Instrukcja obsługi Bauknecht KSN 495/1 IO

Bauknecht lodówka KSN 495/1 IO

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bauknecht KSN 495/1 IO (6 stron) w kategorii lodówka. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/6
Clean the appliance regularly using a new cloth and a solution of lukewarm water and neutral detergent
specific for cleaning inside refrigerators. Never use abrasive detergents.
Do not use steam cleaners. Clean the condenser using a vacuum cleaner, after removing the front plinth
(see Installation manual).
The buttons and control panel display (in some models, located on the freezer door) must not be cleaned
with alcohol or alcohol-derived substances, but with a dry cloth.
Replacing the bulbs
Important:
Always disconnect the refrigerator from the power supply before
replacing any light bulbs.
Before replacing the bulb, remove the lamp cover (if present). After
the bulb has been replaced, refit the lamp cover.
Internal lights are bayonet bulbs.
The ice and water dispenser light, if present, is a normal screw bulb
although some models may have a LED light.
LED lights last longer than normal bulbs, they illuminate the inside of
the appliance better and are more environmentally friendly.
Only use bulbs of the same type which can be requested from the after-sales service and authorized
dealers.
If the appliance has a LED light, contact the after-sales service when a replacement is required.
APPLIANCE MAINTENANCE
AND CLEANING
When the appliance is connected to the power supply, the display will show the factory preset
temperatures (-18°C and +5°C).
If the acoustic signal sounds and the temperature indicator blinks, press and hold the alarm mute button.
Note: After being switched on, the appliance needs approximately 2/3 hours to reach the correct
temperature to store a typical volume of food.
As applicable, insert the anti-bacterial and anti-odour filter as indicated on the filter package.
FIRST USE
Disconnect the appliance from the power supply. Empty the appliance and leave the doors open just
enough to allow air to circulate inside the compartments. This will prevent the formation of mould and
bad odours. If your appliance has an automatic ice maker:
1. Shut off the water supply to the product.
2. Empty the ice bucket.
DURING BLACKOUTS
For power failures lasting up to 12 hours, keep the doors of the appliance closed. In this way the stored
food will stay cold as long as possible.
Should the power failure last more than 12 hours, remove all food from the product and store it in a
suitable appliance.
WHEN THE APPLIANCE IS NOT USED
See the Installation Manual for instructions on how to connect to the mains water supply.
To dispense water:
Water delivery is always available. Press a glass against the water dispenser lever. Water delivery stops
when the lever is released. On models that don't have this lever, press the "Water" button . Water
delivery stops when the lever/button is released.
To dispense ice:
To obtain ice press against the ice dispenser lever. On models that don't have this lever, press the "Ice"
button . Water delivery stops when the lever/button is released.
Useful tips:
1. Keep the glass near the water/ice dispenser outlet.
2. To start dispensing, just press lightly against the lever or press and hold the "Water" / "Ice" buttons
(in models that don't have a water/ice lever). Pressing hard will not result in faster dispensing or greater
quantities.
3. To stop dispensing, remove the glass slowly so that ice does not fall outside the glass (in models with
water/ice levers.)
4. Do not use fragile or easily breakable glasses (in models with water/ice levers).
5. The water dispensed should be consumed within 6 hours.
6. If the water/ice dispenser is only used ccasionally or has been left unused for some time with the
appliance switched on, the circuit will need to be cleaned and the first 2 litres of water drawn off and
the first ice produced thrown away. Repeat this procedure when the product is reconnected to the
power supply after prolonged disuse.
The anti-condensation devices can be disabled by pressing the switch
shown in the figure on the right (switch in position OFF). This allows
you to optimise energy consumption.
If there is condensation in the ice/water dispenser area or on the door,
reactivate the anti-condensation devices (switch in position ON).
USING THE ICE AND WATER DISPENSER
(if installed)
Failure to follow the instructions regarding sanitizing can compromise the hygienic safety of the
water dispensed.
When using the appliance for the first time and every time the filter is changed, discard the first 9-14
litres of water, equivalent to 6-7 minutes of dispensing (not necessarily consecutive, but before initial
consumption) and discard the ice produced in the first 24 hours.
