Instrukcja obsługi Bertazzoni CB36600XLP

Bertazzoni piekarnik CB36600XLP

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bertazzoni CB36600XLP (12 stron) w kategorii piekarnik. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/12
Installation, Service and User Instructions
Built-in gas cooktops
BERTAZZONI
DIMENSIONS: 36’’ (915 mm)(W) x 253/16’’ (640 mm)(D)
Models CB36500X [C3W0..U7X (2 or 5)A]
Models CB36600X [C3Y0..U7X(2 or 5)A]
IMPORTANT - PLEASE READ AND FOLLOW
-Before beginning installation, please read these instructions completely and carefully.
-Do not remove permanently affixed labels, wa may void the warranty. -Please observe alrnings, or plates from the product. This l local
and national codes and ordinances.
-Please ensure that this product is properly grounded.
-The installer should leave these instructions with the consumer who should retain for local inspector's use and for
future reference.
-The electrical plug should always be accessible.
Installation must conform with local codes or in the absence of codes, the National Fuel Gas Code ANSIZ223.1-latest edition. Electrical
installation must be in accordance with the National Electrical Code, ANIS/NFPA70
- latest edition and/or local codes. IN CANADA:
Installation must be in accordance with the current CAN/CGA-B149.1 National Gas Installation Code or CAN/CGA-B
149.2, Propane
Installation Code and/or local codes. Electrical installation must be in accordance with the current CSA C22.1 Canadian Electrical
Codes Part 1 and/or local codes.
Installation of any gas-fired equipment should be made by a licensed plumber. A manual gas shut-off valve must be installed in the gas
supply line ahead of the ov
In Massachusetts: All g "T" handle type manual
gas valve must be installed
IMPORTANT: R’S USE.
READ AND SA EFERENCE.
OBSERVE ALL
WARNING: If wed exactly, a
fire or explosi ersonal injury
or death.
Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
- Do not light any appliance.
- Do not touch any electrical switch.
- Do not use any phone in your building.
- Immediately call your gas supplier from a neighbor’s phone. Follow
the gas supplier’s instructions.
- If you cannot reach your gas suppliers, call the fire department.
Installation and service must be performed by a qualified installer,
service agency or the gas supplier.
310496
2
WARNING
Read this instruction booklet before installing and using the appliance.
The manufacturer will not be responsible for any damage to property or to persons caused by incorrect
installation or improper use of the appliance.
The manufacturer reserves the right to make changes to its products when considered necessary and useful, without
affecting the essential safety and operating characteristics.
This appliance has been designed for non-professional, domestic use only.
Warning: do not use this appliance to heat a room.
Installation instructions
This appliance shall only be installed by an authorized person. This appliance shall be installed in accordance
with the manufacturer’s installation instructions, IMPORTANT: this appliance must be installed in accordance
with the norms & standards of the country where it will be installed.
The installation of this appliance must conform to local codes and ordinances. In the absence of local codes,
Installations must conforms to American National Standards, National Fuel Gas Code ANSI Z223.1 – latest
edition** or B149.1.
If local codes permit, rtified design, max. 5
feet (1,5 m) long, ½” y line. Do not bend or
damage the flexible c ½” female pipe thread.
The appropriate fittin ne, the flexible metal
connector and the shu
The appliance, when i , in the absence des or
of local codes, with th
The appliance and its ly piping system any
pressure testing of th
The appliance must b manual shutoff valve
during any pressure or less than ½ psi (3.5
kPa).
For use with a pressu e; it shall be properly
installed in order to be accessible when appliance is installed in its final location.
The gas appliance pressure regulator must be set for the gas with which the appliance is used.
This appliance can be used with Natural Gas and LP Gas. It is shipped from the factory adjusted for use with
Natural Gas: CONVERSION FIXED ORIFICES ARE LOCATED IN THE LITERATURE PACK SUPPLIED WITH THE
UNIT.
A gas nozzle kit for the change of type of gas are contained inside the package tigether with the gas
appliance installation kit and instruction booklet.
The maximum inlet gas supply pressure incoming to the gas appliance pressure regulator is 20’’ water column
(5 kPa) .
The minimum gas supply pressure for checking the regulator setting shall be at least 1“ w.c. (249 Pa) above the
inlet specified manifold pressure to the appliance (this operating pressure is 4” w.c. (1.00 kPa) for Natural Gas
and 11” w.c. (2.75 kPa) for LP Gas.
ATTENTION: A manual valve shall be installed in an accessible location in the gas line external to the appliance
for the purpose of turning on or shutting off gas to the appliance
WARNING: Do not use aerosol sprays in the vicinity of this appliance while it is in operation
Requirements
Room ventilation – Location and venting.
ATTENTION: An exhaust fan may be used with the appliance; in each case it shall be installed in conformity with
the national standards in force.
ATTENTION: Exhaust hood operation may affect other vented appliances; in each case it shall be installed in
conformity with the national standards in force.
3
INSTALLATION MANUAL
BACKGUARD INSTALLATION INSTRUCTION
Please follow the following installation instructions afther installing the cooktop:
1) Remove n°2 screws fixing worktop as shown in fig.1
2) Place front part of the backguard and attach it from bottom side with the two removed screws (point 2) as shown
in fig .2
3) Fix the front part of the backguard with the screws supplied with the backguard kit (fig.3)
4) Assemble back part with front part of backguard and fix them with a screw supplied with the backguard kit
(fig.4)
2
3 4
WORKTOP FRONTGUARD INSTALLATION INSTRUCTIONS
In order to increase the clearance between front edge of the worktop and the burners for your safety it is
recomended to install the worktop frontguard supplied with the appliance. For installation instructions follow
the instructions indicated in the following figures

