Instrukcja obsługi Black & Decker BDHF200

Black & Decker Podgrzewacz BDHF200

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Black & Decker BDHF200 (13 stron) w kategorii Podgrzewacz. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/13
PLEASE READ AND SAVE THIS USE AND CARE BOOK.
POR FAVOR LEA ESTE INSTRUCTIVO ANTES DE USAR EL PRODUCTO.
VEUILLEZ LIRE ET CONSERVER CE GUIDE D’ENTRETIEN ET D’UTILISATION.
Chill Buster™
Heater Fan
Ventilador del calentador
Radiateur-ventilateur
Séries/Serie 100HF, 301HF, BDHF200 Series
USA/Canada 1-800-231-9786
Mexico 01-800-714-2503
www.blackanddecker.com
Accessories/Parts (USA/Canada) 1-800-738-0245
Accesorios/Partes (EE.UU/Canadá)
Accessoires/Pièces (É.-U./Canada)
PO WER
CAUTION
BDHF200Pub1000002295 5/13/05 10:41 AM Page 1
2
1
WARNING: To reduce the risk of fire:
❑
Keep combustible materials, such as furniture, pillows, bedding, papers,
clothes and curtains at least 3 feet (0.9m) from the front, sides and rear
of heater when the heater is plugged in.
❑
Do not place heater near a bed, because objects such as pillows or
blankets can fall off the bed and be ignited by heater.
❑
Always unplug from electrical outlet whenever heater is not in use.
❑
Avoid the use of an extension cord because it may overheat and cause a
risk of fire. However, if an extension cord must be used, it shall be of a
minimum size of 14 AWG and rated not less than 1875 watts.
When using any electrical appliance, basic precautions should always be
followed to reduce the risk of fire, electrical shock, and injury to persons
including the following:
❑
Read all instructions before using heater.
❑
Heater is hot when in use. To avoid burns, do not let bare skin touch
hot surface. Unplug and let heater cool down for at least ten (10)
minutes before moving it. Use handles provided.
❑
Extreme caution is necessary when any heater is used by or near
children or invalids, and whenever heater is left operating and
unattended.
❑
Do not operate any heater with a damaged cord or plug or after it
malfunctions or is dropped or damaged in any manner. Return heater to
the nearest authorized service facility for examination, repair, or
electrical or mechanical adjustment. Or call appropriate toll-free
number listed on the cover of this manual.
❑
Do not use outdoors.
❑
Heater is not intended for use in wet or moist locations such as
bathrooms, laundry areas or similar indoor locations. Never locate
heater where it may fall into a bathtub or other water container.
❑
Do not run cord under carpeting. Do not cover cord with throw rugs,
runners, or similar coverings. Arrange cord away from traffic areas, and
where it will not be tripped over.
❑
To disconnect heater, press OFF button, then remove plug from outlet by
pulling the plug, not the cord.
❑
Do not insert or allow foreign objects to enter any ventilation or exhaust
opening, as this may cause an electric shock or fire, or damage the
heater.
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS.
❑
A heater has hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint or flammable liquids are used or stored.
❑
Use heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock or
injury to persons.
❑
Avoid using heater when sleeping.
❑
To prevent a possible fire, do not block air intakes or exhaust in any
manner. Do not use on soft surface, like bed, where openings may
become blocked.
POLARIZED PLUG
This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug will fit into a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to modify the plug in any way.
TAMPER-RESISTANT SCREW
This unit is equipped with tamper-resistant screws. To reduce the risk of shock, do not
attempt to remove the front or back housing. There are no user serviceable parts
inside. Repair should be done only by authorized service personnel.
SOFT-TOUCH PARTS
Note: The soft-touch parts of the appliance are free of natural rubber and latex.
They are safe for individuals allergic or sensitive to these materials.
SPECIAL ATTENTION:
The use of an extension cord is not recommended. However, if it is absolutely
necessary, be sure that the cord is (1) No. 14 AWG minimum size and rated no
less than 1875 watts; (2) UL Listed; (3) as short as possible (long cords can
overheat, as well as trip circuit breakers); (4) not used for operating more than one
appliance at a time.
Note: If the power supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in order
to avoid a hazard.
BDHF200Pub1000002295 5/13/05 10:41 AM Page 2
How to Use
This appliance is intended for household use only.
Important: For warranty verification, do not remove line cord sticker.
The Advanced Safety Technology™ (AST) system features unique technology built
into your heater that offers protection detailed in the "Special Features" section.
Important:
During the first few minutes of initial use, you may notice a slight odor. This is
normal and will quickly disappear. This heater is intended for use on a flat, stable
surface, such as a floor, tabletop, shelf, or desk in a location where the airflow
grille openings won’t be obstructed. Do not use in wet or moist locations, like
bathrooms or laundry areas, or in areas where paint or other flammable or
volatile liquids are used or stored.
Caution: Be sure no other appliances are plugged into same circuit with
heater/fan. A circuit overload could occur.
1. Be sure dial is in OFF position before plugging in unit. Plug
into an AC outlet. For 100HF, 101HF models, choose HIGH
for large rooms and LOW for smaller rooms. For 200HF,
201HF, 300HF, 301HF and BDHF200 models with Room
Select™ Control, turn room select dial to the appropriate
setting for a small (approx. 10'x10'/3m x3m), medium (approx. 12'x12'/3.8m x
3.8m) or large room (approx. 12'x 16'/3.8m x5m) (A).
2. Turn thermostat control to HOT to activate heater/fan. Once desired room
temperature is achieved, turn thermostat control toward FROST WATCH until
fan cycles off. The heat will now cycle on/off to maintain a comfortable level.
3. To use as a fan without heat, move dial to FAN ONLY and thermostat control
toward HOT until fan begins to operate. No heating will occur in this mode.
4. The POWER indicator light shows heater is switched on and operating. It
continues to glow even if the thermostat has cycled and the heating elements
are off. Even though this unit has a cool-touch housing, both the front and back
grilles will get hot. Be careful not to touch them.
5. Frost watch: When heater is plugged in and POWER indicator light is on, you
can select any setting for room size (depending on your model) and leave
thermostat control on the lowest setting. Your heater/fan will remain off unless
temperature drops below (40° F/4°C). If this happens, FROST WATCH will
automatically cycle heater/fan on.
6. For 300HF, 301HF models with oscillating feature, slide the
lever on base of unit to OSCILLATION ON (B).
7. For 200HF, 201HF and BDHF200 models with a built-in
digital thermometer, check thermometer to see area
temperature. Depending on model, it will be displayed in
either °F or °C (C). Digital thermometer runs on batteries and
is not affected by whether or not the unit is plugged in. The
batteries are already installed. To activate thermometer, turn
unit over and pull plastic tab out of battery cover on under
side of unit. To change batteries, unscrew battery cover on
underside of unit and pull on the ribbons to pop old batteries
4
3
Product may vary slightly from what is illustrated.
1. Room Select™ Control (200HF, 201HF, 300HF, 301HF and BDHF200 models)
2. CAUTION indicator light
3. Power indicator light
4. Thermostat control
5. Soft-grip handle
6. Battery (under unit) (200HF, 201HF and BDHF200 models)
7. Stable feet
8. Oscillate lever (300HF, 301HF models)
9. Tip-over switch (under unit)
10. Front/back grilles
11. Fan only setting
12. High/low lever (100HF, 101HF models)
13. Digital thermometer (200HF, 201HF and BDHF200 models)
POWER
CAUTION
AREA TEMPERATURE
A
B
C
BDHF200Pub1000002295 5/13/05 10:41 AM Page 4

