Instrukcja obsługi Burley Solo 2004-2006

Burley Różnorodny Solo 2004-2006

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Burley Solo 2004-2006 (24 stron) w kategorii Różnorodny. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/24
SOLO
Owner’s Instruction
& Safety Manual
Contents
Section Page
I. Hardware Bag Contents and Tool List
II. Mounting the Refl ectors
III. Attaching the Wheels
IV. Unfolding and Folding Your Burley Solo
V. Using the Seat Harness
VI. Padded Seat and Shoulder Harness,
Reclining Seat, and Helmet Pocket
VII. Hitching the Burley Solo to Your Bicycle
VIII. Trailer Maintenance and Care
IX. Safety Guidelines
X. Safety Checklists
XI. Parts List and Drawing
Warranty
3
3
4
5
9
11
12
14
15
21
22
24
2
Burley Solo Owner’s Instruction and Safety Manual
Congratulations!
You’ve just pur chased a Burley® trailer, the lead ing choice of dis crim i nat ing bi cy cle
trailer own ers world wide. Every ef fort has been made to ensure your pur chase is of
top quality and proven design, ready to provide you with many years and thou sands
of miles of happy, safe trailering.
IMPORTANT: Because some of the features and guidelines for
using the Burley Solo™ merit close attention, it is very im por tant
that you fa mil iar ize yourself with the trailer by reading this
manual all the way through before use. If you have any ques-
tions, we encourage you to contact your Burley dealer.
Introduction
This manual is written sequentially to assist initial assembly. Your Burley Solo is
shipped 95% factory-as sem bled. You need only to mount the refl ectors, install the
tongue, attach the wheels, side panels, roll bar and safety fl ag, and snap the cover
into place. Once you’ve read the safety guidelines, youre ready to go. Initial as sem bly
should take 10-15 minutes. Sub se quent setting up and folding can eas i ly be done in
a couple of minutes, no tools re quired.
Before trailering, be sure you have a thor ough understanding of the safety harness
and of trailer hitch operation. Practice folding and un fold ing your trailer; it can easily
be done in less than a minute, no tools required. Check to see that the trailer wheels
and hitch are securely at tached. We again request that you read this manual from
start to fi nish before use, referring to it as necessary in the future.
NOTE: Any reference to left or right is made in the direction of
travel, as if you were sitting in the child seat looking forward.
When Loaning or Selling Your Trailer
If you loan or sell your Burley Solo, supply the new user with this manual. They must
familiarize them selves with all sec tions—especially sections “IX. Safety Guidelines”
and “X. Safety Check lists” prior to use. It is es sen tial that they understand the differ-
ences between riding a bicycle with a trailer and without one. It is also essential that
they understand correct wheel at tach ment, setup, folding, and use of the har ness,
safety fl ag, cover, and hitch. Always ensure that both adult and child are wear ing
helmets. Never loan your trailer if it is in need of maintenance or repair.
3
Burley Solo Owner’s Instruction and Safety Manual
I. Hardware Bag Contents and Tool List
IMPORTANT: Please verify that you have received all of the
con tents listed. Do not pro ceed with as sem bly if any parts are
missing; contact Bur ley im me di ate ly for replacement parts.
Hardware Bag Contents
Wheel refl ectors:
(2) large red rear refl ectors
(2) Self-tapping hex head refl ector screws
(2) 1” plastic refl ector brackets
Brake:
(1) brake with mounting clamps, bolt, nut, and instruction sheet.
Envelope:
Burley Checklist
Warranty Card
Burley Solo Owner’s Instruction & Safety Manual
II. Mounting the Refl ectors
The red refl ectors install onto the rear of the main frame tube of the trailer on the
right and left sides. The main frame tubes run along either side of the trailer bottom
frame.
1. The bracket (A) mounts as shown on the
section of the main frame tube that extends
behind the trailer (B). Tighten the clamp onto
the tube so that the two holes used to mount
the refl ector are horizontal.
2. Screw the refl ector (C) onto the bracket as
shown.
3. The lower screw on the refl ector bracket
is used to adjust the angle of the refl ector.
Adjust the angle of the refl ector to ensure
that the back face is oriented vertically to the
ground, so that the refl ector points directly
back when the trailer is attached to the bike.
4. Repeat 1-3 for the other side of the trailer.
A
B
C
Tools Required
Phillips screwdriver
9/16" socket and torque wrench
Flat blade screwdriver


Specyfikacje produktu

Marka: Burley
Kategoria: Różnorodny
Model: Solo 2004-2006

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Burley Solo 2004-2006, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Różnorodny Burley

Instrukcje Różnorodny

Najnowsze instrukcje dla Różnorodny

Walkera

Walkera Goggle 3 Instrukcja

15 Października 2024
Walkera

Walkera Goggle 4 Instrukcja

15 Października 2024
Somfy

Somfy Telis Lounge Instrukcja

5 Października 2024
Navman

Navman NavBus Instrukcja

5 Października 2024
Trelock

Trelock LS 320 Instrukcja

5 Października 2024
DJI

DJI Phantom 3 Standard Instrukcja

5 Października 2024
Bobike

Bobike Maxi City Instrukcja

5 Października 2024
Tanita

Tanita 1210N Instrukcja

5 Października 2024
Kerbl

Kerbl 81685 Cat flap Instrukcja

5 Października 2024