Instrukcja obsługi Bosch VTC-206

Bosch Kamera monitorująca VTC-206

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bosch VTC-206 (2 stron) w kategorii Kamera monitorująca. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/2
Technical S pecifications
Dimensions
23(0.91)
78.8(3.10)
75.8(2.98)
Installation
V TC-206 S eries - Operation Manual
12 VDC
BNC Female
12 VDC Power Supply Class2
Video IN(75 Ohm)
MONITOR
Not supplied
CONNECTION
MOUNTING POSITION
mm(in)
50(1.97)
Ф40(1.57)
28.6(1.13)
24.8(0.98)
1/4"-20 UNC
3-Ф3.2(0.13)
Video
CCD Camera 1/3-inch Super HAD CCD II
Effective pixels (HxV) 976 x 582 (PAL) / 976 x 494 (NTSC)
Color Resolution 600 TVL (min.)
Electronics shutter 1/50 to 1/120,000 s (PAL) 1/60 to 1/120,000 s (NTSC)
Output Signal 1 VPP composite video, 75 ohm
Output connection BNC connector
S/N Ratio Greater than 50 dB
Gamma 0.45
Minimum Illumination 0.1 lx at F2.0 / 30IRE
Lens 3.6 mm  xed
Mechanical
Housing Compact, water resistant
Construction Robust aluminum
Weight 68 g (2.4 oz) approximately
Electrical
Power 12 VDC, 83 mA max.
Power Supply Not included
Environmental
Operational Temp. -10 °C to +50 °C (+14 °F to +122 °F)
Storage Temp. -20 °C to +60 °C (-4 °F to +140 °F)
Environment IP67 certi ed
Never face the camera towards bright (sun)light
In wet or moist applications, seal
camera connections to ensure
protection against water ingress
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at
his own expense.”
WA RNING
This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be
required to take adequate measures.
Ca ut ion
Any changes or modications in construction of this device which are not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
These servicing instructions are for use by qualied service personnel only. To reduce the risk of electric shock do not perform
any servicing other than that contained in the operating instructions unless you are qualied to do so.
In USA and Canada, Use Class 2 Power Supply Only.
Caution
Important safety instructio ns
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Clean only with dry cloth.
6) Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
7) Do not install near any heat sources such as radiators, heat
registers,stoves, or other apparatus (including ampliers) that produce heat.
8) Do not defeat the safety purpose of the polarized or
grounding- type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and
a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not t into
your outlet, consult an electrician for replacement of the obsolete outlet.
9) Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
10) Only use attachments/accessories specied by the manufacturer.
11) Use only with the cart, stand, tripod, bracket, or table specied by
the manufacturer, or sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus combination to avoid injury from tip-over.
12) Unplug this apparatus during lightning storms or when unused for
long periods of time.
13) Refer all servicing to qualied service personnel. Servicing is
required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's
enclosure that may be of sufcient mangnitude to constitute a risk of electric shock to persons.
This symbol is intended to alert the user to the presence of important operating and maintenance(servicing)
instruction in the literature accompanying the appliance.
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems)
This marking shown on the product or its literature, indicate that it should not be disposed with other household wastes at
the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material
resources.
This product should not be mixed with other commercial wastes purchased this product, or their local government ofce, for
details of where and how they can take item for environmentally safe recycling. Business users should contact their supplier
and check the terms and conditions of the purchase contract. Household users should contact either the retailer where they
for disposal.
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER(OR BACK). NO USABLE PARTS ARE
INSIDE. LEAVE SERVICING TO QUALIFED SERVICE PERSONNEL.
CAUTIO N
1. A regulated DC12V 300mA power supply is recommended for use with this camera for the best picture and the most stable
operation.
An unregulated power supply can cause damage to the camera. When unregulated power supply is applied, product warranty
will be void.
2. The camera signal must be terminated with 75 Ohm. If your monitor is switched to high impedance then please adjust
accordingly.
3. Do not attempt to disassemble the camera to gain access to the internal components. Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reective light, which may cause smear on the picture and possible
damage to the CCD.
5. Do not remove the product label with serial number, removing the label will void the product warranty.

Specyfikacje produktu

Marka: Bosch
Kategoria: Kamera monitorująca
Model: VTC-206

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Bosch VTC-206, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Kamera monitorująca Bosch

Bosch

Bosch VDC‑445V04‑10 Instrukcja

7 Października 2024
Bosch

Bosch 7000i Instrukcja

7 Października 2024
Bosch

Bosch FLEXIDOME IP indoor 4000 IR Instrukcja

4 Października 2024
Bosch

Bosch VDI-240 Instrukcja

30 Września 2024
Bosch

Bosch BRS-TOW-4100A Instrukcja

29 Września 2024
Bosch

Bosch BRS-RAC2-8100A Instrukcja

29 Września 2024
Bosch

Bosch DIVAR IP 5000 Instrukcja

29 Września 2024
Bosch

Bosch Smart Home Eyes Instrukcja

26 Września 2024
Bosch

Bosch AutoDome Easy II Instrukcja

25 Września 2024
Bosch

Bosch AUTODOME 4000 Instrukcja

25 Września 2024

Instrukcje Kamera monitorująca

Najnowsze instrukcje dla Kamera monitorująca

Trebs

Trebs CCD-401C Instrukcja

15 Października 2024
Hikvision

Hikvision DS-2CE56D5T-AIRZ Instrukcja

15 Października 2024
D-Link

D-Link DCS-7510 Instrukcja

15 Października 2024
Ubiquiti Networks

Ubiquiti Networks UniFi Video UVC-G3-AF Instrukcja

14 Października 2024
Hikvision

Hikvision DS-2TD2137-7/VP Instrukcja

13 Października 2024
Alecto

Alecto DVC-215IP Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2DE7A245IX-AE/S1 Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2TD2166-15/V1 Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2CD2325FWD-I Instrukcja

13 Października 2024
Hikvision

Hikvision DS-2CD2323G2-IU Instrukcja

12 Października 2024