Specyfikacje produktu

Marka: Bertazzoni
Kategoria: piekarnik
Model: CB36600XLP

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Bertazzoni CB36600XLP, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje piekarnik Bertazzoni

Bertazzoni

Bertazzoni F6011MODVPTC Instrukcja

2 Lutego 2025
Bertazzoni

Bertazzoni Professional PROF365INSGIT Instrukcja

11 Stycznia 2025
Bertazzoni

Bertazzoni PRO96L1EGIT Instrukcja

4 Stycznia 2025
Bertazzoni

Bertazzoni PRO96L1EART Instrukcja

4 Stycznia 2025
Bertazzoni

Bertazzoni PRO96L1EBIT Instrukcja

4 Stycznia 2025
Bertazzoni

Bertazzoni PRO95I1ENET Instrukcja

4 Stycznia 2025
Bertazzoni

Bertazzoni PRO95I1EROT Instrukcja

4 Stycznia 2025
Bertazzoni

Bertazzoni PRO95I1EGIT Instrukcja

4 Stycznia 2025
Bertazzoni

Bertazzoni HER126G2EAVT Instrukcja

3 Stycznia 2025
Bertazzoni

Bertazzoni HER96L2EAVT Instrukcja

31 Grudnia 2025

Instrukcje piekarnik

Najnowsze instrukcje dla piekarnik

Whirlpool

Whirlpool WOI4S8HM1SXA Instrukcja

25 Marca 2025
AEG

AEG NBU5A20SB Instrukcja

24 Marca 2025
AEG

AEG NBU5P40BCK Instrukcja

24 Marca 2025
AEG

AEG TA5PB53WAB Instrukcja

24 Marca 2025
AEG

AEG OU5AE20AK Instrukcja

24 Marca 2025
AEG

AEG TU5AB20SCK Instrukcja

24 Marca 2025
AEG

AEG TB8SB631AB Instrukcja

24 Marca 2025
AEG

AEG TU5PB40NCK Instrukcja

24 Marca 2025
AEG

AEG TU5PB40NSK Instrukcja

24 Marca 2025
AEG

AEG TR6PB531SB Instrukcja

24 Marca 2025