Instrukcja obsługi AXESS GMOS-12

AXESS Niesklasyfikowane GMOS-12

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla AXESS GMOS-12 (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/4

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

GMOS-12

I N S TA L L AT I O N I N S T R U C T I O N S

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS REQUIRED

• Crimping tool and connectors, or solder gun,

solder, and heat shrink

• Tape • Wire cutter • Zip ties

TABLE OF CONTENTS

Connections to be made .......................................2

Installing the GMOS-12 ...........................................3

Programming the GMOS-12 ...................................3

Adjusting the GMOS-12 ..........................................3

Troubleshooting .....................................................3

Saturn OnStar interface 2004-2005

APPLICATIONS

• Provides accessory power (12-volt 10-amp)

• Maintains the retained accessory power (R.A.P.) feature

• Retains OnStar/OE Bluetooth

• Adjustable volume for OnStar

• Designed for non-ampliﬁed models with OnStar

• Retains balance and fade

• Micro “B” USB updatable

SATURN

Ion 2004-2005

Vue 2004-2005

• GMOS-12 Interface

• GMOS-12 harness

• 16-pin harness with stripped leads

CONNECTIONS TO BE MADE

From the 16-pin harness with stripped leads:

• Connect the wire to the ignition/accessory wire.Red

• Connect the wire to the left front positive speaker wire.White

• Connect the wire to the left front negative speaker wire.White/Black

• Connect the wire to the right front positive speaker wire.Gray

• Connect the Gray/Black wire to the right front negative speaker wire.

• Connect the Brown wire to the mute wire of the aftermarket radio. If the radio has no mute

wire, tape it off and disregard it.

• Tape off and disregard the following (6) wires, they will not be used in this application:

Orange/White Blue/Pink Green Green/Black Purple Purple/Black, , , , ,

From the GMOS-12 harness to the aftermarket radio:

• Connect the Yellow wire to the 12 volt constant/battery wire.

• Connect the wire to the ground wire.Black

• Connect the wire to the illumination wire of the aftermarket radio. Orange

If no illumination wire is present, tape it off and disregard it.

• Tape off and disregard the wire, it will not be used this application.Orange/White

• Connect the wire to the left rear positive speaker wire.Green

• Connect the wire to the left rear negative speaker wire.Green/Black

• Connect the wire to the right rear positive speaker wire.Purple

• Connect the wire to the right rear negative speaker wire.Purple/Black

• The Black/Yellow wire is for OnStar volume adjustment and will be discussed later

in this manual.

REV. 7/2/2018 INSTGMOS-12

With the key in the off position:

• Connect the 16-pin harness with stripped leads, and the GMOS-12 harness, into the interface.

Attention! Do not connect the GMOS-12 harness to the wiring harness in the vehicle just yet.

For the steps below, the L.E.D. located inside the interface can only be seen while active. The

interface does not need to be opened to see the L.E.D.

1. Start the vehicle.

2. Connect the GMOS-12 harness to the wiring harness in the vehicle. The L.E.D. will initially be

Green to indicate the interface is powered.

3. After a few seconds the L.E.D. will turn on solid while the interface automatically Red

programs to the vehicle. The radio will shut off at this point. This process should take 5 to 30

seconds.

4. After the interface is programmed, the L.E.D. will turn on solid , and the radio will Green

come back on, indicating programming was successful.

5. Test all functions of the installation for proper operation, before reassembling the dash.

6. If the interface fails to function, refer to “Troubleshooting”.

Resetting the Axxess interface

1. The reset button is located inside the Axxess interface, between the two connectors. Blue

The button is accessible outside the Axxess interface, no need to open the Axxess interface.

2. Press and hold the reset button for two seconds, then let go to reset the Axxess interface.

3. Refer to “Programming the Axxess Interface” from this point.

Onstar level adjustment:

• To adjust the OnStar volume level ﬁnd the Black/Yellow wire on the 12-pin harness.

• Push the OnStar button: while the voice is speaking tap the Blue Black/Yellow wire to

ground.

• There are 4 volume settings for OnStar: once the 4th setting is reached and the Black/

Yellow wire is tapped to ground, it will automatically go back to the ﬁrst volume setting.

• Once the volume is set it will stay at that volume until the Black/Yellow wire is tapped to

ground again.

INSTALLING THE GMOS-12

PROGRAMMING THE GMOS-12

TROUBLESHOOTING

ADJUSTING THE GMOS-12

Specyfikacje produktu

Marka:	AXESS
Kategoria:	Niesklasyfikowane
Model:	GMOS-12

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z AXESS GMOS-12, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Niesklasyfikowane AXESS

AXESS AXBUCS-MZ286V Instrukcja

9 Października 2024

AXESS 99-7014HG Instrukcja

8 Października 2024

AXESS AXGM-17 Instrukcja

8 Października 2024

AXESS AXGMLN-34 Instrukcja

8 Października 2024

AXESS 99-7382HG Instrukcja

8 Października 2024

AXESS GMOS-12 Instrukcja

8 Października 2024

AXESS XSVI-1788-NAV Instrukcja

8 Października 2024

AXESS 99-7510HG Instrukcja

8 Października 2024

AXESS AXBUCS-NI246V Instrukcja

8 Października 2024

AXESS 99-3307G Instrukcja

8 Października 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024

Stihl HT 70 Instrukcja

15 Października 2024

Ernesto H14270 Instrukcja

15 Października 2024

Uniden BT MIC KIT Instrukcja

15 Października 2024

Vaude Omnis Bike 26 Instrukcja

15 Października 2024

ART ProChannel II Instrukcja

15 Października 2024

Aukey DR02J Instrukcja

15 Października 2024

Master Lock 653EURD Instrukcja

15 Października 2024

Roland FR-18 Diatonic Instrukcja

15 Października 2024