Instrukcja obsługi Beko CDA 543 F

Beko lodówka CDA 543 F

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Beko CDA 543 F (11 stron) w kategorii lodówka. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/11
CDA543F
BEKO plc
Beko House
Caxton Way
Watford
Hertfordshire
WD18 8UF
Tel: 01923 654650
Fax: 01923 819653
e-mail: service@beko.co.uk
website: www.beko.co.uk
Printed in Turkey
Part no: 48 2711 00 00
Revision no: 0
12
Frost Free Combi
Fridge Freezer
PERFORMANCE
Energy efficiency class
Energy consumption - Kwh/year
Net storage - vol fresh food ltrs (cu.ft.)
Total net vol - ltrs (cu.ft.)
Frozen food compartment rating
Conservation time from failure
Freezing capacity fresh food - kg (lb) / 24 hrs.
Climate class
Operating noise level dB(A)
Net storage - vol frozen food ltrs (cu.ft.)
A
157 lt. (5.5)
244 lt. (8.6)
13 h.
4 8.8( )
SN
4 STAR
87 lt. (3.1)
329
41
CDA543F
Congratulations on your choice of a quality Appliance which has been designed to give you
service for many years.
WARNING !
IMPORTANT !
DO NOT connect your appliance to the electricity supply until all packing and transit protectors have
been removed.
• Leave to stand for at least 4 hours before switching on to allow compressor oil to settle if transported
horizontally.
• If you are discarding an old refrigerator with a lock or latch fitted to the door, disable the lock/latch,
ensure that it is left in a safe condition to prevent the entrapment of young children.
• This fridge/freezer must only be used for its intended purpose i.e the storing and freezing of edible
foodstuff.
• Do not dispose of the appliance on a fire. At BEKO, the care and protection of our environment is
an ongoing commitment. This appliance which is among the latest range introduced is particularly
environment friendly. Your appliance contains non CFC / HFC natural substances in the cooling
system (Called R600a) and in the insulation (Called cyclopentane) which are potentially flammable
if exposed to fire. Therefore, take care not to damage, the cooling circuit / pipes of the appliance
in transportation and in use. In case of a damage do not expose the appliance to fire, potential
ignition source and immediately ventilate the room where the appliance is situated.
• We suggest you contact your local authority for disposal information and facilities available.
• We do not recommend use of this appliance in an unheated, cold room.
(E.g.: garage, conservatory, annex, shed, out-house etc.) See Installation Instructions on page 4 for
further information.
• To obtain the best possible performance and trouble free operation from your appliance it is very
important to carefully read these instructions.
• On delivery, check to make sure that the product is not damaged and that all the parts and accessories
are in perfect condition.
• Take care to ensure that the plug remains readily accessible. Do not use multiple adapter bar or
extension cable.
• Failure to observe these instructions may invalidate your right to free service during the guarantee
period.
WARNING- Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of
obstruction.
WARNING- Do not use mechanical devices or other means to accelerate the defrosting process, other
than those recommended by the manufacturer.
WARNING- Do not damage the refrigerant circuit.
WARNING- Do not use electrical appliances inside the food storage compartments of the appliance,
unless they are of the type recommended by the manufacturer.
• We suggest you keep these instructions in a safe
place for easy reference.
3
4
4-5
6
7-8
9
10
11
11
12
12
13
14
14
15
16
17
17
18
19
ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and the
frequency shown in the rating plate inside the appliance corresponds to your
electricity supply.
Rating label is on the left hand side of fridge inner liner.
We recommend that this appliance is connected to the mains supply via a
suitable switched and fused socket in a readily accessible position.
Should the mains lead of the appliance become damaged or should it need
replacing at any time, it must be replaced by a special purpose made mains lead
which can only be obtained from a BEKO Authorised Service Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then the plug should be
cut off and an appropriate plug fitted. Destroy the old plug which is cut off as a
plug with bared cord could cause a shock hazard if inserted into a socket
elsewhere in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse
need to be replaced an ASTA approved BS 1362 fuse of the same rating must be
used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the
plug must not be used until a replacement fuse cover has been fitted. Colour of
the replacement fuse cover must be the same colour as that visible on the pin face
of the plug. Fuse covers are available from any good electrical store.
IMPORTANT! FITTING A DIFFERENT PLUG
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals
in your plug proceed as follows:
(See diagram).
1. Connect the green-yellow or
green (Earth) wire to the terminal
in the plug marked 'E' or with
the symbol or coloured
green and yellow or green.
2. Connect the blue (Neutral) wire
to the terminal in the plug
marked 'N' or coloured black.
3. Connect the brown (Live) wire to
the terminal in the plug marked 'L'
or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or
in the main fuse box.
If in doubt contact a qualified electrician.
FITTED WITH
BS 1362 13A FUSE ALWAYS
FIT BS 1362 REPLACEMENT
CARTRIDGE FUSE
GREEN &
YELLOW
OR
GREEN
N
BLUE
OR
BLACK
L
BROWN
OR
RED
22mm.
6mm.
6mm.
6mm. 32mm.
12mm.
FUSE
CORD GRIP
TRANSPORTATION INSTRUCTIONS
1. The appliance should be transported only in a vertical upright position. The
packing as supplied must be intact during transportation.
2. If during the course of transport the appliance has to be transported
horizontally, it must only be laid on its right hand side when standing in the
front of the appliance. After bringing it to upright position,it must not be operated
for at least 4 hours to allow the system to settle.
3. Failure to comply with the above instructions could result in damage occuring
to the appliance. The manufacturer will not be held responsible if these
instructions are disregarded.
4. The appliance must be protected against rain, moisture and other
atmospheric influences.
5. When positioning your appliance take care not to damage your flooring,
pipes, wall coverings etc. Do not move the appliance by pulling by the door
or handle.
6. Empty any water in the drain tray before moving. See section ‘Defrosting’ and
‘Care & cleaning’ for further information.
7. Make sure that the defrost water pipe at the back of the product is fixed to the
plastic evaporating pan on the top of the compressor, to avoid defrost water
spillage on the floor.
IMPORTANT : Care must be taken while cleaning / carrying the appliance to
avoid touching the bottom of the condenser metal wires at the back of the
appliance as you might injure your fingers and hands.
Do not attempt to sit or stand on top of your appliance as it is not designed for
such use. You could injure yourself or damage the appliance.
"IMPORTANT: Make sure that mains cable is not caught under the appliance
during and after carrying / moving the appliance, to avoid the mains cable
becoming cut or damaged."
Do not allow children to play with the appliance or tamper with the controls.
BEKO plc declines to accept any liability should the instructions not be
followed.
IMPORTANT
INSTALLATION INSTRUCTIONS
1. The space in the room where the appliance is installed must not be smaller
than 10 cubic metres.
2. Do not put your fridge freezer in a cold room where the temperature is likely
to go below +5 degrees C (41 degrees F) during night time and/or especially
in winter.
This fridge freezer has been designed to operate in ambient temperatures
between +5 and +32 degrees C (41 and 90 degrees F) Therefore if the
appliance is installed in an unheated/cold room (eg: conservatory/annex/
shed/garage etc) then the appliance will not operate causing the freezer
compartment to run warmer and as a result the storage time of frozen food
may be reduced. 43

