Instrukcja obsługi Bauknecht WAT 9555D

Bauknecht pralka WAT 9555D

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bauknecht WAT 9555D (14 stron) w kategorii pralka. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/14

QUICK REFERENCE GUIDE GB

BEFORE USING THE APPLIANCE FOR THE FIRST TIME:

• IMPORTANT: MAKE SURE YOU HAVE READ THE INSTALLATION INSTRUCTIONS.

• IMPORTANT: REMOVE THE TRANSPORT SCREWS AND THE TRANSPORT BRACKET.

• First wash cycle without laundry:

1. Open the tap.

2. Close the drum flaps.

3. Pour a small amount of detergent (about 30 ml) into the detergent dispenser

compartment .

4. Close the lid.

5. Select a short wash programme and a low spin speed (see programme chart).

6. Press the “Start/Pause” button.

This will remove any water remaining in the machine from the manufacturer’s test run.

NORMAL DAILY USE:

1. Open the tap.

2. Sort the laundry according to fabric type and colour and load the machine.

3. Close the drum flaps.

4. Add detergent and any additives required into the dispenser.

5. Close the lid.

6. Select the programme, temperature, spin speed and special options.

7. Press the “Start/Pause” button.

Read these user instructions carefully to learn about all the functions of your washing

machine.

GB CONTENTS

INSTALLATION INSTRUCTIONS PAGE 19

WASHING MACHINE AND ACCESSORIES PAGE 22

PROTECTING THE ENVIRONMENT PAGE 23

SAFETY INSTRUCTIONS PAGE 23

TRANSPORT / HANDLING PAGE 23

PREPARING THE WASH PAGE 24

DETERGENT AND ADDITIVES PAGE 25

DYEING AND BLEACHING PAGE 25

STARCHING PAGE 25

REMOVING THE FOREIGN BODY TRAP PAGE 26

DRAINING RESIDUAL WATER PAGE 26

MAINTENANCE AND CLEANING PAGE 27

TROUBLESHOOTING GUIDE PAGE 28

AFTER-SALES SERVICE PAGE 30

HOW TO UNPACK THE APPLIANCE

1. Cut and remove the shrink-wrap.

2. Remove the top protection and the protection corners.

3. Remove the bottom protection by tilting and turning

the appliance on one rear bottom corner.

4. Open the lid while pressing it slightly down and at the

same time operate the handle. Remove the

polystyrene cushion.

5. Peel off the light blue protective film from the panel

(depending on model).

HOW TO REMOVE THE TRANSPORT

SCREWS AND THE TRANSPORT BRACKET

The appliance is fitted with the transport screws and

the transport bracket to prevent internal damage while

being moved.

Before using the appliance, the transport bracket

at the back MUST be removed.

1. Unscrew the two screws A and the four screws B

with a flat screwdriver or a N° 8 hex nut screwdriver.

2. Remove the transport bracket.

3. Replace the four outer screws B into the machine

again and tighten.

4. Tear off the two stop plugs C from the hose holder

and clip them into the openings of the machine

Note: In case of future moves, always transport the

washing machine upright.

INSTALLATION

•Install the appliance on a solid and level floor surface

close to electrical, water and drain connections.

•Make sure that all feet are stable and resting on

the floor and then check that the appliance is

perfectly level (use a spirit level).

•If the floor is uneven, adjust the levelling feet as

required (do not insert pieces of wood, cardboard

etc. under the feet).

•The appliance can be installed in a 40 cm width

and 63 cm depth space.

Note: It is important to avoid blocking the openings on the

underside of the appliance when installing on a carpet floor.

ADJUSTMENT OF THE APPLIANCE

1. To move the appliance into its operating position:

Pull the handle situated on the bottom of the front

(optional on certain models) a little bit by hand

and pull it in the final driving position by foot.

Afterwards push the handle back into the original,

stable position.

The front feet can be adjusted in order to level the

appliance.

2. Loosen the locknut using a wrench.

3. Adjust the height of the foot, turning it by hand.

4. Tighten the locknut by turning it anti-clockwise

towards the appliance casing.

IMPORTANT: Do not run the appliance while it is

standing on the trolleys.

INSTALLATION INSTRUCTIONS

Specyfikacje produktu

Marka:	Bauknecht
Kategoria:	pralka
Model:	WAT 9555D
Kolor produktu:	Black,Stainless steel
Typ produktu:	Przelewowy ekspres do kawy
Pojemność zbiornika na wodę:	1.25 l
Materiał obudowy:	Stal nierdzewna
Moc:	1000 W
Przyrządza kawę:	Tak
Wbudowany wyświetlacz:	Nie
Wyjmowany zbiornik wody:	Tak
Wbudowany młynek:	Nie
Pojemność w kubkach:	10 kub.
Położenie urządzenia:	Blat
Typ ekspresu do kawy:	Półautomatyczny
Pojemnik na mleko:	Nie
Blokada kapania zapobiega kapaniu wody na prasowane ubrania:	Tak
Lampka kontrolna:	Tak
Wskaźnik poziomu wody:	Tak
Podświetlony włącznik/wyłącznik:	Tak
Rodzaj zakrętki:	Pokrywa na zawiasach
Płytka grzejna:	Tak