Instrukcja obsługi Bauknecht TRAE 6560/1

Bauknecht Suszarka bębnowa TRAE 6560/1

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bauknecht TRAE 6560/1 (8 stron) w kategorii Suszarka bębnowa. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/8
9









 
!
! " 
#

$
%&
'& " ()%
10
!  " 
1. Removing the packaging
and check
•After unpacking, make sure
that the dryer is undamaged.
If in doubt, do not use the
dryer. Contact After-Sales
Service or your local retailer.
•Keep the packaging
materials (plastic bags,
polystyrene parts, etc.) out of
reach of children, as they are
potentially dangerous.
2. Electrical Connections
•Electrical connections must
be carried out by a qualified
technician in compliance
with the manufacturer’s
instructions and current
standard safety regulations.
•Electrical connection must
comply with local Electricity
Board regulations.
•Voltage information, power
consumption and the
required fuse protection is
shown on the rating plate
mounted at the rear of the
dryer.
•The manufacturer cannot
accept any liability for
personal injury or damage to
property resulting from
failure to adhere to these
instructions.
•The dryer must be earthed as
prescribed by law.
•Do not use extension leads or
multiple adaptors.
•Before any maintenance on
the dryer disconnect it from
the mains supply.
•Do not operate the dryer if it
has been damaged during
transport. Contact one of our
After-Sales Service
technicians.
•Mains cables must be
replaced by an original cable
and is only to be carried out
by a technician from After-
Sales Service or an authorized
electrician.
•After installation access to
the mains plug has to be
guaranteed, or the all-pole
disconnection has to be
possible with a switch.
3. Installation
•Do not install your dryer
where it can be subject to
extreme conditions, such as:
poor ventilation,
temperatures around
freezing (or above 35°C).
•Remove the protective foil
from the control panel.
Stability:
When installing the dryer
always carefully level the
dryer adjusting the two feet
and check the correct
levelling with a spirit level.
To built in the dryer
•For security reason do not
remove the worktop.
•Connect the dryer to an
external ventilation system in
order to prevent steam from
damaging your furniture
during the years.
Stacking kit
Your dryer can be stacked on
top of your front loading
washing machine.
To do this, use stacking kit
AMH 752, available at your
dealer.
Minimum housing
dimensions:
Width: 600 mm
Height: 850 mm
Depth: 560 mm
11
#
1) For Great Britain only
Warning - this appliance
must be earthed
Fuse replacement
If the mains lead of this
appliance is fitted with a
BS 1363A 13amp fused plug,
to change a fuse in this type
of plug use an A.S.T.A.
approved fuse to BS 1362
type and proceed as follows:
1. Remove the fuse cover (A)
and fuse (B).
2. Fit replacement 13A fuse into
fuse cover.
3. Ret both into plug.
Important:
The fuse cover must be
refitted when changing a
fuse and if the fuse cover is
lost the plug must not be
used until a correct
replacement is fitted.
Correct replacement are
identified by the colour
insert or the colour
embossed in words on the
base of the plug.
Replacement fuse covers are
available from your local
electrical store.
2) For the Republic of
Ireland only
The information given in
respect of Great Britain will
frequently apply, but a third
type of plug and socket is also
used, the 2-pin, side earth type.
3) Socket outlet / plug
(valid for both
countries)
If the fitted plug is not suitable
for your socket outlet, Please
contact Whirlpool Service for
further instruction. Please do
not attempt to change plug
yourself. This procedure needs
to be carried out by a qualified
Whirlpool technician in
compliance with the
manufactures instructions and
current standard safety
regulations.

Specyfikacje produktu

Marka: Bauknecht
Kategoria: Suszarka bębnowa
Model: TRAE 6560/1

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Bauknecht TRAE 6560/1, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Suszarka bębnowa Bauknecht

Bauknecht

Bauknecht TRKK STUTTGART/2 Instrukcja

8 Października 2024
Bauknecht

Bauknecht TK Prime 75A3 BW Instrukcja

26 Września 2024
Bauknecht

Bauknecht T M11 9X3SKY CH Instrukcja

23 Września 2024
Bauknecht

Bauknecht WMC 6L55 Instrukcja

21 Września 2024
Bauknecht

Bauknecht TRKB 7570 Instrukcja

17 Września 2024
Bauknecht

Bauknecht TRK 4970 Instrukcja

16 Września 2024
Bauknecht

Bauknecht T M11 8X3EY DE Instrukcja

14 Września 2024
Bauknecht

Bauknecht TSenseD8X2SK Instrukcja

14 Września 2024
Bauknecht

Bauknecht TR Style 82A3 TD KONN Instrukcja

14 Września 2024
Bauknecht

Bauknecht TN M11 8X2SK CH Instrukcja

12 Września 2024

Instrukcje Suszarka bębnowa

Najnowsze instrukcje dla Suszarka bębnowa

Asko

Asko T410HD.W.AU Instrukcja

15 Października 2024
Bosch

Bosch WTH8300CNL Instrukcja

15 Października 2024
Adler

Adler AD 2279 Instrukcja

15 Października 2024
Haier

Haier HWD90-B14959NU1 Instrukcja

15 Października 2024
Haier

Haier HWD100-B14959S8NU1 Instrukcja

15 Października 2024
Haier

Haier HWD100-B14959NU1 Instrukcja

15 Października 2024
Haier

Haier HWD80-B14959S8NU1 Instrukcja

15 Października 2024
Teka

Teka THPD80 Instrukcja

15 Października 2024
Indesit

Indesit IDV 75 B K (UK) Instrukcja

14 Października 2024
Indesit

Indesit YT M11 82 X UK Instrukcja

14 Października 2024