Specyfikacje produktu

Marka: Beko
Kategoria: lodówka
Model: CDA 543 F

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Beko CDA 543 F, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje lodówka Beko

Beko

Beko RDNE710E40SXBR Instrukcja

14 Stycznia 2025
Beko

Beko RDNE850L22X Instrukcja

14 Stycznia 2025
Beko

Beko DN170123XP Instrukcja

14 Stycznia 2025
Beko

Beko GNE753DIX Instrukcja

14 Stycznia 2025
Beko

Beko CN151120 X Instrukcja

11 Stycznia 2025
Beko

Beko BCHA306E3S Instrukcja

10 Stycznia 2025
Beko

Beko B5RDNE594ZXB Instrukcja

10 Stycznia 2025
Beko

Beko RDNE455K30ZXBN Instrukcja

10 Stycznia 2025
Beko

Beko ASL1532 Instrukcja

10 Stycznia 2025
Beko

Beko ASN652V Instrukcja

10 Stycznia 2025

Instrukcje lodówka

Najnowsze instrukcje dla lodówka

Siemens

Siemens KA 58 NP 95 Instrukcja

15 Stycznia 2025
Zanussi

Zanussi ZRB 29 NC8 Instrukcja

15 Stycznia 2025
Fisher & Paykel

Fisher & Paykel RF442BRPUX6 Instrukcja

15 Stycznia 2025
Amica

Amica FDR2213B Instrukcja

15 Stycznia 2025
Siemens

Siemens KG 33 VX 41 Instrukcja

15 Stycznia 2025
Bauknecht

Bauknecht KRIS 1509A Instrukcja

15 Stycznia 2025
Dometic

Dometic RM 7400 L Instrukcja

15 Stycznia 2025
LG

LG GR-B652YVSK Instrukcja

15 Stycznia 2025
Zanussi

Zanussi ZRB34211XV Instrukcja

15 Stycznia 2025
Hotpoint

Hotpoint HTR15ABRLCC Instrukcja

15 Stycznia 2025