If the water dispenser has not been used for more than 4/5 days, it is advisable to clean the circuit and
run off the first litre of water.
Reposition the removable water dispenser (if present), ensuring your hands are hygienically clean.
Clean the ice bucket or drawer regularly but using only drinking water.
The filter must be changed when indicated on the control panel or when the ice/water dispenser has
not been used for more than 30 days.
Every time the filter is changed, it is a good idea to always sanitise the water dispensing system with
food-grade disinfectant solutions (sodium hypochlorite based) which do not alter the characteristics of
the materials. Rinse with at least 2 litres of water before use.
Only original spare parts supplied by the manufacturer should be used when replacing components in
the ice and water dispenser.
Any work on the appliance must be carried out by a qualified technician or the After-sales Service.
CLEANING, SANITIZATION AND
MAINTENANCE OF THE ICE AND/OR
WATER DISPENSER (if present)
After switching on the refrigerator, it usually takes a full night for the first ice cubes to form. When
selecting crushed ice (on some models only - see the Quick Start Guide), the cubes are crushed just
before being dispensed, therefore the crushed ice may come out with a slight delay. Noise from the ice
crusher is normal, and pieces of ice may vary in size. When changing from crushed ice to ice cubes, a small
amount of crushed ice may come out together with the first cubes.
The quantity and size of the ice cubes depend on the mains water pressure. Ice cubes production can be
increased by decreasing the freezer compartment temperature setting.
VERSION WITH ICE TRAY
Normal ice production is 7 to 8 batches of ice cubes over a 24 hour period.
Large amounts of ice cubes should be taken directly from the bucket, and not
from the dispenser. It is recommended that the drawer is closed after completing
the operation.
VERSION WITH ICE MAKER IN THE FREEZER COMPARTMENT AND
ICE BUCKET ON THE DOOR
Normal ice production is 12 to 14 batches of ice cubes over a 24 hour period.
To remove and refit the ice bucket
Insert your fingers in the opening at the
bottom of the container, pull the lever and
lift and extract the container (see figure 1).
On some models, you need to insert your
fingers into the opening at the bottom of the
container and place your thumb on the
release button (see figure 2) to remove the
container. Hold the base of the bucket with
both hands, press the release button and lift
the bucket up and out.
To re-insert the ice bucket, place it onto its
support attached to the inner door and
lower into position.
Note: If you need a large amount of ice cubes, take them directly from the bucket and not from the
dispenser.
VERSION WITH ICE MAKER AND BUCKET ON THE FREEZER DOOR
With the door closed, normal ice production is 6 to 7 batches of ice cubes over a 24 hour period.
Ice cube production depends to a large extent on how often the door is opened, the amount of fresh food
placed in the freezer compartment, the ambient temperature and the temperature set. If the ice maker
has not been used for a long time, it will take a full night for the first ice cubes to form.
Removing and refitting the ice bucket
Insert your fingers into the opening at the bottom of the ice bucket, pull the
lever then lift and extract the bucket (see figure 3).
To re-insert the ice bucket, place it onto its support attached to the inner
door and lower into position.
Note: For large amounts of ice, enable the "Fast Freezing" function (see the
Quick Start guide). If you need a large amount of ice cubes, take them
directly from the bucket and not from the dispenser.
Important: Turn the ice maker off before removing the ice bucket to
stop ice cubes being dispensed accidentally.
Use only drinking water for the regular cleaning of the ice maker cover.
USING THE AUTOMATIC ICE MAKER
(if installed)
figure 1 figure 2
figure 3


Specyfikacje produktu

Marka: Bauknecht
Kategoria: lodówka
Model: KSN 495/1 IO

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Bauknecht KSN 495/1 IO, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje lodówka Bauknecht

Instrukcje lodówka

Najnowsze instrukcje dla lodówka

Samsung

Samsung RT32K5030EF Instrukcja

15 Października 2024
Liebherr

Liebherr CBNes 4875 Instrukcja

15 Października 2024
Frigidaire

Frigidaire FFPH44M4LM Instrukcja

15 Października 2024
AEG

AEG Santo 70318 KG1 Instrukcja

15 Października 2024
Whirlpool

Whirlpool ART 550 Instrukcja

15 Października 2024
Indesit

Indesit TLA 1 (UK) (0) Instrukcja

15 Października 2024
Hotpoint

Hotpoint HTH18GBCCC Instrukcja

15 Października 2024
Zanker

Zanker ZKK8021 Instrukcja

15 Października 2024
Hoover

Hoover HFF 618 DW Instrukcja

15 Października 2024
Frigidaire

Frigidaire FRT15HB3DQ Instrukcja

15 Października 2024