Specyfikacje produktu

Marka: Black & Decker
Kategoria: Podgrzewacz
Model: BDHF200

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Black & Decker BDHF200, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Podgrzewacz Black & Decker

Black & Decker

Black & Decker BXMRA1500E Instrukcja

27 Września 2024
Black & Decker

Black & Decker BDHF501 Instrukcja

21 Września 2024
Black & Decker

Black & Decker OR013FD Instrukcja

16 Września 2024
Black & Decker

Black & Decker BDSF1600 Instrukcja

9 Września 2024
Black & Decker

Black & Decker BDTH600 Instrukcja

6 Września 2024
Black & Decker

Black & Decker OR09C Instrukcja

6 Września 2024
Black & Decker

Black & Decker BDHF551 Instrukcja

5 Września 2024
Black & Decker

Black & Decker BDC24L Instrukcja

2 Września 2024
Black & Decker

Black & Decker 100CH-MEX Instrukcja

2 Września 2024
Black & Decker

Black & Decker BXSH2000E Instrukcja

1 Września 2024

Instrukcje Podgrzewacz

Najnowsze instrukcje dla Podgrzewacz

Trotec

Trotec TDS 75 R Instrukcja

14 Stycznia 2025
Thomson

Thomson THSF022 Instrukcja

14 Stycznia 2025
Breville

Breville the Smart Tilt Control Max LCE308 Instrukcja

14 Stycznia 2025
Breville

Breville BodyZone BZB437 Instrukcja

14 Stycznia 2025
Duux

Duux Edge Oil Instrukcja

14 Stycznia 2025
SVAN

SVAN SVCA2000RP Instrukcja

13 Stycznia 2025
Dimplex

Dimplex DX 521 Instrukcja

13 Stycznia 2025
Bestron

Bestron AFH211G Instrukcja

13 Stycznia 2025
Vonroc

Vonroc PH503AC Instrukcja

11 Stycznia 2025
JANDY

JANDY VersaFlo Instrukcja

11 Stycznia 2025