Instrukcja obsługi Caliber MCD 260M

Caliber Radia samochodowe MCD 260M

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Caliber MCD 260M (42 stron) w kategorii Radia samochodowe. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/42
E N G L I S H
1
S P E C I F I C A T I O N S
GENERAL
Power Supply DC 12V
Polarity Negative Ground
Speaker impedance 4-8 ohms
Power Output 4 x 55W
CD PLAYER
System Compact disc audio system
Usable disc Compact disc
Sampling frequency 44.1KHz
No of quantization bits 16bit
Frequency 20-20,000Hz
Number of channels 2 stereo
S/N Ratio >60dB
RADIO SECTION
FM
Frequency Range 87.5-108 Mhz
Usable Sensitivity Better than 12dB at S/N 30 dB
Stereo Separation 30 dB at 1KHz
S/N Ratio 45 dB
MW
Frequency Range 522-1620 Khz
Intermediate Frequency 450KHz
Usable Sensitivity Better than 38dB at S/N 20 dB
S/N Ratio 35 dB
REMARK :
Specifications subject to change without notice.
MCD 260M 4x 70W
4 65 87 9
3
2
1
10
11
12
1314
16
151718192021
1. VOLUME DOWN BUTTON
2. SEL BUTTON (Volume/Bass/Treble/Balance/Fader)
3. VOLUME UP BUTTON
4. PANEL RELEASE BUTTON
5. MUTE BUTTON
6.AMS (MP3) BUTTON
7.AF BUTTON
8.TA BUTTON
9. POWER BUTTON
10.TUNE/SEEK/TRACK FORWARD BUTTON
11. PTY BUTTON
12.TUNE/SEEK/TRACK REVERSE BUTTON
13. BAND/ID3 BUTTON
14/15/17/18/19/20. PRESET STATIONS BUTTONS (M1~M6)
16. DISPLAY BUTTON
17. RANDOM BUTTON
18. REPEAT BUTTON
19. INT BUTTON
20. PAUSE BUTTON
21. MODE BUTTON
22. RESET BUTTON
23. DISC EJECT
E N G L I S H
2
D I S C P L A Y
P R E C A U TI O N S
• Use only in a 12-volt DC negative-ground electrical system.
• Disconnect the vehicle's negative battery terminal while mounting and connecting the
unit.
• When replacing the fuse, be sure to use one with an identical amperage rating.
• Using a fuse with a higher amperage rating may cause serious damage to the unit.
• DO NOT attempt to disassemble the unit. Laser beams from the optical pickup are dan-
gerous to the eyes.
• Make sure that pins or other objects do not get inside the unit; they may cause mal-
functions, or create safety hazards such as electrical shock or laser beam exposure.
• If you have parked the car for a long time in hot or cold weather, wait until the tem-
perature in the car become normal before operating the unit.
• Keep the volume at a level at which you can hear outside warning sounds (horns
sirens, etc.).
CD NOT E S
• Playing a defective or dusty CD can cause dropouts in sound.
• Hold CDs as illustrated.
• DO NOT touch the unlabeled side.
• DO NOT attach any seal, label or data protection sheet to either side of a disc.
• DO NOT expose a CD to direct sunlight or excessive heat.
• Wipe a dirty CD from the center outward with a cleaning cloth.
• Never use solvents such as benzine or alcohol.
• This unit cannot play 3-inch ( 8cm ) CDs.
• NEVER insert a 3-inch CD contained in the adapter
or an irregularly shaped CD.
• The unit may not be able to eject it, resulting in a
malfunction.
B E FOR E O PE RATION
• DO NOT raise the volume level too much, as this
will block outside sounds, making driving dangerous.
• Stop the car before performing any complicated
operation.
C A U T I O N
DO NOT open covers and do not repair by yourself.
Consult the dealer or an experienced technician for help.
Installation procedures
First complete the electrical connections, and then
check them for correctness.
Anti-Theft System
This unit is equipped with a detachable panel.
Removing this panel makes the radio totally inoperable.
Removing the panel
1. Switch off the power of the unit.
2. Remove the detachable panel.
3. Gently press the button of the case and open the
cover. Place the panel into the case and take it with you
when you leave the car.
Install detachable panel
1.Fix right part of face plate in the right part of panel slot
of the unit.
2.Press down the left side of the face plate until it clicks
into the panel slot of the unit.
Remove the unit
Switch of the power of the unit.
1. Remove the panel and the trim plate.
2. Insert both T-Keys into hole in front of the set until
they lock.
3. Pull out the unit.
1. Insert mounting bracket into the
dashboard, and bend the mounting
tabs out with a screwdriver. (Make
sure that lock lever is flush with
the mounting bracket. Not projec-
ting outward)
2. Secure the rear of the unit After
fixing mounting bolt and power
connector, fix the rear of the unit
to the car body by rubber cushion.
3. Insert trimplate

Specyfikacje produktu

Marka: Caliber
Kategoria: Radia samochodowe
Model: MCD 260M

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Caliber MCD 260M, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Radia samochodowe Caliber

Caliber

Caliber MCD786 Instrukcja

13 Stycznia 2025
Caliber

Caliber MCD 085 Instrukcja

12 Stycznia 2025
Caliber

Caliber RCD110B Instrukcja

13 Października 2024
Caliber

Caliber CA 160 V2 Instrukcja

12 Października 2024
Caliber

Caliber RMD213 Instrukcja

12 Października 2024
Caliber

Caliber RCD266BT Instrukcja

10 Października 2024
Caliber

Caliber RCD120BT Instrukcja

7 Października 2024
Caliber

Caliber MCD 265 Instrukcja

6 Października 2024
Caliber

Caliber CA 130 Instrukcja

3 Października 2024
Caliber

Caliber RCD120 Instrukcja

27 Września 2024

Instrukcje Radia samochodowe

Najnowsze instrukcje dla Radia samochodowe

Grundig

Grundig scc 1300 vd Instrukcja

15 Stycznia 2025
Autovision

Autovision AV-9740 Instrukcja

14 Stycznia 2025
Dual

Dual XDMA6355 Instrukcja

14 Stycznia 2025
Hyundai

Hyundai H-CDM8028 Instrukcja

14 Stycznia 2025
BLOW

BLOW AVH-9810 Instrukcja

13 Stycznia 2025
Roadstar

Roadstar CD-910RDVD Instrukcja

13 Stycznia 2025
Hyundai

Hyundai H-CCR8085 Instrukcja

13 Stycznia 2025
Autovision

Autovision AV-9200TBT Instrukcja

13 Stycznia 2025
Alpine

Alpine TDM-9501RM Instrukcja

12 Stycznia 2025
Alpine

Alpine TDM-7574R Instrukcja

12 Stycznia 2025