink
as they will damage the sink surface and make it more susceptible to
staining. The sink may be cleaned with a dilute bleach solution.
• Do not place very hot objects directly on the sink, place them on a
special surface (board) made from wood or heat-proof plastic, etc.
• If the sink comes into contact with acidic materials, rinse immediately
with plenty of water and wipe with a soft dry cloth.
• In hard-water areas, a limescale deposit may build up on the sink.
The limescale may become stained by coloured foods such as coee
or red wine. If this occurs, we recommend use of a mild limescale
remover.
• Particularly stubborn organic stains can be removed eectively by
soaking the sink in a biological washing-powder solution, dishwasher
powder solution or diluted bleach.
• Do not leave rusty objects in contact with the sink. Rust can cause
staining, cracking or even permanent damage to the sink surface.
• To avoid staining of the surface do not leave food or other materials
with corrosive properties such as juices, salt, vinegar, mustard etc. on
the sink for a long time.
• After using the sink, rinse it clean with warm soapy water and rinse
with clean water before wiping dry.
• During installation, protect from scratches, scus and other damage.
• Do not overtighten or strain plumbing fittings.
• The moulding and edges of the sink must be absolutely level so
water flows o the drainer.
4
Installation
Before Installation
Oer up the sink to the worktop and/or the cabinets to confirm that
the external dimensions of the bowl are compatible with the cabinets
themselves.
Confirm that with the sink in position:
• There is adequate space to install any taps or other required
accessories.
• There is adequate space to install the waste pipework and that any
necessary modification to internal shelves to accommodate the waste
(and trap) is acceptable.
• Access to any water stop-cock or other services will still be adequate
after the installation.
Cutting the tap hole
Only cut the tap hole from the underside of the sink.
• Select the tap hole position based on whether left hand or right hand
drainer is required.
• Locate the centre of the required tap hole and cut it out using a
suitable 35mm diameter hole cutter (available from most plumbers
merchants or DIY stores).
• Caution: Ensure that the sink is safely supported around the hole
to be cut out.
5
24
1
3
Fig. 1
1: Seal
2: Sink
3: Worktop
4: Fitting bracket supplied (suitable
for 30mm or 40mm worktop)
Installation
• Place the sink upside-down on the worktop where it will be mounted.
• Draw the perimeter of the sink on the worktop with a pencil.
• Remove the sink and draw a dotted line, 1cm inside the perimeter.
• Double check the marking out and positioning before starting to cut
the worktop.
• Make the cutout with suitable tools along the dotted line.
• After cutting out the worktop aperture, we recommend you seal the
cut edges with silicone (or similar) sealant to help prevent ingress of
water.
• It is often easier to mount the taps, waste-fitting and overflow onto the
sink prior to fitting the sink to the worktop (see next page for assembly
of supplied waste system).
• Position the sink on the worktop, bedding it onto the supplied seal
strip (Fig. 1).
• The taps, waste-fitting and overflow can now be mounted onto
the sink (if not already done)
and fully connected to their
respective services.
• Assemble the supplied waste
and overflow fittings as shown
(Fig. 2) and insert into the sink
from above (Fig. 3). NOTE: do
not use silicone sealant.
6
• To check the waste for leaks, close the plug/basket of the waste
fitting, open the tap and fill the sink to the level of the overflow; turn
o the tap and wait several minutes to verify that the water doesn’t
drain away.
• Empty the sink.
If a washing machine or dishwasher is going to be installed beneath
the sink top:
• Before installing the washing machine or dishwasher, make sure
that all of the fastening brackets for the sink top have been fastened
securely.
• To prevent overheating, which may result in the deformation and
consequent detachment of the sink from the top, adjust the feet on
the washing machine/dishwasher so that there is sucient ventilation
between the top of the appliance and the sink. To aid the circulation
and cooling of the air, it is recommended that ventilation slots be made
in the cabinet base.
) asket
: ^ cre
: trainer
: eal
+ rain
+ rain pipe
6] Å ^ er o pipe
: eal
: ^ cre
Fig. 2 Fig. 3
7
E & O E. All instructions, dimensions and illustrations are provided for guidance only. CDA reserve the
right to change specifications without prior notice.
The Guarantee is Valid Providing That
• The product has been installed by a suitably qualified person.
• Installation has been carried out in accordance with instructions and
current legislation.
• Proof of purchase can be produced.
• The product has been used for domestic purposes only.
• The product has not been tampered with or repair attempted or
modified by any unauthorised person.
• All products have been installed in accordance with WRAS regulations
and local water bye-laws
The Guarantee Does Not Cover
• Damage by misuse, neglect or transit.
• Use of parts not used or recommended by CDA.
• Routine maintenance, general wear & tear and installation faults.
• Products used for commercial or professional purposes.
Your sink is guaranteed against defects in materials and/or workmanship
for 5 years. At the discretion of CDA, should a fault arise the sink may be
repaired or replaced and agreed refitting may be reimbursed on receipt
on a faulty sink/part, once they have been inspected and deemed faulty.
www.cda.eu
Please contact our for Service on the details belowCustomer Care Department
Customer Care Department
The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : customer.care@cda.eu
Specyfikacje produktu
| Marka: | CDA |
| Kategoria: | umywalka |
| Model: | AS1CM |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z CDA AS1CM, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje umywalka CDA
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
12 Września 2024
Instrukcje umywalka
- umywalka Ikea
- umywalka Smeg
- umywalka CATA
- umywalka Coyote
- umywalka Bartscher
- umywalka Franke
- umywalka Allibert
- umywalka Kernau
- umywalka ZLine
- umywalka Miomare
- umywalka BLANCO
- umywalka Rangemaster
- umywalka Gustavsberg
- umywalka Elkay
- umywalka ARC
- umywalka Differnz
- umywalka Enza
- umywalka Lynx
- umywalka Alfi
- umywalka Dxv
- umywalka Vigo
- umywalka Signature Hardware
- umywalka Duravit
- umywalka ProFlo
- umywalka Rohl
- umywalka Thompson Traders
- umywalka Whitehaus
Najnowsze instrukcje dla umywalka
25 Lutego 2025
31 Stycznia 2025
15 Stycznia 2025
3 Stycznia 2025
3 Stycznia 2025
3 Stycznia 2025
2 Stycznia 2025
2 Stycznia 2025
2 Stycznia 2025
2 Stycznia 2025